Search

We demonstrate a sapphire machining process integrated with intermediate-scale quantum processors. The process allows through-substrate electrical connections, necessary for low-frequency mode-mitigation, as well as signal-routing, which are vital as quantum computers scale in qubit number, and thus dimension. High-coherence qubits are required to build fault-tolerant quantum computers and so material choices are an important consideration when developing a qubit technology platform. Sapphire, as a low-loss dielectric substrate, has shown to support high-coherence qubits. In addition, recent advances in material choices such as tantalum and titanium-nitride, both deposited on a sapphire substrate, have demonstrated qubit lifetimes exceeding 0.3 ms. However, the lack of any process equivalent of deep-silicon etching to create through-substrate-vias in sapphire, or to inductively shunt large dies, has limited sapphire to small-scale processors, or necessitates the use of chiplet architecture. Here, we present a sapphire machining process that is compatible with high-coherence qubits. This technique immediately provides a means to scale QPUs with integrated mode-mitigation, and provides a route toward the development of through-sapphire-vias, both of which allow the advantages of sapphire to be leveraged as well as facilitating the use of sapphire-compatible materials for large-scale QPUs., Comment: 9 pages, 6 figures

A blazed chirped Bragg grating in a planar silica waveguide device was used to create an integrated diffractive element for a spectrometer. The grating diffracts light from a waveguide and creates a wavelength dependent focus in a manner similar to a bulk diffraction grating spectrometer. An external imaging system is used to analyse the light, later device iterations plan to integrate detectors to make a fully integrated spectrometer. Devices were fabricated with grating period chirp rates in excess of 100nm/mm, achieving a focal length of 5.5mm. Correction of coma aberrations resulted in a device with a footprint of 20mm x 10mm, a peak FWHM resolution of 1.8nm, a typical FWHM resolution of 2.6nm and operating with a 160nm bandwidth centered at 1550nm., Comment: 13 Pages, 8 figures

Direct UV-written waveguides are fabricated in silica-on-silicon with birefringence of $(4.9 \pm 0.2) \times 10^{-4}$, much greater than previously reported in this platform. We show that these waveguides are suitable for the generation of heralded single photons at telecommunication wavelengths by spontaneous four-wave mixing. A pulsed pump field at 1060 nm generates pairs of photons in highly detuned, spectrally uncorrelated modes near 1550 nm and 800 nm. Waveguide-to-fiber coupling efficiencies of 78-91% are achieved for all fields. Waveguide birefringence is controlled through dopant concentration of $\mathrm{GeCl_4}$ and $\mathrm{BCl_3}$ using the flame hydrolysis deposition process. The technology provides a route towards the scalability of silica-on-silicon integrated components for photonic quantum experiments., Comment: 9 pages, 5 figures

We propose and demonstrate a modular architecture for reconfigurable on-chip linear-optical circuits. Each module contains 10 independent phase-controlled Mach-Zehnder interferometers; several such modules can be connected to each other to build large reconfigurable interferometers. With this architecture, large interferometers are easier to build and characterize than with traditional, bespoke, monolithic designs. We demonstrate our approach by fabricating three modules in the form of UV-written silica-on-silicon chips. We characterize these chips, connect them to each other, and implement a wide range of linear optical transformations. We envisage that this architecture will enable many future experiments in quantum optics., Comment: 5 pages, 3 figures

We numerically investigate the implementation of Haar-random unitarity transformations and Fourier transformations in photonic devices consisting of beam splitters and phase shifters, which are used for integrated photonics implementations of boson sampling. The distribution of reflectivities required to implement an arbitrary unitary transformation is skewed towards low values, and this skew becomes stronger the larger the number of modes. A realistic implementation using Mach-Zehnder interferometers is incapable of doing this perfectly and thus has limited fidelity. We show that numerical optimisation and adding extra beam splitters to the network can help to restore fidelity.

Interference between independent single photons is perhaps the most fundamental interaction in quantum optics. It has become increasingly important as a tool for optical quantum information science, as one of the rudimentary quantum operations, together with photon detection, for generating entanglement between non-interacting particles. Despite this, demonstrations of large-scale photonic networks involving more than two independent sources of quantum light have been limited due to the difficulty in constructing large arrays of high-quality single photon sources. Here, we solve the key challenge, reporting a novel array of more than eighteen near-identical, low-loss, high-purity, heralded single photon sources achieved using spontaneous four-wave mixing (SFWM) on a silica chip. We verify source quality through a series of heralded Hong-Ou-Mandel experiments, and further report the experimental three-photon extension of the entire Hong-Ou-Mandel interference curves, which map out the interference landscape between three independent single photon sources for the first time., Comment: 16 pages including supplementary information

Quantum teleportation is a fundamental concept in quantum physics which now finds important applications at the heart of quantum technology including quantum relays, quantum repeaters and linear optics quantum computing (LOQC). Photonic implementations have largely focussed on achieving long distance teleportation due to its suitability for decoherence-free communication. Teleportation also plays a vital role in the scalability of photonic quantum computing, for which large linear optical networks will likely require an integrated architecture. Here we report the first demonstration of quantum teleportation in which all key parts - entanglement preparation, Bell-state analysis and quantum state tomography - are performed on a reconfigurable integrated photonic chip. We also show that a novel element-wise characterisation method is critical to mitigate component errors, a key technique which will become increasingly important as integrated circuits reach higher complexities necessary for quantum enhanced operation., Comment: Originally submitted version - refer to online journal for accepted manuscript; Nature Photonics (2014)

The integrated optical circuit is a promising architecture for the realization of complex quantum optical states and information networks. One element that is required for many of these applications is a high-efficiency photon detector capable of photon-number discrimination. We present an integrated photonic system in the telecom band at 1550 nm based on UV-written silica-on-silicon waveguides and modified transition-edge sensors capable of number resolution and over 40% efficiency. Exploiting the mode transmission failure of these devices, we multiplex three detectors in series to demonstrate a combined 79% +/- 2% detection efficiency with a single pass, and 88% +/- 3% at the operating wavelength of an on-chip terminal reflection grating. Furthermore, our optical measurements clearly demonstrate no significant unexplained loss in this system due to scattering or reflections. This waveguide and detector design therefore allows the placement of number-resolving single-photon detectors of predictable efficiency at arbitrary locations within a photonic circuit - a capability that offers great potential for many quantum optical applications.

We demonstrate the elements of a coupled-resonator optical waveguide in a side-coupled Fabry-P\'erot configuration, and show that the coupling rate between adjacent waveguides can be widely tuned through the thermo-optic effect. The device is linearly scalable and can be combined with other integrated devices, with applications as an optical delay line or as a key element in a cavity-QED based quantum simulator., Comment: 3 pages, 4 figures

While universal quantum computers ideally solve problems such as factoring integers exponentially more efficiently than classical machines, the formidable challenges in building such devices motivate the demonstration of simpler, problem-specific algorithms that still promise a quantum speedup. We construct a quantum boson sampling machine (QBSM) to sample the output distribution resulting from the nonclassical interference of photons in an integrated photonic circuit, a problem thought to be exponentially hard to solve classically. Unlike universal quantum computation, boson sampling merely requires indistinguishable photons, linear state evolution, and detectors. We benchmark our QBSM with three and four photons and analyze sources of sampling inaccuracy. Our studies pave the way to larger devices that could offer the first definitive quantum-enhanced computation., Comment: Main text: 5 pages, 4 figures. Supp Info: 6 pages

Increasing the complexity of quantum photonic devices is essential for many optical information processing applications to reach a regime beyond what can be classically simulated, and integrated photonics has emerged as a leading platform for achieving this. Here, we demonstrate three-photon quantum operation of an integrated device containing three coupled interferometers, eight spatial modes and many classical and nonclassical interferences. This represents a critical advance over previous complexities and the first on-chip nonclassical interference with more than two photonic inputs. We introduce a new scheme to verify quantum behaviour, using classically characterised device elements and hierarchies of photon correlation functions. We accurately predict the device's quantum behaviour and show operation inconsistent with both classical and bi-separable quantum models. Such methods for verifying multiphoton quantum behaviour are vital for achieving increased circuit complexity. Our experiment paves the way for the next generation of integrated photonic quantum simulation and computing devices., Comment: 7 pages, 4 figures

We present direct UV-written waveguides and Bragg gratings operating at 780 nm. By combining two gratings into a Fabry-Perot cavity we have devised and implemented a novel and practical method of measuring the group delay of Bragg gratings., Comment: 10 pages, 8 figures

Integration is currently the only feasible route towards scalable photonic quantum processing devices that are sufficiently complex to be genuinely useful in computing, metrology, and simulation. Embedded on-chip detection will be critical to such devices. We demonstrate an integrated photon-number resolving detector, operating in the telecom band at 1550 nm, employing an evanescently coupled design that allows it to be placed at arbitrary locations within a planar circuit. Up to 5 photons are resolved in the guided optical mode via absorption from the evanescent field into a tungsten transition-edge sensor. The detection efficiency is 7.2 \pm 0.5 %. The polarization sensitivity of the detector is also demonstrated. Detailed modeling of device designs shows a clear and feasible route to reaching high detection efficiencies.