Search

The upstart is commonly used on bars in artistic gymnastics following a release and regrasp skill, where the gymnast will perform a flighted element before catching the bar. The variability of the flighted element leads to varying initial conditions prior to the upstart. The aim of the study was to understand how technique can be manipulated in order to ensure success at the task despite this variability. More specifically, the study aimed to quantify the ranges of initial angular velocity a gymnast could cope with in an upstart using (a) a fixed timing technique, (b) with one additional parameter to modify timings as a function of initial angular velocity, and (c) a further additional parameter to extend the range. Relationships were established, using computer simulation modeling, between the movement pattern parameters, which defined the technique, and the initial angular velocity of the upstart. A two-parameter relationship outperformed both the one-parameter relationship and the fixed timing solution in terms of the range of initial angular velocities the model could cope with. One of the two parameters governed the time by which the initiation of the shoulder extension should be reduced as a function of increased initial angular velocity, and the other parameter performed the same function for the remaining timing parameters at the hip and shoulder. The present study suggests that gymnasts, and, therefore, humans, may be able to modify movement patterns to cope with uncertain initial conditions using a relatively small number of parameters. [ABSTRACT FROM AUTHOR]

The back handspring is one of the most commonly performed skills on the balance beam in women's gymnastics. Despite this, quantitative research on the beam has often been overlooked. This study aimed to investigate the kinetic and kinematic variables during the performance of two back handspring techniques on the beam: the back handspring with two footed landing and the back handspring step-out. A modified balance beam was fixed to a force plate with an isolated mat for landing to allow analysis of the take-off and hand contact phases. Kinetic and kinematic data were recorded for twelve gymnasts performing both techniques. No statistically significant differences between techniques were found during take-off. However, average peak vertical and horizontal ground reaction forces (4.1 bodyweights ± 1.1 BW, and 0.7 BW ± 0.2 BW, respectively) were higher and time to peak force shorter during the hand contact phase for the two footed variant. A more vertical trajectory, along with a greater hand contact ground reaction force were found in comparison to the back handspring performed on the floor. These results highlight the need for more specific investigation to understand the factors which could contribute to reducing the load faced during balance beam performance. [ABSTRACT FROM AUTHOR]

The aim of the study was to examine changes in weight transfer, alignment, and shot outcome during golf shots from flat, uphill, and downhill slopes. Twelve elite male golfers hit 30 shots with a 6-iron from a computer-assisted rehabilitation environment used to create 5° slopes while collecting 3-dimensional kinematics and kinetics of the swing. A launch monitor measured performance outcomes. A shift in the center of pressure was found throughout the swing when performed on a slope, with the mean position moving approximately 9% closer to the lower foot. The golfers attempted to remain perpendicular to the slope, resulting in weight transfer toward the lower foot. The golfers adopted a wider stance in the sloped conditions and moved the ball toward the higher foot at address. Ball speed was not significantly affected by the slope, but launch angle and ball spin were. As the coaching literature predicted, golfers were more likely to hit shots to the left from an uphill slope and to the right from a downhill slope. No consistent compensatory adjustments in alignment at address or azimuth were found, with the change in final shot dispersion resulting from the lateral spin of the ball. [ABSTRACT FROM AUTHOR]

The aim of the study was to examine changes in centre of pressure (COP) movement, alignment and shot outcome during golf shots from flat, uphill, and downhill slopes by mid-handicap golfers. Twelve male golfers hit balls with a six-iron from the flat and 5° slopes while kinematics and kinetics of the swing were collected. A launch monitor measured performance outcomes. A shift in the COP was found during the backswing when playing on a slope, but disappeared during the downswing. Golfers attempted to align the body perpendicular to the slope at the start of the swing resulting in COP movement towards the lower foot, but were not able to maintain this throughout the swing, like low handicap golfers. There was no significant difference in stance width, but golfers placed the ball closer to the uphill foot on a slope. Ball speed was not significantly affected by the slope, but launch angle and ball spin were. Golfers were more likely to hit shots to the left from an uphill slope and to the right for a downhill slope. No consistent compensatory adjustments in alignment at address were found, with differences in final ball position due to lateral spin. [ABSTRACT FROM AUTHOR]

The aim was to determine whether operating a feedforward schema for generating movement pattern parameters was more successful than an open loop strategy for coping with uncertain initial conditions. A computer simulation model was used to determine the optimal solutions that maximised the likelihood of performing a successful upstart. Feedforward schema were established between movement pattern parameters and initial angular velocity. The success of modifying a pre-planned movement pattern based on the parameter relationships (feedforward) was compared with optimal solutions unable to adapt (open loop) to initial angular velocity. The open loop solution was successful 28% and 20% of the time for a full strength (elite) and weaker gymnast. The feedforward strategy had success rates of 99% and 96% respectively. [ABSTRACT FROM AUTHOR]

The upstart is a fundamental skill in gymnastics, requiring whole body coordination to transfer the gymnast from a swing beneath the bar to a support position above the bar. The aim of this study was to determine the solution space within which a gymnast could successfully perform an upstart. A previous study had shown that the underlying control strategy for the upstart could be accounted for by maximizing the likelihood of success while operating in a noisy environment. In the current study, data were collected on a senior gymnast and a computer simulation model of a gymnast and bar was used to determine the solution space for maximizing success while operating in a noisy environment. The effects of timing important actions, gymnast strength, and movement execution noise on the success of the upstart were then systematically determined. The solution space for the senior gymnast was relatively large. Decreasing strength and increasing movement execution noise reduced the size of the solution space. A weaker gymnast would have to use a different technique than that used by the senior gymnast to produce an acceptable success rate. [ABSTRACT FROM AUTHOR]

The undersomersault, or felge, to handstand on parallel bars has become an important skill in Men's Artistic Gymnastics as it forms the basis of many complex variations. To receive no deductions from the judges, the undersomersault must be performed without demonstrating the use of strength to achieve the final handstand position. Two male gymnasts each performed nine undersomersaults from handstand to handstand while data were recorded using an automatic motion capture system. The highest and lowest scoring trials of each gymnast, as determined by four international judges, were chosen for further analysis. Three optimization criteria were used to generate undersomersault technique during the swing phase of the skill using a computer simulation model: minimization of peak joint torques, minimization of horizontal velocity before release, and maximization of angular momentum. The techniques used by both gymnasts could be explained using the second optimization criterion which facilitated further skill development. The first optimization criterion generated a technique advocated for beginners where strength might be expected to be a limiting factor. The third optimization criterion resulted in a different type of undersomersault movement of greater difficulty according to the FIG Code of Points. [ABSTRACT FROM AUTHOR]

The release window for a given dismount from the asymmetric bars is the period of time within which release results in a successful dismount. Larger release windows are likely to be associated with more consistent performance because they allow a greater margin for error in timing the release. A computer simulation model was used to investigate optimum technique for maximizing release windows in asymmetric bars dismounts. The model comprised four rigid segments with the elastic properties of the gymnast and bar modeled using damped linear springs. Model parameters were optimized to obtain a close match between simulated and actual performances of three gymnasts in terms of rotation angle (1.5°), bar displacement (0.014 m), and release velocities (<1%). Three optimizations to maximize the release window were carried out for each gymnast involving no perturbations, 10-ms perturbations, and 20-ms perturbations in the timing of the shoulder and hip joint movements preceding release. It was found that the optimizations robust to 20-ms perturbations produced release windows similar to those of the actual performances whereas the windows for the unperturbed optimizations were up to twice as large. It is concluded that robustness considerations must be included in optimization studies in order to obtain realistic results and that elite performances are likely to be robust to timing perturbations of the order of 20 ms. [ABSTRACT FROM AUTHOR]

It has previously been shown that male gymnasts using the "scooped" giant circling technique were able to flatten the path followed by their mass center, resulting in a larger margin for error when releasing the high bar (Hiley & Yeadon, 2003a). The circling technique prior to performing double layout somersault dismounts from the asymmetric bars in women's artistic gymnastics appears to be similar to the "traditional" technique used by some male gymnasts on the high bar. It was speculated that as a result the female gymnasts would have margins for error similar to those of male gymnasts who use the traditional technique. However, it is unclear how the technique of the female gymnasts is affected by the need to avoid the lower bar. A 4-segment planar simulation model of the gymnast and upper bar was used to determine the margins for error when releasing the bar for 9 double layout somersault dismounts at the Sydney 2000 Olympics. The elastic properties of the gymnast and bar were modeled using damped linear springs. Model parameters, primarily the inertia and spring parameters, were optimized to obtain a close match between simulated and actual performances in terms of rotation angle (1.2°), bar displacement (0.011 m), and release velocities (<1%). Each matching simulation was used to determine the time window around the actual point of release for which the model had appropriate release parameters to complete the dismount successfully. The margins for error of the 9 female gymnasts (release window 43-102 ms) were comparable to those of the 3 male gymnasts using the traditional technique (release window 79-84 ms). [ABSTRACT FROM AUTHOR]

In men's artistic gymnastics the backward giant circle on the high bar is used to produce the angular momentum that the gymnast needs for executing somersaulting dismounts. Dismounts in which the gymnast performs two somersaults in the layout (straight body) position require the greatest angular momentum. However, it appears there are two distinct techniques that elite gymnasts use when performing backward giant circles prior to a double layout somersault dismount. The “traditional” technique has been superseded by the “scooped” technique which is now used by the majority of elite gymnasts. To determine whether the scooped technique is better at producing angular momentum, a simulation model was used to optimize the angular momentum about the mass center at release. The model was evaluated using data obtained from a force/video analysis of accelerated giant circles. The model was able to estimate the reaction forces measured by strain gauges on the bar to within 9% of the peak forces, and the body rotation angle to within 1% of total rotation. During the optimizations, the joint angle time histories of the model were manipulated in order to maximize the angular momentum about the model's mass center at release. Two optima were found which were characteristic of the two backward giant circle techniques used by elite gymnasts. The traditional technique produced more angular momentum than the scooped technique, although both were capable of producing sufficient angular momentum for a double layout somersault dismount. This suggests that the preference of elite gymnasts for the scooped technique must be based on factors other than the production of angular momentum. [ABSTRACT FROM AUTHOR]

Minimising joint torque is often used as an optimisation criterion when investigating human movement. Alternatively, an aspect of performance may be chosen to be maximised when investigating sporting movements. The aim of the study was to optimise the technique in the backward giant circle prior to a double layout somersault dismount from the high bar using various criteria to determine which best characterised the technique adopted by a gymnast. Ten recorded gymnast trials were used to determine bar release parameters and the level of noise in the gymnast’s movements. A computer simulation model of a gymnast and bar was used to optimise giant circle technique under three criteria: minimising joint torques, maximising the release window and maximising success in the presence of motor system noise. Local and global optimisations of technique were performed using the three criteria starting from the average technique of the 10 recorded trials. All global optimum solutions diverged from the gymnast’s technique. The local optimum for maximising success in the presence of noise had a success rate comparable with the global optimum (98% vs. 100%, respectively). It is concluded that the gymnast’s technique is characterised by maximising success despite operating with motor system noise. [ABSTRACT FROM AUTHOR]