Search

We study the evolution of chromospheric line and continuum emission during the impulsive phase of the X-class SOL2014-09-10T17:45 solar flare. We extend previous analyses of this flare to multiple chromospheric lines of Fe I, Fe II, Mg II, C I, and Si II, observed with IRIS, combined with radiative-hydrodynamical (RHD) modeling. For multiple flaring kernels, the lines all show a rapidly evolving double-component structure: an enhanced, emission component at rest, and a broad, highly red-shifted component of comparable intensity. The red-shifted components migrate from 25-50 km s$^{-1}$ towards the rest wavelength within $\sim$30 seconds. Using Fermi hard X-ray observations, we derive the parameters of an accelerated electron beam impacting the dense chromosphere, using them to drive a RHD simulation with the RADYN code. As in Kowalski et al. 2017a, our simulations show that the most energetic electrons penetrate into the deep chromosphere, heating it to T$\sim$10,000 K, while the bulk of the electrons dissipate their energy higher, driving an explosive evaporation, and its counterpart condensation -- a very dense (n$_e \sim 2 \times 10^{14}$ cm$^{-3}$), thin layer (30--40 km thickness), heated to 8--12,000 K, moving towards the stationary chromosphere at up to 50 km s$^{-1}$. The synthetic Fe II 2814.45A profiles closely resemble the observational data, including a continuum enhancement, and both a stationary and a highly red-shifted component, rapidly moving towards the rest wavelength. Importantly, the absolute continuum intensity, ratio of component intensities, relative time of appearance, and red-shift amplitude, are sensitive to the model input parameters, showing great potential as diagnostics., Comment: Accepted for publication by the Astrophysical Journal - 9th April 2020

The Interface Region Imaging Spectrograph (IRIS) has observed bright spots at the transition region footpoints associated with heating in the overlying loops, as observed by coronal imagers. Some of these brightenings show significant blueshifts in the Si iv line at 1402.77 A (logT[K] = 4.9). Such blueshifts cannot be reproduced by coronal loop models assuming heating by thermal conduction only, but are consistent with electron beam heating, highlighting for the first time the possible importance of non-thermal electrons in the heating of non-flaring active regions. Here we report on the coronal counterparts of these brightenings observed in the hot channels of the Atmospheric Imaging Assembly (AIA) on board the Solar Dynamics Observatory. We show that the IRIS bright spots are the footpoints of very hot and transient coronal loops which clearly experience strong magnetic interactions and rearrangements, thus confirming the impulsive nature of the heating and providing important constraints for their physical interpretation., Comment: 13 pages, 9 figures, accepted by ApJ, movie available upon request to F. Reale

The chromospheric response to the input of flare energy is marked by extended extreme ultraviolet (EUV) ribbons and hard X-ray (HXR) footpoints. These are usually explained as the result of heating and bremsstrahlung emission from accelerated electrons colliding in the dense chromospheric plasma. We present evidence of impulsive heating of flare ribbons above 10 MK in a two-ribbon flare. We analyse the impulsive phase of SOL2013-11-09T06:38, a C2.6 class event using data from Atmospheric Imaging Assembly (AIA) on board of Solar Dynamics Observatory (SDO) and the Reuven Ramaty High Energy Solar Spectroscopic Imager (RHESSI) to derive the temperature, emission measure and differential emission measure of the flaring regions and investigate the evolution of the plasma in the flaring ribbons. The ribbons were visible at all SDO/AIA EUV/UV wavelengths, in particular, at 94 and 131 \AA\ filters, sensitive to temperatures of 8 MK and 12 MK. Time evolution of the emission measure of the plasma above 10 MK at the ribbons has a peak near the HXR peak time. The presence of hot plasma in the lower atmosphere is further confirmed by RHESSI imaging spectroscopy analysis, which shows resolved sources at 11-13 MK associated with at least one ribbon. We found that collisional beam heating can only marginally explain the necessary power to heat the 10 MK plasma at the ribbons., Comment: 21 pages, 15 figures

We present direct evidence for the detection of the main energy release site in a non-eruptive solar flare, SOL2013-11-09T06:38UT. This GOES C2.7 event was characterised by two flaring ribbons and a compact, bright coronal source located between them, which is the focus of our study. We use imaging from SDO/AIA, and imaging spectroscopy from RHESSI to characterise the thermal and non-thermal emission from the coronal source, and EUV spectroscopy from the Hinode/EIS, which scanned the coronal source during the impulsive peak, to analyse Doppler shifts in Fe XII and Fe XXIV emission lines, and determine the source density. The coronal source exhibited an impulsive emission lightcurve in all AIA filters during the impulsive phase. RHESSI hard X-ray images indicate both thermal and non-thermal emission at the coronal source, and its plasma temperature derived from RHESSI imaging spectroscopy shows an impulsive rise, reaching a maximum at 12-13 MK about 10 seconds prior to the hard X-ray peak. High redshifts associated with this bright source indicate downflows of 40-250 km/s at a broad range of temperatures, interpreted as loop shrinkage and/or outflows along the magnetic field. Outflows from the coronal source towards each ribbon are also observed by AIA images at 171, 193, 211, 304 and 1600 A. The electron density of the source obtained from a Fe XIV line pair is $10^{11.50}$ which is collisionally thick to electrons with energy up to 45-65 keV, responsible for the source's non-thermal X-ray emission. We conclude that the bright coronal source is the location of the main release of magnetic energy in this flare, with a geometry consistent with component reconnection between crossing, current-carrying loops. We argue that the energy that can be released via reconnection, based on observational estimates, can plausibly account for the non-thermal energetics of the flare., Comment: 10 pages, 7 figures

The impulsive phase of solar flares is a time of rapid energy deposition and heating in the lower solar atmosphere, leading to changes in the temperature and density structure of the region. We use an O V density diagnostic formed of the 192 to 248 line ratio, provided by Hinode EIS, to determine the density of flare footpoint plasma, at O V formation temperatures of 250,000 K, giving a constraint on the properties of the heated transition region. Hinode EIS rasters from 2 small flare events in December 2007 were used. Raster images were co-aligned to identify and establish the footpoint pixels, multiple-component Gaussian line fitting of the spectra was carried out to isolate the diagnostic pair, and the density was calculated for several footpoint areas. The assumptions of equilibrium ionization and optically thin radiation for the O V lines were found to be acceptable. Properties of the electron distribution, for one event, were deduced from earlier RHESSI hard X-ray observations and used to calculate the plasma heating rate, delivered by an electron beam adopting collisional thick-target assumptions, for 2 model atmospheres. Electron number densities of at least log n = 12.3 cm-3 were measured during the flare impulsive phase, far higher than previously expected. For one footpoint, the radiative loss rate for this plasma was found to exceed that which can be delivered by an electron beam implied by the RHESSI data. However, when assuming a completely ionised target atmosphere the heating rate exceeded the losses. A chromospheric thickness of 70-700 km was found to be required to balance a conductive input to the O V-emitting region with radiative losses. The analysis shows that for heating by collisional electrons, it is difficult, or impossible to raise the temperature of the chromosphere to explain the observed densities without assuming a completely ionised atmosphere., Comment: Accepted to A&A 14th September 2015

Wind-tunnel experiments show new generic configuration for fairing for helicopter rotor hub reduces contribution of hub to overall aerodynamic drag. New generic fairing has flat bottom, which eliminates converging/diverging boundary by straightening surfaces facing each other. Reduces interference drag, similarly to reduction of interference drag by flattening of facing surfaces of two side-by-side airfoils.