Search

Abstract Purpose Co-culturing is a widely used method to improve bioethanol production from biomass enriched in fermentable sugars. This study aims to produce bioethanol from sugarcane molasses by simultaneous co-fermentation of S. cerevisiae isolate TA2 and W. anomalus isolate HCJ2F-19. Methods Response surface methodology (RSM) based on the central composite design (CCD) was employed to optimize fermentation conditions, including mixing rate (110–150 rpm), temperature (25–35 °C), molasses concentration (25–35 obrix), and incubation time (36–72 h). The ethanol concentration was analyzed using HPLC equipped with a UV detector. Results The monocultureS. cerevisiae isolate TA2 produced 17.2 g.L−1 of ethanol, 0.33 g.g−1 of ethanol yield, and 0.36 g.L−1.h−1 of productivity compared to W. anomalus isolate HCJ2F that produced 14.5 g.L−1, 0.30 g.g−1 and 0.28 g.L−1.h−1 ethanol, ethanol yield, and productivity under laboratory conditions, respectively. In comparison to single cultures of S. cerevisiae TA2 and W. anomalus HCJ2F, the co-fermentation using both isolates showed an increased ethanol yield of 29% and 53% compared to the single species fermentations, respectively. The results showed that the growth of W. anomalus HCJ2F-19 and S. cerevisiae TA2 was not influenced by each other during the co-fermentation process. The one variable at a time optimization (OVAT) analysis resulted in an ethanol concentration of 26.5 g.L−1 with a specific yield and productivity of 0.46 g.g−1, 0.55 g.L−1.h−1, respectively, at pH 5.5, 25 obrix, 48 h, 150 rpm, 30 °C, 60:40 inoculum ratio, and 10% overall inoculum size. The maximum ethanol concentration of 35.5 g.L−1 was obtained by co-fermentation using the RSM-CCD tool at 30 obrix, 30 °C, 54 h, and 130 rpm. Conclusion The results suggested that the co-fermentation of S. cerevisiae isolate TA2 and W. anomalus isolate HCJ2F improves bioethanol production from sugar cane molasses under optimum fermentation conditions.

Abstract Purpose Yeast strains tolerant to a wide range of stress conditions are needed for the production of bioethanol from substrates rich in sugar. In our earlier research findings, Meyerozyma caribbica isolate MJTm3 (OM329077) demonstrated remarkable stress tolerance and fermentative activity. The present study aimed to optimize six fermentation parameters to generate conducive fermentation conditions for ethanol production by M. caribbica isolate MJTm3. Method The response surface method (RSM) based on central composite design (CCD) was employed to optimize process conditions for higher bioethanol yield. The optimization process was carried out based on six independent parameters, namely temperature (25–35 °C), pH (5.5–6.5), inoculum size (10–20% (v/v)), molasses concentration (25–35 (w/v)), mixing rate (110–150 rpm), and incubation period (48–72-h). Analysis of ethanol concentration was done by HPLC equipped with a UV detector. Result The optimal conditions of the parameters resulting in a maximum predicted ethanol yield were as follows: pH 5.5, an inoculum size of 20%, a molasses concentration of 25 °Bx, a temperature of 30 °C, an incubation period of 72-h, and a mixing rate of 160 revolutions per minute (rpm). Using the above optimum conditions, the model predicted a bioethanol yield of 79%, 92% of the theoretical yield, a bioethanol concentration of 49 g L−1, and a productivity of 0.68 g L−1 h−1. A batch fermentation experiment was carried out to validate the predicted values and resulted in a bioethanol yield of 86%, 95% of theoretical yield, a bioethanol concentration of 56 g L−1, and productivity of 0.78 g L−1 h−1. On the other hand, the surface plot analysis revealed that the synergistic effect of the molasses concentration and the mixing rate were vital to achieving the highest bioethanol yield. These values suggested that the RSM with CCD was an effective method in producing the highest possible output of bioethanol from molasses in actual operation. Conclusion The study confirmed the potential of using M. caribbica isolate MJTm3 for bioethanol production from sugarcane molasses under the abovementioned optimal fermentation conditions.

Hydrocarbon-derived pollutants are becoming one of the most concerning ecological issues. Thus, there is a need to investigate and develop innovative, low-cost, eco-friendly, and fast techniques to reduce and/or eliminate pollutants using biological agents. The study was conducted to isolate, characterize, and identify potential diesel-degrading bacteria. Samples were collected from flower farms, lakeshores, old aged garages, asphalt, and bitumen soils and spread on selective medium (Bushnell Haas mineral salt agar) containing diesel as the growth substrate. The isolates were characterized based on their growth patterns using optical density measurement, biochemical tests, and gravimetric analysis and identified using the Biolog database and 16S rRNA gene sequencing techniques. Subsequently, six diesel degraders were identified and belong to Pseudomonas, Providencia, Roseomonas, Stenotrophomonas, Achromobacter, and Bacillus. Among these, based on gravimetric analysis, the three potent isolates AAUW23, AAUG11, and AAUG36 achieved 84%, 83.4%, and 83% diesel degradation efficiency, respectively, in 15 days. Consequently, the partial 16S rRNA gene sequences revealed that the two most potent bacterial strains (AAUW23 and AAUG11) were Pseudomonas aeruginosa, while AAUG36 was Bacillus subtilis. This study demonstrated that bacterial species isolated from hydrocarbon-contaminated and/or uncontaminated environments could be optimized to be used as potential bioremediation agents for diesel removal.

The discharge of hydrocarbons and their derivatives to environments due to human and/or natural activities cause environmental pollution (soil, water, and air) and affect the natural functioning of an ecosystem. To minimize or eradicate environmental pollution by hydrocarbon contaminants, studies showed strategies including physical, chemical, and biological approaches. Among those strategies, the use of biological techniques (especially bacterial biodegradation) is critically important to remove hydrocarbon contaminants. The current review discusses the insights of major factors that enhance or hinder the bacterial bioremediation of hydrocarbon contaminants (aliphatic, aromatic, and polyaromatic hydrocarbons) in the soil. The key factors limiting the overall hydrocarbon biodegradation are generally categorized as biotic factors and abiotic factors. Among various environmental factors, temperature range from 30 to 40°C, pH range from 5 to 8, moisture availability range from 30 to 90%, carbon/nitrogen/phosphorous (C/N/P; 100:20:1) ratio, and 10–40% of oxygen for aerobic degradation are the key factors that show positive correlation for greatest hydrocarbon biodegradation rate by altering the activities of the microbial and degradative enzymes in soil. In addition, the formation of biofilm and production of biosurfactants in hydrocarbon-polluted soil environments increase microbial adaptation to low bioavailability of hydrophobic compounds, and genes that encode for hydrocarbon degradative enzymes are critical for the potential of microbes to bioremediate soils contaminated with hydrocarbon pollutants. Therefore, this review works on the identification of factors for effective hydrocarbon biodegradation, understanding, and optimization of those factors that are essential and critical.

The provision of current awareness to a community of customers is generally accepted as highly desirable. The service becomes even more valuable when it includes journals held within the customers' own library. Describes a pilot programme conducted at the Rodgers Library for Science and Engineering at the University of Alabama, September 1995 to May 1996. An electronically-accessed table of contents service was distributed to a group of faculty members in the Department of Chemistry. ContentsFirst database from OCLC was electronically accessed and delivered directly to the E-mail address of target users. The objective was to examine how useful an electronic-based current awareness service (CAS) would be to faculty users and how the service might enhance the library's overall role in facilitating the communication of information among researchers. The survey evaluation conducted at the end indicated that provision of table of contents electronically was a highly valuable library service. [ABSTRACT FROM AUTHOR]