Search

The paper presents and discusses the results of a study of the thermal properties of cement composites with different contents of magnetite aggregate (0%, 20%, 40% and 60% by volume). The effect of grain size on the evaluated thermal properties was also investigated. For this purpose, concrete containing 50% by volume of magnetite aggregate with four different fractions (1–2 mm, 2–4 mm, 4–8 mm and 8–16 mm) was used. Thermal parameters were evaluated on specimens fully saturated with water and dried to a constant mass at 65 °C. The series with varying grain sizes of magnetite achieved thermal conductivity values in the range of 2.76–3.03 W/(m·K) and 2.00–2.21 W/(m·K) at full water saturation and after drying to a constant mass, respectively. In the case of the series with 20% magnetite by volume, the thermal conductivity was 2.65 W/(m·K) and 1.99 W/(m·K) for the material fully saturated with water and dried to a constant mass, respectively. The series with a 60% volume share of magnetite obtained values of this parameter of 3.47 W/(m·K) and 2.66 W/(m·K), respectively, under the same assumptions. [ABSTRACT FROM AUTHOR]

The long-term durability of concrete pavements in wet-freeze climate is influenced by deicing salts used for winter maintenance of roads. Alkaline deicers could also be an external source of alkalis, therefore, their role in respect to the development of deleterious alkali-silica reaction (ASR) should be considered. The performance of mineral aggregate mixtures in concrete was studied using RILEM test procedure '60°C concrete test with external alkali supply'. Air-entrained concrete specimens were exposed to cyclic temperature changes, wetting-drying and NaCl solution immersion. Tests revealed the development of concrete expansion in time and associated changes of its elastic modulus for 31 mixtures of fine and coarse aggregate and Portland and fly ash or slag blended cements. The expansive behaviour of air-entrained concrete was strongly influenced by the presence of micro- and cryptocrystalline silica in aggregates. A replacement of nonreactive limestone sand by moderately reactive quartz sand resulted in a substantial enhancement of concrete expansion by a factor of three. The observed reduction of elastic modulus was correlated with more abundant presence of alkali-silica reaction products in concrete. Effects of cement type (CEM I, CEM II/A-V, CEM II/B-S) on the ASR performance of concrete with crushed coarse aggregate and quartz sand are discussed. [ABSTRACT FROM AUTHOR]

Alkali silica reaction (ASR) is a harmful phenomenon occurring as a result of chemical interactions between sodium and potassium hydroxides in the pore solution and reactive minerals contained in the aggregate. Reactive minerals like microcrystalline, cryptocrystalline or strained quartz dissolve in the alkaline solution and form an expansive gel product. Proper selection of concrete constituents is necessary to ensure the durability of concrete structures. The proper recognition of the aggregate mineralogical composition is a very important element in the process of selection of concrete components due to the risk of ASR occurrence. This paper presents the results of detailed microscopic analysis of alkali-silica reactivity of domestic fine aggregates of various origins. Six siliceous sands from different locations in Poland and one limestone sand were tested. Detailed petrographic analysis was performed on thin sections. In all siliceous sands micro- and cryptocrystalline quartz was recognized as a reactive mineral. Digital image analysis was performed for quantitative assessment of the potential of reactivity of sands. It revealed, that siliceous river sands were the most susceptible to an alkali-silica reaction, which was confirmed by mortar bar expansion test performed according to the standard test method.

During the decommissioning of nuclear power plants, a significant amount of cement based composites should be disposed as radioactive waste. The use of material with low-activation constituents could effectively reduce radioactivity of concrete. The subject of the paper is the content of trace elements with large activation cross section in concrete constituents due to their ability to be activated in radiation shielding structures. Various Portland cement specimens were subjected to elemental analysis by neutron activation analysis and prompt gamma activation analysis to assess the dominant long-lived residual radioisotopes. Concentrations of the radionuclides, such as Europium-152, Cobalt-60 and Caesium-134 were assessed. Their half-life time is 13.5, 5.27, and 2.07 years, respectively. On the basis of the obtained results, recommendations for cement selection for low-activation concrete are proposed in order to economize decommissioning cost by reducing a radioactive concrete waste.

Salt solutions are used to ensure safe driving conditions during winter. NaCl deicer is the most often used brine in Polish climatic zone. The chemical effects of this type of chloride-based deicer in wetting and drying (WD) and temperature cycles on concrete need to be better understood. This research was focus to study the microstructure of air-entrained pavement concrete after combined chemical (10% of NaCl) and physical (WD and 60°C) exposure conditions. The adopted WD and temperature regime was designed to verify the hypothesis that regularly alternating wetting and drying cycles with external alkali supply from deicer salt will provoke the Alkali-Silica Reaction (ASR). The aggregates varied their origin and mineralogical composition. The microscopic examination was carried out on concrete specimens using SEM with EDX. The microscopic analysis has shown that main reason for concrete deterioration during cyclic chemical and physical exposure conditions was both physical influence - WD cycles and the chemical influence – ASR (primarily, the fine aggregate which lead to form of alkali-silica gel). The expansive gel was shown to be capable of destroying the test specimens. Also differences in mineralogical composition of coarse aggregates influenced on the concrete prism expansion due to ASR.

Copyright of Roads & Bridges / Drogi i Mosty is the property of Road & Bridge Research Institute and its content may not be copied or emailed to multiple sites or posted to a listserv without the copyright holder's express written permission. However, users may print, download, or email articles for individual use. This abstract may be abridged. No warranty is given about the accuracy of the copy. Users should refer to the original published version of the material for the full abstract. (Copyright applies to all Abstracts.)

Copyright of Roads & Bridges / Drogi i Mosty is the property of Road & Bridge Research Institute and its content may not be copied or emailed to multiple sites or posted to a listserv without the copyright holder's express written permission. However, users may print, download, or email articles for individual use. This abstract may be abridged. No warranty is given about the accuracy of the copy. Users should refer to the original published version of the material for the full abstract. (Copyright applies to all Abstracts.)