Search

The chemical stabilization, or immobilization, of trace elements (metals and metalloids; TE) in contaminated soil has been studied for decades. A vast number of scientific publications are available on the method performance in laboratory settings, reporting that the application of various soil amendments to contaminated soil reduces TE mobility, bioavailability and toxicity. The most commonly used soil amendments include organic matter, iron oxides, phosphates, ashes, and lately biochar, alone or in combination with each other and/or lime. Most of the implemented field studies show a certain degree of improvement in soil and/or vegetation status following amendment. Regardless the positive performance of the technique in the laboratory, field validations and demonstrations remain scarce. The establishment of a field experiment often involves permits from authorities and agreements with site owners, both of which are considerably more time-consuming than laboratory tests. Due to conservative institutional structures, public authorities have been slow to adopt alternative remediation technologies, especially when the total TE concentration in soil remains the same and all of the associated risks are not yet convincingly described. For this reason, researchers should also focus on enhancing public knowledge of alternative remediation techniques so that future projects which aim to demonstrate the effectiveness of in situ immobilization techniques under natural conditions will be supported.

Industrial residues, such as fly ashes and biosolids, contain elements (e.g., N, P, K, S, Ca and Zn) that make them a viable alternative for synthetic fertilizers in forestry and agriculture. However, the use of these materials is often limited due to the presence of potentially toxic substances. It is therefore necessary to assess and, when warranted, modify the chemical and physical form of these and similar waste materials before any advantages are taken of their beneficial properties. Biofuel fly ash, municipal solid waste incineration (MSWI) fly ash, biosolids, peat, peat residues and gypsum board waste were combined in various proportions, and this resulted in increased leaching of N, P, S, Cu and Mn, but decreased leaching of Ca, K, Mg, Cr, Fe, Ni, Zn, Al, As and Pb. Chemical fractionation revealed that elements Ca, K, Mg, S and Mn were predominantly exchangeable, while the rest of the elements were less mobile. Cadmium was mostly exchangeable in MSWI fly ash, but less mobile in biofuel fly ash mixtures. Recycling of MSWI fly ash in the mixtures with fertilizers is considerably less attractive, due to the high levels of salts and exchangeable Cd.

The area’s natural analogues, vitrifi ed forts, combustion technology, and vitrifi ed waste have been reviewed.The purpose was to identify if investigations of vitrifi ed rock in hill forts might b ...

The aim of the study was to determine if an As-contaminated soil, stabilized using zerovalent iron (Fe(0)) and its combination with gypsum waste, coal fly ash, peat, or sewage sludge, could be used as a construction material at the top layer of the landfill cover. A reproduction of 2 m thick protection/vegetation layer of a landfill cover using a column setup was used to determine the ability of the amendments to reduce As solubility and stimulate soil functionality along the soil profile. Soil amendment with Fe(0) was highly efficient in reducing As in soil porewater reaching 99 % reduction, but only at the soil surface. In the deeper soil layers (below 0.5 m), the Fe treatment had a reverse effect, As solubility increased dramatically exceeding that of the untreated soil or any other treatment by one to two orders of magnitude. A slight bioluminescence inhibition of Vibrio fischeri was detected in the Fe(0) treatment. Soil amendment with iron and peat showed no toxicity to bacteria and was the most efficient in reducing dissolved As in soil porewater throughout the 2 m soil profile followed by iron and gypsum treatment, most likely resulting from a low soil density and a good air diffusion to the soil. The least suitable combination of soil amendments for As immobilization was a mixture of iron with coal fly ash. An increase in all measured enzyme activities was observed in all treatments, particularly those receiving organic matter. For As to be stable in soil, a combination of amendments that can keep the soil porous and ensure the air diffusion through the entire soil layer of the landfill cover is required.

The recycling of hygienized municipal sewage sludge (biosolids) to soil as the source of phosphorus (P) is generally encouraged. The use of biosolids, however, has some concerns, such as the presence of elevated concentrations of potentially toxic trace elements, and the possible presence of pathogens, hormones and antibiotics. Organic substances are destroyed during combustion whereas trace elements could partly be separated from P in different ash fractions. Biomass combustion waste (ash) can instead be considered as an alternative P source. This study evaluates and compares the impact of biosolids and their combustion residues (ashes), when used as fertilizers, on P and Cd solubility in soil, plant growth and plant uptake of these elements. Biosolids were also amended with K and Ca to improve the composition and properties of P in ashes, and incinerated at either 800 °C or 950 °C. Combustion of biosolids improved the Cd/P ratio in ashes by 2-5 times, compared with the initial biosolids. The low Cd content in ashes (4-9 mg Cd (kg P)(-1)) makes this material a particularly attractive alternative to mineral fertilizers. Significantly higher pore water P (as well as total N) was measured in soils containing biosolids, but plants produced a higher biomass in soil fertilized with ashes. The K and Ca amendments prior to biosolids combustion generally decreased the total Cd in ash, but had little effect on P and Cd uptake and biomass growth. Similarly, the combustion temperature had negligible effect on these factors as well.

An investigation of the spatial variability of topsoil contamination level was performed in 49 preschool playgrounds located in Vilnius city and correlated with urban (height and age of the preschools and height of surrounding buildings) and natural (altitude) factors. Composite samples, consisting of 20–30 sub-samples, were collected from 10 cm topsoil layer with a 3–5 m distance from each other. Sieved fraction (< 0.63 mm) was ashed at 400 °C, ground to < 1.0 μm and analysed for the real total concentrations of 22 trace elements (Ag, B, Ba, Co, Cr, Cu, Ga, Li, Mn, Mo, Nb, Ni, Pb, Sc, Sn, Sr, Ti, V, Y, Yb, Zn and Zr) using optical atomic emission spectrophotometry. Information on construction year and height (number of building stories) of preschool and surrounding buildings was acquired from the Centre of Registers of Lithuania. Out of 22 analysed elements, 13 to a greater extent exceeded the background values in several areas and were used to calculate the total contamination index (Zs13). Out of 49 analysed areas, 21 had moderately hazardous to hazardous levels of contamination as indicated by Zs13. The main contaminating elements, exceeding the permissible concentrations were Ag, Cu, Mo, Pb, Sn and Zn, the origins of which coincide with city industry and traffic. Topsoil around the newer preschool buildings, despite their location, contained lower concentrations of contaminants, while areas at higher altitudes were more contaminated than those located at lower altitudes. The latter causality is biased, as the city industry, and hence the highest contamination, is in districts located higher above sea level than the remaining studied sites.

Increase of energy recovery from municipal solid waste by incineration results in the increased amounts of incineration residues, such as fly ash, that have to be taken care of. Material properties should define whether fly ash is a waste or a viable resource to be used for various applications. Here, two areas of potential fly ash application are reviewed: the use of fly ash in a landfill top cover either as a liner material or as a soil amendment in vegetation layer. Fly ashes from incineration of three types of fuel are considered: refuse derived fuel (RDF), municipal solid waste incineration (MSWI) and biofuel. Based on the observations, RDF and MSWI fly ash is considered as suitable materials to be used in a landfill top cover liner. Whereas MSWI and biofuel fly ashes based on element availability for plant studies, could be considered suitable for the vegetation layer of the top cover. Responsible application of MSWI ashes is, however, warranted in order to avoid element accumulation in soil and elevation of background values over time.

Aging of refuse-derived fuel (RDF) fly ashes was investigated in a long-term laboratory experiment. Aging affected the chemical stability of RDF fly ash in terms of leaching behavior, ANC, and mineralogical transformations. The design of experiment model evaluation showed that the use of RDF ashes in a top cover liner construction has the following advantages: most of the investigated hazardous elements like Pb, Cl, Cr, Cu, etc., will not be released from the ashes, and their buffer capacity will increase with time. However, aging has the disadvantage that leaching of Zn and SO4 is likely to increase. The multivariate data analysis of the coefficients of variation did not reveal any systematic errors in the performance of the experiment. However, batch leaching test not always reflect the real situation in the landfill top cover environment.

The effects of aging should be considered for reliable long-term assessments of the environmental risks of the use of refuse-derived-fuel (RDF) fly ash as landfill top cover liner material. Mineral transformations that occur in RDF fly ash, and the effects of selected factors on these transformations, were studied on compacted fly ash specimens in an accelerated aging experiment using a reduced factorial design. Carbon dioxide concentration, temperature, relative air humidity, time, and the quality of added water were varied in six factor combinations. Acid neutralization capacity and leaching behavior were analyzed after four different periods of time. The results were evaluated with multivariate data analysis. A significant change in the acid neutralization capacity, a decrease in leaching of Ba, Ca, Cl−, Cr, Cu, Pb, K, and Na, and an increase in solubility of Mg, Si, Zn, and SO42− could be attributed to different aging conditions.

The aim of the plant pot experiment was to evaluate potential environmental impacts of combined industrial residues to be used as soil fertilisers by analysing i) element availability in fly ash and biosolids mixed with soil both individual and in combination, ii) changes in element phytoavailability in soil fertilised with these materials and iii) impact of the fertilisers on plant growth and element uptake. Plant pot experiments were carried out, using soil to which fresh residue mixtures had been added. The results showed that element availability did not correlate with plant growth in the fertilised soil with. The largest concentrations of K (3534 mg/l), Mg (184 mg/l), P (1.8 mg/l), S (760 mg/l), Cu (0.39 mg/l) and Zn (0.58 mg/l) in soil pore water were found in the soil mixture with biosolids and MSWI fly ashes; however plants did not grow at all in mixtures containing the latter, most likely due to the high concentration of chlorides (82 g/kg in the leachate) in this ash. It is known that high salinity of soil can reduce germination by e.g. limiting water absorption by the seeds. The concentrations of As, Cd and Pb in grown plants were negligible in most of the soils and were below the instrument detection limit values. The proportions of biofuel fly ash and biosolids can be adjusted in order to balance the amount and availability of macronutrients, while the possible increase of potentially toxic elements in biomass is negligible seeing as the plant uptake of such elements was low.

An information survey was conducted in the areas of natural analogues, vitrified forts, combustion technology and vitrified waste.The main purpose was to identify if vitrified stone material in hil ...

Carbon in waste can occur as inorganic (IC), organic (OC) and elemental carbon (EC) each having distinct chemical properties and possible environmental effects. In this study, carbon speciation was performed using thermogravimetric analysis (TGA), chemical degradation tests and the standard total organic carbon (TOC) measurement procedures in three types of waste materials (bottom ash, residual waste and contaminated soil). Over 50% of the total carbon (TC) in all studied materials (72% in ash and residual waste, and 59% in soil) was biologically non-reactive or EC as determined by thermogravimetric analyses. The speciation of TOC by chemical degradation also showed a presence of a non-degradable C fraction in all materials (60% of TOC in ash, 30% in residual waste and 13% in soil), though in smaller amounts than those determined by TGA. In principle, chemical degradation method can give an indication of the presence of potentially inert C in various waste materials, while TGA is a more precise technique for C speciation, given that waste-specific method adjustments are made. The standard TOC measurement yields exaggerated estimates of organic carbon and may therefore overestimate the potential environmental impacts (e.g. landfill gas generation) of waste materials in a landfill environment.