Search

The aim of this trial was to determine whether a toothpaste with microcrystalline hydroxyapatite is not inferior to a fluoride toothpaste in prevention of caries in children. This double-blinded randomized control trial compared two toothpastes regarding the occurrence of caries lesions using International Caries Detection and Assessment System (ICDAS) ≥ code 1 on the primary dentition within 336 days. The test group used a fluoride-free hydroxyapatite toothpaste three times daily while control group used a toothpaste with fluoride. 207 children were included in the intention-to-treat analysis; 177 of them finished the study per protocol. An increase in caries ICDAS ≥ code 1 per tooth was observed in 72.7% of the hydroxyapatite-group (n = 88), compared with 74.2% of the fluoride-group (n = 89). The exact one-sided upper 95% confidence limit for the difference in proportion of participants with ICDAS increase ≥ 1 (-1.4%) was 9.8%, which is below the non-inferiority margin of 20% demonstrating non-inferiority of hydroxyapatite compared to the fluoride control toothpaste. This RCT showed for the first time, that in children, the impact of the daily use of a toothpaste with microcrystalline hydroxyapatite on enamel caries progression in the primary dentition is not inferior to a fluoride control toothpaste (Clinical Trials NCT03553966).

Introduction. Various materials are used in direct dental pulp capping method. Their biocompatibility and alkalizing abilities are of primary importance affecting therapeutic effects. The aim of this study was to evaluate and compare the cytotoxicity of various pulp-capping materials on human gingival fibroblasts and investigate the pH changes induced by these materials. Material and methods. Human gingival fibroblasts were cultured with nine direct pulp materials using culture plate inserts. The cytotoxic effects were recorded by using an MTT-based colorimetric assay after 3 and 24 h. In the second part of the experiment, the materials were inserted in dialysis tubes and transferred into plastic vials containing deionized water. The changes of the medium pH were measured after 3 and 24 h. Results. We showed differences in cell viability of gingival fibroblasts after varied time of exposition for the tested materials. Cell viability after 24 h increased for Dycal, Biopulp, and Calcipro, and decreased for Calcipulpe, Angelus, Angelus White, and ProRoot Regular. Cell viability for ProRoot and Life did not change. Non-setting calcium hydroxide preparations followed by the MTA group and setting calcium hydroxide materials produced the highest pH. All the tested materials significantly increased pH (p < 0.0001) at 24 h. Conclusions. Currently used pulp capping materials varied in their cytotoxicity relative to human gingival fibroblasts and their alkalizing capacities. Since most likely pH does not affect the viability of cultured cells, further investigations are required to determine physicochemical properties of these materials and the biological activity of the dental pulp. (Folia Histochemica et Cytobiologica 2017, Vol. 55, No. 2, 86–93)

Objective: To do a clinical and radiographic evaluation of the effectiveness of MTA when used as a direct pulp capping material in primary molars. Study design: Clinical and radiographic follow-up was performed on 30 primary molars with deep caries lesions in 30 patients from 3 to 9.75 years of age. Pulps exposed during cavity preparation were treated by direct pulp capping with MTA. The follow-up clinical and radiographic examinations were carried out at different time intervals: 6, 7–12, 13–18, 19–24, and >24 months after treatment. Results: Twenty-four teeth were evaluated during the entire observation period. Positive clinical and radiographic outcomes were achieved in 19 teeth (13 teeth were saved and 6 were exfoliated). In five teeth, complications were observed only in children under 7 years old. Conclusion: Based on these clinical and radiographic results, MTA was found to be successful when used as a direct pulp capping material in primary teeth.

The aim of this ex vivo study was to compare the performance of the visual ICDAS II scale and two fluorescence methods (DIAGNOdent Pen and VistaCam iX) in detecting occlusal caries lesions in permanent teeth using cone beam computed tomography (CBCT) as a reference test.One hundred-sixty molars and premolars were qualified for the study. The visual, the DIAGNOdent Pen and VistaCam iX examinations were carried out by two examiners. The actual extent of the lesions was determined using CBCT. For the three methods, inter- and intra-examiner reproducibility was calculated using intraclass correlation coefficient. The sensitivity, specificity, and accuracy of these methods were compared using the mid-P McNemar test. The level of significance was set at p 0.05.For all data, intraclass-correlation coefficients (ICC) for intra- and inter-examiner reproducibility were high. With regard to the enamel threshold, the sensitivity and accuracy were significantly higher for VistaCam iX and ICDAS II compared with the DIAGNOdent Pen (p 0.05). The results obtained with the DIAGNOdentu Pen indicated significantly higher specificity values for the enamel threshold (p 0.05). The results obtained with the VistaCam iX showed the lowest sensitivity but the significantly highest specificity and accuracy for the dentin threshold (p 0.05).The ICDAS II is an effective method for detecting early carious lesions, characterized by a higher sensitivity compared with devices using fluorescence. To improve the diagnostic efficiency of the evaluated devices, modifying the cut-off values recommended by the manufacturers should be considered.

The aim of this study is to assess the extent of early carious lesions using the International Caries Detection and Assessment System (ICDAS) II and DIAGNOdent pen compared with microCT examination. Forty-eight molars and premolars were qualified for the study. The visual and the DIAGNOdent pen device examinations were carried out by two examiners. The actual extent of the lesions was determined using micro-CT examination. The optimal cutoff test value was determined using the Youden index. For the two methods, inter- and intra-examiner reproducibility was calculated using intraclass correlation coefficient. The sensitivity, specificity, and accuracy of these methods were compared using the mid-P McNemar test. The level of significance was set at p

It has been documented that total removal of carious dentin, assessed according to clinical criteria, does not mean complete eradication of bacteria. For that reason in prevention of caries and pulp inflammations, application of the materials having high antibacterial properties seems to be indispensable.Determination of antibacterial activities of two white Mineral Trioxide Aggregate (MTA) preparations against bacteria of the genus Streptococcus.Antibacterial activities of the materials were determined by diffusion method on a solid tryptic-soy medium (Tryptic Soy Agar, Oxoid). Wells were prepared on the medium with a puncher of 7 mm diameter and 5 mm depth (four for each material). The bottom was poured with 10 microlitres of liquid TSA for sealing. Bacterial suspension was inoculated with cotton swabs onto the medium surface and then the wells were filled with the materials prepared ex tempore. The plates were left in room temperature for 30 minutes and incubated at 37 degrees C for 24 h. Results were read by measuring the inhibition zones on day 1, 2, 3 and 8 of the culture.All the study samples demonstrated inhibition of bacteria of the genus Streptococcus. The antibacterial effect of MTA was maintained till the end of the experiment (day 8). ProRoot White showed slightly larger inhibition zone against Streptococcus salivarius and Streptococcus sanguis as compared to MTA white Angelus. The mean inhibition zones against Streptococcus mutans appeared the same for both test materials.The two MTA preparations assessed in the current study show good antibacterial action against the standard strains Streptococcus mutans, Streptococcus sanguis and Streptococcus salivarius.

Introduction The aim of the paper was to determine the antibacterial activity of four glass ionomer cements against bacteria of the genera Streptococcus and Lactobacillus. Material and methods Four capsulated glass ionomer cements were applied in the study: Fuji Triage (GC), Fuji IX (GC), Ketac Molar (3M Espe) and Ketac Silver (3M Espe). Four standard bacterial strains were used to assess the antibacterial activity of the studied cements: Streptococcus mutans, S. sanguis, S. salivarius and Lactobacillus casei. The antibacterial activity was determined by the agar diffusion method. The bacterial suspension was spread with a cotton swab on TSA plates. For each material six wells (7 mm diameter, 5 mm deep) were made with a cork borer. Each well was then filled with freshly prepared cements. The results were obtained by measuring the bacterial growth inhibition zone after 1, 2, 3 and 7 days. Results Fuji Triage cement inhibited the growth of all bacterial strains. Fuji IX cement demonstrated the most potent antibacterial activity against S. sanguis. Ketac Molar showed antibacterial activity against S. sanguis and S. salivarius, whereas Ketac Silver was efficient against S. mutans as well. Neither of the Ketac cements inhibited growth of the standard L. casei strain. Discussion Antibacterial activity of glass ionomer cements has attracted the interest of scientists in recent years. Most authors, including us, carried out experiments using the agar diffusion method and demonstrated antibacterial activity of glass ionomer cements. Different antibacterial activity of glass ionomer cements, observed in our study and studies of other authors, depended on the evaluated cement, bacterial strain and period of evaluation.