Search

Sophisticated analytical solution methods for the stress concentration problem in multilayered composites with interference-fit bolts have been developed on the basis of layer-related solutions. The model is based on a circular or elliptical isotropic bolt integrated in a fibre- or textile-reinforced multilayered composite plate. For the simulation of the interference between bolt and composite plate a modelling strategy has been proposed featuring the application of a defined temperature load to a metallic elastic inclusion. For analysing the stress concentration effects in the surrounding plate, complex-valued displacement functions in combination with the method of conformal mappings for the interface between inclusion and plate and a combination of boundary collocation and least squares method for the outer boundary are used. For the verification of the developed calculation methods, a number of experimental and numerical studies have been carried out and the decay behaviour of the distortions have been compared for different radians. For all combinations of multilayered composite plate and interference-fit bolt investigated so far, a good correlation of the analytically calculated and the numerically determined results can be observed. [ABSTRACT FROM AUTHOR]

Compliant mechanisms are single-piece structures obtaining their desired motion through elastic deformation of flexible parts. The performance of compliant mechanisms is highly dependent on the material properties, which have to be characterized over a wide range of loads. Textile glass fiber reinforced polypropylene is identified as valuable material for compliant structures. The material properties and damage phenomena for tension, shear and compression loading as well as for cyclic loading are elaborated under special consideration of elastic and inelastic deformations. Local strain measurements in the vicinity of an open hole sharpen the validity of homogenized models for textile reinforcements and directing towards multi-scale approaches for a localized deformation analysis. [ABSTRACT FROM AUTHOR]

A partial resection of the lower jaw often has to be carried out in the context of the surgical removal of tumours in the lower jaw, mouth and tongue-floor space and lower jaw fractures with loss of substance, benign bone lesions and extensive difficult inflammation of bone tissue, respectively. The primary reconstruction of the lower jaw after partial resection with loss of continuity is mainly important for functional and aesthetic reasons. The defects of lower jaw continuity are often bridged with metal plates to reconstruct the masticatory function of the lower jaw, temporarily or permanently. Functional as well as aesthetic disadvantages arise in the case of the application of such plates as a result of a high stiffness jump between reconstruction plate and bone and their insufficiently individual design. The employment of biocompatible, carbon-fibre-reinforced Polyetheretherketon (CF-PEEK) permits the development of a geometry- and stiffness-adapted carrying structure for the mandible. For the demand-adapted dimensioning and the test of a CF-PEEK bandage, the application of optical methods, such as the grey value correlation method, is suited as well as numeric methods, such as the finite element method. In an initial analysis of deformation behaviour, the various osteosynthesis configurations are comparatively investigated on a model jaw. The calculations and tests of the lower jaw model show that the use of the new CF-PEEK bandage compared to the use of conventional titanium osteosynthesis plates shows a mechanical behaviour which is much better adapted to the natural lower jaw.