Search

The misuse of antibiotics as well as incorrect dosage or insufficient time for detoxification can result in the presence of pharmacologically active molecules in fresh milk. Hence, in many countries, commercially available milk has to be tested with immunological, chromatographic or microbiological analytical methods to avoid consumption of antibiotic residues. Here a novel, sensitive and portable assay setup for the detection and quantification of penicillin and kanamycin in whole fat milk (WFM) based on competitive magnetic immunodetection (cMID) is described and assay accuracy determined. For this, penicillin G and kanamycin-conjugates were generated and coated onto a matrix of immunofiltration columns (IFC). Biotinylated penicillin G or kanamycin-specific antibodies were pre-incubated with antibiotics-containing samples and subsequently applied onto IFC to determine the concentration of antibiotics through the competition of antibody-binding to the antibiotic-conjugate molecules. Bound antibodies were labeled with streptavidin-coated magnetic particles and quantified using frequency magnetic mixing technology. Based on calibration measurements in WFM with detection limits of 1.33 ng&middot, mL&minus, 1 for penicillin G and 1.0 ng&middot, 1 for kanamycin, spiked WFM samples were analyzed, revealing highly accurate recovery rates and assay precision. Our results demonstrate the suitability of cMID-based competition assay for reliable and easy on-site testing of milk.

SARS-CoV-2 causes ongoing infections worldwide, and identifying people with immunity is becoming increasingly important. Available point-of-care diagnostic systems as lateral flow assays have high potential for fast and easy on-site antibody testing but are lacking specificity, sensitivity or possibility for quantitative measurements. Here, a new point-of-care approach for SARS-CoV-2 specific antibody detection in human serum based on magnetic immuno-detection is described and compared to standard ELISA. For magnetic immuno-detection, immunofiltration columns were coated with a SARS-CoV-2 spike protein peptide. SARS-CoV-2 peptide reactive antibodies, spiked at different concentrations into PBS and human serum, were rinsed through immunofiltration columns. Specific antibodies were retained within the IFC and labelled with an isotype specific biotinylated antibody. Streptavidin-functionalized magnetic nanoparticles were applied to label the secondary antibodies. Enriched magnetic nanoparticles were then detected by means of frequency magnetic mixing detection technology, using a portable magnetic read-out device. Measuring signals corresponded to the amount of SARS-CoV-2 specific antibodies in the sample. Our preliminary magnetic immuno-detection setup resulted in a higher sensitivity and broader detection range and was four times faster than ELISA. Further optimizations could reduce assay times to that of a typical lateral flow assay, enabling a fast and easy approach, well suited for point-of-care measurements without expensive lab equipment.

For performing point-of-care molecular diagnostics, magnetic immunoassays constitute a promising alternative to established enzyme-linked immunosorbent assays (ELISA) because they are fast, robust and sensitive. Simultaneous detection of multiple biomolecular targets from one body fluid sample is desired. The aim of this work is to show that multiplex magnetic immunodetection based on magnetic frequency mixing by means of modular immunofiltration columns prepared for different targets is feasible. By calculations of the magnetic response signal, the required spacing between the modules was determined. Immunofiltration columns were manufactured by 3D printing and antibody immobilization was performed in a batch approach. It was shown experimentally that two different target molecules in a sample solution could be individually detected in a single assaying step with magnetic measurements of the corresponding immobilization filters. The arrangement order of the filters and of a negative control did not influence the results. Thus, a simple and reliable approach to multi-target magnetic immunodetection was demonstrated.

During the last decade protein electrochemistry at miniaturized electrodes has become important not only for functional studies of the charge transfer properties of redox proteins but also for fostering the development of sensitive biosensor and bioelectronic devices. One of the major challenges in this field is the directed coupling between electronic and biologically active components. A prerequisite for a fast and reversible electron transfer between electrode and protein is that the protein can be bound to the electrode in a favourable orientation. We examined electrostatic and bioaffinity-tag binding strategies for the directed immobilization of horse heart cytochrome c (cytc) on gold electrode surfaces to achieve this goal. Horse heart cytc was expressed in E. coli either as non-modified or genetically modified, i.e. histidine (his)-tag containing protein. The his-tags were introduced at defined positions at the N- or C-terminus of the polypeptide. It was our aim to generate tagged-versions of cytc that facilitate strong electronic coupling between protein and electrode and, at the same time, retain their catalytic and regulatory properties. The combination of different immobilization strategies, e.g. his-tag and electrostatic immobilization also opens new avenues for bivalent immobilization of proteins. This is of interest for molecular bioelectronic and biosensing applications where the proteins are immobilized between two crossing electrodes.

Nanostructured surfaces have recently gained in importance for electrochemical applications because of an enhanced surface area compared to planar substrates. Due to this property, structured substrates are well suited for electrochemical (bio-)sensors, capacitive coupling with electrogenic cells, and other bioelectronic applications. However, the relationship between electrolytically exposed and redox-active surface areas of nanostructured electrodes compared to planar electrodes is still under discussion. Here, we performed a series of comparative studies to elucidate processes taking place at the electrochemically active surface of gold nanopillars. The pillars, approximately 200 nm in height and 50 nm in diameter, were fabricated using template-assisted nanostructuring. The surface area increase compared to planar electrodes was determined by scanning electron microscopy (SEM), and the redox-active surface area of the same sample was derived from cyclovoltammetric studies. We found consistency between the SEM results and the electrochemically active surfaces determined by cyclic voltammetry of immobilized ferrocenylhexanethiol, immobilized cytochrome c, and oxidation/reduction of gold for small scan rates. Similar values were derived from the capacitance measured by cyclic voltammetry, whereas impedimetric measurements revealed values twice as high. Commonly used diffusion-controlled systems, such as hexacyanoferrate, showed a smaller increase of the electroactive surface area. Finally, we conclude that the sterically restricted diffusion of redox-active species leads to an inaccurate determination of the electroactive surface area of nanosized electrodes.

Plant pathogens cause major economic losses in the agricultural industry because late detection delays the implementation of measures that can prevent their dissemination. Sensitive and robust procedures for the rapid detection of plant pathogens are therefore required to reduce yield losses and the use of expensive, environmentally damaging chemicals. Here we describe a simple and portable system for the rapid detection of viral pathogens in infected plants based on immunofiltration, subsequent magnetic detection, and the quantification of magnetically labeled virus particles. Grapevine fanleaf virus (GFLV) was chosen as a model pathogen. Monoclonal antibodies recognizing the GFLV capsid protein were immobilized onto immunofiltration columns, and the same antibodies were linked to magnetic nanoparticles. GFLV was quantified by immunofiltration with magnetic labeling in a double-antibody sandwich configuration. A magnetic frequency mixing technique, in which a two-frequency magnetic excitation field was used to induce a sum frequency signal in the resonant detection coil, corresponding to the virus concentration within the immunofiltration column, was used for high-sensitivity quantification. We were able to measure GFLV concentrations in the range of 6 ng/ml to 20 μg/ml in less than 30 min. The magnetic immunoassay could also be adapted to detect other plant viruses, including Potato virus X and Tobacco mosaic virus , with detection limits of 2 to 60 ng/ml.

Reliable techniques to detect the presence and zygosity of transgenic events in plants are crucial for biotechnology research and plant breeding industry. Therefore, we have introduced a novel assay, which enables high-throughput genotyping of transgenic events in maize using duplex real-time PCR. We demonstrated that the presence and zygosity of two selected transgenic events could be detected with high reproducibility and that our method is suitable for rapid genotyping of a large number of samples.

Simple and reliable, high-throughput techniques to detect the zygosity of transgenic events in plants are valuable for biotechnology and plant breeding companies seeking robust genotyping data for the assessment of new lines and the monitoring of breeding programs. We show that next-generation sequencing (NGS) applied to short PCR products spanning the transgene integration site provides accurate zygosity data that are more robust and reliable than those generated by PCR-based methods. The NGS reads covered the 5′ border of the transgenic events (incorporating part of the transgene and the flanking genomic DNA), or the genomic sequences flanking the unfilled transgene integration site at the wild-type locus. We compared the NGS method to competitive real-time PCR with transgene-specific and wild-type-specific primer/probe pairs, one pair matching the 5′ genomic flanking sequence and 5′ part of the transgene and the other matching the unfilled transgene integration site. Although both NGS and real-time PCR provided useful zygosity data, the NGS technique was favorable because it needed fewer optimization steps. It also provided statistically more-reliable evidence for the presence of each allele because each product was often covered by more than 100 reads. The NGS method is also more suitable for the genotyping of large panels of plants because up to 80 million reads can be produced in one sequencing run. Our novel method is therefore ideal for the rapid and accurate genotyping of large numbers of samples.

Here, we report a new strategy for the directed bivalent immobilization of cyt c on or between gold electrodes. C-terminal modification with cys- or his-tag did not affect the functional integrity of the protein. In combination with electrostatic protein binding, these tags enable a bifunctional immobilization between two electrodes or alternatively one electrode and interacting enzymes.