Search

The study of 5G base station antenna array performance for self-interference reduction is derived. The line of sight signal channel model and Rayleigh channel model are developed. The relevant calculations for channel capacities are shown. This is the pre-material for this study. More results and conclusions will be presented soon., Comment: 4 pages short paper

This paper introduces a novel approach to experimentally characterize effective human skin permittivity at sub-Terahertz (sub-THz) frequencies, specifically from $140$~to $210$~GHz, utilizing a quasi-optical measurement system. To ensure accurate measurement of the reflection coefficients of human skin, a planar, rigid, and thick reference plate with a low-loss dielectric is utilized to flatten the human skin surface. A permittivity characterization method is proposed to reduce permittivity estimation deviations resulting from the pressure effects on the phase displacements of skins under the measurements but also to ensure repeatability of the measurement. In practical permittivity characterizations, the complex permittivities of the finger, palm, and arm of seven volunteers show small standard deviations for the repeated measurements, respectively, while those show significant variations across different regions of the skins and for different persons. The proposed measurement system holds significant potential for future skin permittivity estimation in sub-THz bands, facilitating further studies on human-electromagnetic-wave interactions based on the measured permittivity values., Comment: 13 pages for Journal paper

This manuscript proposes a method for characterizing the complex permittivity of the human finger skin based on an open-ended waveguide covered with a thin dielectric sheet at sub-terahertz frequencies. The measurement system is initially analyzed through full-wave simulations with a detailed finger model. Next, the model is simplified by replacing the finger with an infinite sheet of human skin to calculate the forward electromagnetic problem related to the permittivity characterization. Following this, a radial basis network is employed to train the inverse problem solver. Finally, the complex permittivities of finger skins are characterized for 10 volunteers. The variations in complex relative permittivity across different individuals and skin regions are analyzed, revealing a deviation of $<\pm 1.5$ for both the dielectric constants and loss factors across 140 to 220 GHz. Repeated measurements at the same location on the finger demonstrate good repeatability with a relative estimation uncertainty $<\pm 1.5\%$., Comment: 4 pages, EuMW 2024 conference paper

This manuscript presents a novel method for characterizing the permittivities of low-loss dielectric slabs in sub-terahertz (sub-THz) frequencies, specifically above 100 GHz using a quasi-optical system. The algorithm is introduced with detailed derivations, and the measurement sensitivity is analyzed through simulations. Subsequently, the method's validity is established via simulations, demonstrating high accuracy (error 0.1% for the loss tangent) for a 30 mm thick plate material and relatively lower accuracy (error <5% for the loss tangent) for a 6 mm thick plate material. Notably, this accuracy surpasses that of the approach presented in [1] when the same window width is used to extract signals. Furthermore, a comparison between the permittivities of plexiglass with a 30 mm thickness characterized by the proposed method and the approach in [1] reveals a maximum difference in the dielectric constant of 0.011 and in loss tangent of 0.00071 from 140 to 220 GHz. Finally, the relative complex permittivities of plexiglass at 142.86 GHz obtained by both methods are compared with the reference values provided in [2], exhibiting differences of 0.06 in the dielectric constant., Comment: 8 pages, for IEEE paper form paper submission

Penetration of cellphones into markets requires their robust operation in time-varying radio environments, especially for millimeter-wave communications. Hands and fingers of a human cause significant changes in the physical environments of cellphones, which influence the communication qualities to a large extent. In this paper, electromagnetic models of real hands and cellphone antennas are developed, and their efficacy is verified through measurements for the first time in the literature. Referential cellphone antenna arrays at $28$ and $39$~GHz are designed. Their radiation properties are evaluated through near-field scanning of the two prototypes, first in free space for calibration of the antenna measurement system and for building simplified models of the cellphone arrays. Next, radiation measurements are set up with real hands so that they are compared with electromagnetic simulations of the interaction between hands and simplified models of the arrays. The comparison showed a close agreement in terms of spherical coverage, indicating the efficacy of the hand and antenna array models along with the measurement approach. The repeatability of the measurements is $0.5$~dB difference in terms of cumulative distributions of the spherical coverage at the median level., Comment: 11 pages, 17 figures, Journal

The importance of indoor mobile connectivity has increased during the last years, especially during the Covid-19 pandemic. In contrast, new energy-efficient buildings contain structures like low-emissive windows and multi-layered thermal insulations which all block radio signals effectively. To solve this problem with indoor connectivity, we study passive antenna systems embedded in walls of low-energy buildings. We provide analytical models of a load bearing wall along with numerical and empirical evaluations of wideband back-to-back antenna spiral antenna system in terms of electromagnetic- and thermal insulation. The antenna systems are optimized to operate well when embedded into load bearing walls. Unit cell models of the antenna embedded load bearing wall, which are called signal-transmissive walls in this paper, are developed to analyze their electromagnetic and thermal insulation properties. We show that our signal-transmissive wall improves the electromagnetic transmission compared to a raw load bearing wall over a wide bandwidth of 2.6-8 GHz, covering most of the cellular new radio frequency range 1, without compromising the thermal insulation capability of the wall demanded by the building regulation. Optimized antenna deployment is shown with 22 dB improvement in electromagnetic transmission through the load bearing wall., Comment: 9 pages, 13 figures, submitted to IEEE Transactions on Antennas and Propagation

Implementation of an antenna array on a 5G mobile phone chassis is crucial in ensuring the radio link quality especially at millimeter-waves. However, we generally lack the ability to design antennas under practical operational conditions involving body effects of a mobile user in a repeatable manner. We developed numerical and physical phantoms of a human body for evaluation of mobile handset antennas at 28 GHz. While the numerical phantom retains a realistic and accurate body shape, our physical phantom has much simpler hexagonal cross-section to represent a body. Gains of the phased antenna array configuration on a mobile phone chassis, called co-located array is numerically and experimentally evaluated. The array is formed by placing two sets of 4-element dual-polarized patch antenna arrays, called two modules, at two locations of a mobile phone chassis. Modules are intended to collect the maximum amount of energy to the single transceiver chain. Spherical coverage of the realized gain by the array shows that the experimental statistics of the realized gains across entire solid angles agree with numerical simulations. We thereby demonstrate that our antenna evaluation method reproduces the reality and our phantom serves repeatable tests of antenna array prototypes at 28 GHz., Comment: 10 pages, 12 figures, submitted to IEEE Transactions on Antennas and Propagation

Wireless capsule endoscopy (WCE) systems are used to capture images of the human digestive tract for medical applications. The antenna is one of the most important components in a WCE system. In this paper, we provide novel small antenna solutions for a WCE system operating at the 433 MHz ISM band. The in-body capsule transmitter uses an ultrawideband outer-wall conformal loop antenna, whereas the on-body receiver uses a printed monopole antenna with a partial ground plane. A colon-equivalent tissue phantom and CST Gustav voxel human body model were used for the numerical studies of the capsule antenna. The simulation results in the colon-tissue phantom were validated through in-vitro measurements using a liquid phantom. According to the phantom simulations, the capsule antenna has -10 dB impedance matching from 309 to 1104 MHz. The ultrawideband characteristic enables the capsule antenna to tolerate the detuning effects due to electronic modules in the capsule and due to the proximity of various different tissues in gastrointestinal tracts. The on-body antenna was numerically evaluated on the colon-tissue phantom and the CST Gustav voxel human body model, followed by in-vitro and ex-vivo measurements for validation. The on-body antenna exceeds -10 dB impedance matching from 390 MHz to 500 MHz both in simulations and measurements. Finally, this paper reports numerical and experimental studies of the path loss for the radio link between an in-body capsule transmitter and an on-body receiver using our antenna solutions. The path loss both in simulations and measurements is less than 50 dB for any capsule orientation and location., Comment: 11 pages, 19 figures, Journal, IEEE Transactions on Antennas and Propagation

In an in-band full-duplex system, radios transmit and receive simultaneously in the same frequency band at the same time, providing a radical improvement in spectral efficiency over a half-duplex system. However, in order to design such a system, it is necessary to mitigate the self-interference due to simultaneous transmission and reception, which seriously limits the maximum transmit power of the full-duplex device. Especially, large differences in power levels in the receiver front-end sets stringent requirements for the linearity of the transceiver electronics. We present an advanced architecture for a compact full-duplex multiantenna transceiver combining antenna design with analog and digital cancellation, including both linear and nonlinear signal processing., Comment: Presented in 47th Annual Asilomar Conference on Signals, Systems, and Computers, 2013