Search

POLARBEAR-2b (PB-2b) is the second receiver in the Simons Array, a cosmic microwave background (CMB) polarization experiment. The Simons Array uses dichroic polarization sensitive lenslet-coupled sinuous antennas and transition-edge sensor (TES) bolometers made of superconducting films. These bolometers are read out with frequency multiplexing electronics. PB-2b contains ∼ 7500 detectors in two bands at 90 and 150 GHz with arcminute resolution. The polarization of these detectors is modulated by a cryogenic continuously rotating half-wave plate. PB-2b was installed on its telescope in 2022 in the Atacama Desert at an altitude of 5.2 km. This paper will detail initial readout commissioning, test of a new loopgain monitoring method, and focusing the optics. Work is ongoing to commission the remaining ambient temperature readout electronics, measure detector time constants, and observe with the cryogenic half-wave plate spinning [ABSTRACT FROM AUTHOR]

We are developing the frequency-domain multiplexing (FDM) readout for the SAFARI far-infrared spectrometer on board the SPICA space observatory. Each readout channel comprises a set of ~ 160 TESs and LC filters and is read out with a SQUID preamplifier. Baseband feedback is applied to overcome the dynamic range limitations of the SQUID. We have carried out extensive characterization of a test readout system coupled to a 176-pixel TES bolometer array in order to understand and optimize the system. We present our latest measurements of this 176-pixel FDM demonstrator, focusing on the noise contribution from the SQUID. [ABSTRACT FROM AUTHOR]

Our new detector and readout concept brings together TES (Transition Edge Sensor) and MKID (Microwave Kinetic Inductance Detector) technologies and exploits the idea of a microwave-induced superconducting transition in a small thin-film microbridge. The superconducting transition of the bridge manifests itself as variation in the Q -factor of niobium resonators at 5–8 GHz, somewhat similar to MKID operation. We present data showing the potential for developing this concept into multipixel detector arrays. Single-pixel sensitivity was measured at 4.5 K for an input band of 600–700 GHz using a prototype 10-nm-thick Nb bridge of size 1 μm × 500 nm. Radiation from human skin was detected with a resolution better than 1 K/rtHz, which is encouraging for terahertz imaging applications. To further improve device sensitivity, we are also developing Hf-based devices that operate near 0.35 K. Details about the physics and stability of these devices are discussed. [ABSTRACT FROM PUBLISHER]