Search

To examine gait patterns and gait quality, 7 twins with cerebral palsy were measured preoperatively and after surgical intervention. The aim was to study differences and/or similarities in gait between twins, the influence of personal characteristics and birth conditions, and to describe the development of gait over time after single event multilevel surgery. A standardized clinical exam and a three-dimensional gait analysis were performed. Gait patterns were classified according to Sutherland and Davids, and the Gillette Gait Index was calculated as a global measure of the gait impairment. Next to subject characteristics at time of first measurement, and at time of birth, birth conditions were collected. Gait patterns were determined as crouch gait in 13 legs, as stiff gait in 6 legs and as jump gait in 8 legs. One leg showed a normal gait pattern. The knee flexion-extension angle correlated most constant with the knee flexion-extension angle of the contralateral leg (range 0.91-0.99). Correlations with the legs of the sibling showed variable correlations (range 0.44-0.99); with all other legs medium to high correlations of 0.73-0.91 were found. The Gillette Gait Index was found to initially decrease after surgical intervention. Similar correlations were found between twins or between legs for the gait pattern expressed by the knee flexion-extension angle, and the Gillette Gait Index improved after surgery. It seems that gait quality in twins with cerebral palsy is characterized predominantly by the traumatic disorder: genetic dispositions and personal characteristics only play a negligible role. (Contains 1 figure and 5 tables.)

Trendelenburg walking pattern is a common finding in various disorders, including cerebral palsy (CP), where it is seen in children and adults. Clinically, this deviation is viewed as a consequence of hip abductor weakness resulting in pelvic obliquity. Trunk lean to the ipsilateral side is a common compensatory mechanism to counteract pelvic obliquity and to maintain gait stability. However, no published investigations objectively address pelvic and trunk motions in the frontal plane or examine the correlation with hip abductor weakness in patients with CP. We selected 375 ambulatory (GMFCS I-III) patients with spastic bilateral CP and 24 healthy controls from our gait laboratory database. They had all undergone a standardized three-dimensional analysis of gait, including trunk motion, and a clinical examination including hip abductor strength testing. Selected frontal plane kinematic and kinetic parameters were investigated and statistically tested for correlation (Spearman rank) with hip abductor strength. Only a weak (r = 0.278) yet highly significant correlation between trunk lean and hip abductor strength was found. Hip abductor weakness was accompanied by decreased hip abduction moment. However, no significant differences in pelvic position were found between the different strength groups, indicating that the pelvis remained stable regardless of the patients' strength. Our findings indicate that weak hip abductors in patients with CP are accompanied by increased trunk lean to the ipsilateral side while pelvic position is preserved by this compensatory mechanism. However, since this correlation is weak, other factors influencing lateral trunk lean should be considered. In patients with severe weakness of the hip abductors compensatory trunk lean is no longer fully able to stabilize the pelvis, and frontal pelvic kinematics differs from normal during loading response. The results indicate that the stable pelvic position seems to be of greater importance than trunk position for patients with CP. Further studies are needed to investigate other factors influencing lateral trunk lean. (Contains 3 figures and 2 tables.)

A prototype of a powered knee orthotic device was developed to determine whether fractional external torque and power support to the knee relieves the biomechanical loads and reduces the muscular demand for a subject performing sit-to-stand movements. With this demonstrator, consisting of the subsystems actuation, kinematics, sensors, and control, all relevant sensor data can be acquired and full control is maintained over actuator parameters. A series-elastic actuator based on a direct current motor provides up to 30 Nm torque to the knee via a hinge joint with an additional sliding degree of freedom. For reasons of feasibility under everyday conditions, user intention is monitored by employing a noninvasive, nonsticking muscle activity sensor to replace electromyographic sensors, which require skin preparation. Furthermore, foot plates with force sensors have been developed and included to derive ground reaction forces. The actual knee torque needed to provide the desired support is based on an inverse dynamics model using ground reaction forces signals and leg kinematics. A control algorithm including disturbance feed forward has been implemented. A demonstration experiment with two subjects showed that 23 % of moment support in fact leads to a similar reduction in activation of the main knee extensor muscle. [ABSTRACT FROM AUTHOR]

Background: Shear stress at the stump in trans-tibial amputees induced by turning movements may be reduced with the use of torsion adapters in the prosthesis.Objective: Monitoring the motion and kinetic effects of a regular torsion adapter in comparison to a rigid placebo in unplanned spin and step turns.Study Design: Single-blinded placebo-controlled cohort study.Methods: In total, 10 trans-tibial amputees underwent three-dimensional gait analysis in level walking and unplanned spin and step turns with a torsion adapter and with a rigid placebo.Results: Kinetic effects varied among participants. No statistically significant reduction of peak internal and peak external transverse plane moments was found for the torsion adapter in any walking condition. However, transverse plane rotation of the adapter was monitored in all participants.Conclusion: Motion between the socket and the residual limb may be reduced during turns due to transverse plane motion of the torsion adapter and shear stress on the residual limb may be reduced. However, there may be good and bad responders to torsion adapters due to differences in coupling between the residual limb and the socket.Clinical Relevance: Strong coupling between stump and socket will help the user controlling his prosthesis. Shear stress at the stump may increase in stump-socket interface stiffness and may be the reason for residual limb problems. Torsion adapters therefore may be beneficial for comfort and stump condition in individual cases. [ABSTRACT FROM AUTHOR]