Search

Medial protrusio is a recognized complication of total hip arthroplasty, but it is not known if a medial wall breach during cup implantation increases the risk. We thus investigated the effect of up to a 2 cm defect in the medial acetabular wall in a cadaveric model. Separately, we investigated the ability of acetabular screws to rescue the construct.Nine human fresh-frozen hemipelves were reamed medially to create the defect, implanted with acetabular cups, and then loaded to failure. The nine contralateral hemipelves were reamed in a standard fashion and served as controls. Separately, nine hemipelves with a medial defect were augmented with two acetabular screws each, then loaded to failure, with the contralateral side as a control. Load-to-failure, stiffness, and energy were recorded.The presence of a medial wall defect decreased the load-to-failure by a mean of 26% (5710 v. 4221 N, p=0.024). The addition of two acetabular screws did not rescue the construct (mean 27% decrease, 4082 v. 2985 N, p=0.024). The majority of specimens failed in a supra-physiologic range of force. Bone density correlated with failure loads (R(2) range of 0.54-0.78), and osteoporotic specimens were more likely to fail at a physiologic range, consistent with forces experienced during minor stumbles or falls.Osteoporotic patients with a medial wall defect after hip arthroplasty may be susceptible to fracture during activities of daily living. Protected weight bearing with an assistive device may be reasonable in order to minimize fall risk until cup ingrowth is achieved.

Retrieval analysis of total joint arthroplasty components has primarily focused on assessing wear or other damage to polyethylene components. As damage to the opposing bearing surface can accelerate polyethylene wear and damage, and especially with the use of hard-on-hard articulations, retrieval analysis benefits from incorporating evaluation of hard bearing surfaces as well. The purpose of this study is to report six case studies of metal bearing surfaces with distinctive damage patterns, to interpret them in the context of adverse events plausibly responsible for their creation, and to suggest their likely clinical or scientific significance. The specific damage patterns reported here are 1) extensive scraping, 2) circumferential discoloration, 3) a long chain of periodic micro-indentations, 4) pitting with deposits, 5) scratches with small-radius directional changes, and 6) indentation with scraping.

The processes of whole-joint osteoarthritis development following localized joint injuries are not well understood. To demonstrate this local-to-global linkage, it was hypothesized that a localized osteoarticular injury in the rabbit knee would not only cause biomechanical and histological abnormalities in the involved compartment, but also concurrent histological changes in the non-involved compartment. Twenty rabbits had an acute osteoarticular injury that involved localized joint incongruity (a 2 mm osteochondral defect created in the weight-bearing area of the medial femoral condyle), while another twenty received control sham surgery. At the time of sacrifice at eight or sixteen weeks post-surgery, the experimental knees were subjected to sagittal-plane laxity measurement, followed by cartilage histo-morphological evaluation using the Mankin score. The immediate effects of defect creation on joint stability and contact mechanics were explored in concomitant rabbit cadaver experimentation. The injured animals had cartilage histological scores significantly higher than in the sham surgery group (p