Search

The effects of marble processing wastewater physicochemical treatment sludge (K1) on polypropylene (PP) waste pyrolysis were investigated by lab-scale batch pyrolysis system. PP-K1 proportions and pyrolysis temperature were studied as variables and both were found to have influences onto pyrolysis char, oil/tar, gas fractions distribution, as well as pyrolysis char characteristics (determined via SEM, EDX, FTIR, TGA and XRD analyses). The influence of K1 could be related to its high mineral composition (CaCO3, CaMg(CO3)2 and (Mg0.03Ca0.97)(CO3)) which also detected in the char products. K1 acts as catalyst and remained unchanged in thermochemical reactions below 700°C. The main thermal degradation of PP occurs around 400–470°C, although it starts at about 300–350°C, whereas, K1 resulted in more thermal degradation at 300°C pyrolysis. As K1 dose increased, pyrolysis chars became more thermally stable with the pyrolysis temperature. Diverse types of chars in terms of porosity, thermal strength and chemical structure were produced with PP + K1 as compared to the PP chars. For example, with 10%–20% K1 doses, the chars are in aromatic structure while chars become aliphatic when K1 dosage increased to 30% or above. The structural diversity made these chars new products that can be used as raw material for subsequent purposes. This study provided a basis for the chars' physical and chemical properties which are needed for further research to develop new generation evaluation areas for them. Therefore, a new symbiotic upcycling approach has been presented for PP wastes and marble processing wastewater treatment sludge. [ABSTRACT FROM AUTHOR]

The effects of green pretreatment processes, such as ultrasonic process (US) and deep eutectic solvent (DES), applied to the biomass on kinetic parameters are as important as their effects on characteristic properties. Process conditions and course of reaction progression depend on the knowledge about kinetic parameters, activation energy and reaction model of thermal degradation in scale-up studies. Therefore, in this study, the change in the kinetic parameters with US applied with both distilled water and DES (glycerol:sodium acetate) at 100 W power and 20 kHz frequency for 10 minutes to sunflower seed husk (SSH) was revelaed. Isoconversional methods Kissinger-Akahira-Sunose (KAS) and Flynn-WallOzawa (FWO) were preferred for the evaluation of activation energy of SSH and pretreated SSH at 15°C/min, 20°C/min and 25°C/min heating rates. US pretreatment with DES instead of water resulted in increment of average activation energy values (Ea) from 113.13 to 143.65 kJ/mol in the KAS method. Ea values for all SSH samples changed in the range of 87.72-143.65 kJ/mol and higher Ea values was obtained with KAS method for pretreated SSH samples. Consequently, the use of DES in US pretreatment was more effective to change kinetic parameters of SSH compared to water. [ABSTRACT FROM AUTHOR]