Search

A method for the determination of methylmercury in plasma and serum samples was developed. The method uses isotope dilution with (198)Hg-labeled methylmercury, extraction into dichloromethane, back-extraction into water, aqueous-phase ethylation, purge and trap collection, thermal desorption, separation by gas chromatography, and mercury isotope specific detection by inductively coupled plasma mass spectrometry. By spiking 2 mL sample with 1.2 ng tracer, measurements in a concentration interval of (0.007-2.9) μg L(-1) could be performed with uncertainty amplification factors <2. A limit of quantification of 0.03 μg L(-1) was estimated at 10 times the standard deviation of concentrations measured in preparation blanks. Within- and between-run relative standard deviations were <10% at added concentration levels of 0.14 μg L(-1), 0.35 μg L(-1) and 2.8 μg L(-1), with recoveries in the range 82-110%. Application of the method to 50 plasma/serum samples yielded a median (mean; range) concentration of methylmercury of 0.081 (0.091; <0.03-0.19) μg L(-1). This is the first time methylmercury has been directly measured in this kind of specimen, and is therefore the first estimate of a reference range., (Copyright © 2011 Elsevier B.V. All rights reserved.)

The ferrihydrite-backed DGT (diffusive gradients in thin films), recently developed for arsenic and phosphate measurements was, for the first time, characterized with respect to molybdate, antimonate, vanadate and tungstate determination. Arsenate was included in the characterization to allow comparison with literature data and thus provide quality control of the measurements. In addition to laboratory experiments, field measurements were carried out in a natural stream in northern Sweden affected by mine drainage. It was shown that ferrihydrite-DGT is suitable for simultaneous determination of labile arsenic, molybdate, antimonate, vanadate and tungstate over a wide pH range. Diffusion coefficients were estimated using two different methods; diffusion cell and direct uptake to DGT devices in synthetic solutions. Estimations of the coefficients using the direct uptake method were performed between pH 4 and 8. The results from the two methods agreed well irrespective of pH, except for molybdate and antimonate that showed decreased values at pH 8. Adsorption of the analytes to ferrihydrite gel-discs was rapid at all pH values. However, there was a tendency toward lower adsorption affinity for antimonate compared to the other anions. 100% recovery of accumulated analytes was achieved through complete dissolution of the ferrihydrite adsorbent using 1.4 molL(-1) HNO(3) with 0.1 molL(-1) HF. From field sampling it was concluded that the opportunities for accurate antimonate and molybdate determination decrease at pH≥8.7. DGT-labile concentrations were generally lower than dissolved concentrations. Relatively lower DGT concentrations, compared to dissolved (<0.45 μm), were observed under a period when ferric oxide precipitations were detected on the DGT protective filter., (Copyright © 2010 Elsevier B.V. All rights reserved.)

The glycerol tri[1-14C]olein test for fat malabsorption was carried out in two male volunteers and measurements of the loss of 14C in expired air, urine and faeces and the retention of 14C in biopsy samples of abdominal fat were made using accelerator mass spectrometry. Exhalation accounted for 73% and 55% of the administered activity and could be described by three-component exponential functions with halftimes of about 1h, 2 days and 150 days, respectively. Urinary excretion accounted for 24% of the administered activity, almost all during the first 24h after administration; about 2% was excreted in the faeces in 48h. The halftime of retention of 14C in fat ranged from 137 to 620 days. Absorbed dose calculations indicate that for a normal adult the largest dose, 1.5-7.0mGy/MBq is received by the adipose tissue, and that the effective dose is 0.3-0.5mSv/MBq. It is concluded that no restrictions need to be placed on radiation safety grounds on the administration of 0.05-0.1MBq 14C-triolein for the triolein breath test.