Search

The aim of this study is to evaluate the possibility of using unrefined crude glycerol (CG), a byproduct of the biodiesel industry, in the production of polyurethane foams. In order to assess the suitability of this raw material for the production of polyurethane foams, two samples of crude glycerol with different compositions in glycerol, fatty acids, and methyl esters were used directly, without any pretreatment or purification. Additionally, one of these samples was also submitted to a pre-treatment step in order to evaluate the advantage of purifying the raw material and, for comparison, pure glycerol was also used to prepare polyurethane foams. Both chemical and structural characterizations of the produced foams, as well as the thermomechanical properties determined, showed that unrefined crude glycerol is a suitable ecopolyol for the production of polyurethane foams. Although the presence of fatty acids and esters affects their mechanical performance, this issue can be explored to tune the properties of the ensuing polyurethane foams. Furthermore, the evaluation of the impact of using unrefined CG on the sustainability of polyurethane foams production yielded promising results. [ABSTRACT FROM AUTHOR]

The aim of this study was to evaluate the possibility of using polyols derived from liquefied cork in the production of novel bio-based polyurethane foams ( PUFs). For that purpose, different liquefaction conditions were used at atmospheric pressure and moderate temperature where poly(ethylene glycol) and glycerol were used as solvents and sulfuric acid as catalyst. The ensuing polyols were used to produce foams which were characterized using structural, morphological, thermal and mechanical analyses to demonstrate that liquefaction conditions play a crucial role in the properties of the foams. The resulting foams exhibited the typical cellular structure of PUFs with low densities (57.4-70.7 kg m−3) and low thermal conductivities (0.038-0.040 W m−1 K−1). However, the mechanical properties differed significantly depending on the liquefaction conditions. The best stress-strain results were obtained for PUFs prepared using the polyol with lowest IOH and water content (Young's modulus of 475.0 kPa, compressive stress ( σ10%) of 34.6 kPa and toughness of 7397.1 J m−3). This PUF was thermally stable up to 200 °C and presented a glass transition temperature of around 27 °C. The results obtained demonstrate that these polyols from liquefied cork yield PUFs that are adequate materials for insulation applications. © 2014 Society of Chemical Industry [ABSTRACT FROM AUTHOR]

Polymeric foams can be found virtually everywhere due to their advantageous properties compared with counterparts materials. Possibly the most important class of polymeric foams are polyurethane foams (PUFs), as their low density and thermal conductivity combined with their interesting mechanical properties make them excellent thermal and sound insulators, as well as structural and comfort materials. Despite the broad range of applications, the production of PUFs is still highly petroleum-dependent, so this industry must adapt to ever more strict regulations and rigorous consumers. In that sense, the well-established raw materials and process technologies can face a turning point in the near future, due to the need of using renewable raw materials and new process technologies, such as three-dimensional (3D) printing. In this work, the fundamental aspects of the production of PUFs are reviewed, the new challenges that the PUFs industry are expected to confront regarding process methodologies in the near future are outlined, and some alternatives are also presented. Then, the strategies for the improvement of PUFs sustainability, including recycling, and the enhancement of their properties are discussed. [ABSTRACT FROM AUTHOR]