Search

Fluid injection operations, such as CO2 storage and enhanced oil recovery (EOR), imply reservoir pressurization, which changes the effective and total stresses due to poroelastic effects. These stress changes control the geomechanical stability of discontinuities like faults and fractures. Though the effect of these pre-existing discontinuities on stress path is sometimes neglected, the stress state is altered around them. We investigate the effect of a fault on the stress path evolution when pressurizing a reservoir using an in-house hybrid FEM-DEM code called “MDEM”. Simulation results indicate that the stress path is affected by the presence of faults considered to deform elastically, especially in the vicinity of the fault in the reservoir-caprock interfaces. The stress path perturbation is caused by the shear deformation of the fault plane, which is different in the reservoir and the caprock sections. Actually, the magnitude and the extension of the stress path perturbation around a fault become larger for faults with lower shear stiffness. The upper hanging wall and the lower footwall of the fault in the reservoir-caprock interface experience a higher stress path in the horizontal and the vertical directions. Furthermore, the stress paths decrease (negative in the vertical direction) in the upper footwall and the lower hanging wall in the reservoir-caprock interfaces. The fault effect on the stress path increases as the aspect ratio of the reservoir becomes lower. Moreover, the results indicated that both the caprock and the reservoir in the footwall experience a greater change for lower Poisson's ratio of the caprock. These stress changes are independent of the in situ stress regime as long as the fault deforms elastically. However, the impact of the stress path perturbation on the stability of the reservoir and the caprock is different in a compressional (reverse faulting) and an extensional (normal faulting) stress regimes. The stress state becomes less sta

Large amounts of carbon dioxide (CO2) should be injected in deep saline formations to mitigate climate change, implying geomechanical challenges that require further understanding. Pressure build-up induced by CO2 injection will decrease the effective stresses and may affect fault stability. Geomechanical effects of overpressure induced by CO2 injection either in the hanging wall or in the foot wall on fault stability are investigated. CO2 injection in the presence of a low-permeable fault induces pressurization of the storage formation between the injection well and the fault. The low permeability of the fault hinders fluid flow across it and leads to smaller overpressure on the other side of the fault. This variability in the fluid pressure distribution gives rise to differential total stress changes around the fault that reduce its stability. Despite a significant pressure build-up induced by the fault, caprock stability around the injection well is not compromised and thus, CO2 leakage across the caprock is unlikely to happen. The decrease in fault stability is similar regardless of the side of the fault where CO2 is injected. Simulation results show that fault core permeability has a significant effect on fault stability, becoming less affected for high-permeable faults. An appropriate pressure management will allow storing large quantities of CO2 without inducing fault reactivation. © 2016 Institute of Rock and Soil Mechanics, Chinese Academy of Sciences