Search

Ten gas oils and one deasphalted hydrocracked vacuum residue obtained from ebullated-bed vacuum residue hydrocracking have been cracked in a laboratory advanced catalyst evaluation unit on a commercial fluid catalytic cracking (FCC) catalyst. It was found that the eleven secondary heavy oils obey second-order reaction kinetics. The relations between gas oil properties and FCC conversion, product yields, and quality were evaluated by means of intercriteria analysis. It could be stated that the FCC conversion strongly correlates with the gas oil Kw characterization factor. The product yields were established to depend on the secondary gas oil carbon atoms number, aromatic ring index, paraffinic and aromatic carbon content, and the total aromatics content.

The intercriteria analysis developed on the base of intuitionistic fuzziness and index matrices was applied to evaluate processing data of the LUKOIL Neftohim Burgas H-Oil ebullated bed vacuum residue hydrocracker with the aim of revealing the reasons for increased fouling registered during the 3rd cycle of the H-Oil hydrocracker. It was found that when the ratio of the ΔT of the 1st reactor to the ΔT of the 2nd reactor gets lower than 2.0, an excessive H-Oil equipment fouling occurs. The fouling was also found to be favored by processing of lower Conradson carbon content vacuum residual oils and increased throughput and depressed by increasing the dosage of the HCAT nanodispersed catalyst. The fouling in the atmospheric tower bottom section is facilitated by a lower aromatic content in the atmospheric tower bottom product. The addition of FCC slurry oil not only increases aromatic content but also dissolves some of the asphaltenes in the atmospheric residual hydrocracked oil and decreases its colloidal instability index. The fouling in the vacuum tower bottom section is facilitated by a higher saturate content in the VTB. Surprisingly, it was found that the asphaltene content in the VTB depresses the fouling rate. No relation was found of the sediment content in the hydrocracked residual oils measured by hot filtration tests and by the centrifuge method to the equipment fouling of the H-Oil hydrocracker.

Three H-Oil gas oils, heavy atmospheric gas oil (HAGO), light vacuum gas oil (LVGO), heavy vacuum gas oil (HVGO), and two their blends with hydrotreated straight run vacuum gas oils (HTSRVGOs) were cracked on two high unit cell size (UCS) lower porosity commercial catalysts and two low UCS higher porosity commercial catalysts. The cracking experiments were performed in an advanced cracking evaluation fluid catalytic cracking (FCC) laboratory unit at 527 °C, 30 s catalyst time on stream, and catalyst-to-oil (CTO) variation between 3.5 and 7.5 wt/wt The two high UCS lower porosity catalysts were more active and more coke selective. However, the difference between conversion of the more active high UCS lower porosity and low UCS higher porosity catalysts at 7.5 wt/wt CTO decreased in the order 10% (HAGO) > 9% (LVGO) > 6% (HVGO) > 4% (80% HTSRVGO/20% H-Oil VGO). Therefore, the catalyst performance is feedstock-dependent. The four studied catalysts along with a blend of one of them with 2% ZSM-5 were examined in a commercially revamped UOP FCC VSS unit. The lower UCS higher porosity catalysts exhibited operation at a higher CTO ratio achieving a similar conversion level with more active higher UCS lower porosity catalysts. However, the higher UCS lower porosity catalysts made 0.67% Δ coke that was higher than the maximum acceptable limit of 0.64% for this particular commercial FCC unit (FCCU), which required excluding the HVGO from the FCC feed blend. The catalyst system containing ZSM-5 increased the LPG yield but did not have an impact on gasoline octane. It was found that the predominant factor that controls refinery profitability related to the FCCU performance is the FCC slurry oil (bottoms) yield.