Search

This article reviews the current activities at the Montanuniversität Leoben on the design, processing, and characterization of 3D printed advanced ceramics using the lithography‐based manufacturing technology. An overview of the challenges and the opportunities offered to improve the mechanical properties of printing ceramics is given. Their brittle failure is analyzed within the framework of linear elastic fracture mechanics, considering specific aspects of additive manufacturing. Several issues associated with the printing process are addressed, such as surface quality, geometry control, influence of printing directions, as well as the need to establish testing protocols for 3D printed parts. Based on the layer‐by‐layer capabilities of the stereolithographic process, bio‐inspired material design concepts are discussed aiming to enhance the mechanical resistance of 3D‐printed ceramics. By tailoring the layer architecture and microstructure of the parts, high strength and fracture resistance may be achieved. [ABSTRACT FROM AUTHOR]

Fabrication of 3D-printed ceramic parts with high complexity and high spatial resolution often demands low wall thickness as well as high stiffness at the green state, whereas printing simpler geometries may tolerate thicker, more compliant walls with the advantage of a rapid binder-burn-out and sintering process. In this work, the influence of the binder system on the thermophysical properties of 3D-printed stabilized zirconia ceramics was investigated. Samples were fabricated with the lithography- based ceramic manufacturing (LCM) technology using two different photosensitive ceramic suspensions (LithaCon 3Y230 and LithaCon 3Y210), with the same ZrO2 powder. A significant difference in stiffness in the green state (~3 MPa vs. ~32 MPa for LithaCon 3Y230 and LithaCon 3Y210, respectively) was measured, associated with a rather loose or a linked network formed in the binder due to photopolymerization. Both materials reached high relative densities, that is, >99%, exhibiting a homogeneous fine-grained microstructure. No significant differences on the coefficient of thermal expansion (11.18 ppm/K vs. 11.17 ppm/K) or Young's modulus (207 GPa vs. 205 GPa) were measured, thus demonstrating the potential of tailoring binder systems to achieve the required accuracy in 3D-printed parts, without detrimental effects on material's microstructure and thermophysical properties at the sintered state. [ABSTRACT FROM AUTHOR]

The quality of crystallographic alignment in textured ceramics produced by tape casting and templated grain growth (TGG) has been little studied despite its demonstrated impact on magnetic, piezoelectric, and optical properties. Physical and crystallographic alignment of anisotropic template particles is shown to be directly linked to the casting rate, gap height, and casting viscosity during tape casting. These parameters are shown to affect the shape and magnitude of the shear rate profile under the doctor blade during casting which in turn causes a gradient in the torque acting on anisotropic particles. The magnitude of the torque, the time the slurry is exposed to torque during casting, and the ratio of casting height to template diameter are demonstrated to enable the particle alignment process to be tailored to produce well‐aligned template particles. Crystallographic alignment of the textured ceramic was quantified by grain misalignment angle (full width at half maximum, FWHM) and degree of orientation (r) and is directly correlated with the degree of torque during casting. High‐quality alignment (FWHM = 4.5°; r = 0.13) was demonstrated in the model TGG system consisting of submicrometer alumina and 5 vol% 11 μm diameter template platelet particles. [ABSTRACT FROM AUTHOR]