Search

Bifacial crystalline silicon (c-Si) solar cells have currently attracted much attention due to the front high-efficiency and additional gain of power generation from the back side. Here, we have presented n-type passivated emitter and rear totally-diffused (n-PERT) bifacial c-Si solar cells featuring front selective emitter (SE) and polysilicon (poly-Si) based passivating contacts. The SE formation was scanned with laser doping based on front boron-diffusion p+ emitter. The poly-Si based passivating contacts consisting of nano-layer SiOx of ~1.5 nm thickness grown with cost-effective nitric acid oxidation and phosphorus-doped polysilicon exhibited excellent passivation for high open-circuit voltage. We have successfully achieved the large-area (156 × 156 mm2) n-PERT bifacial solar cells yielding top efficiency of 21.15%, together with a promising short-circuit current density of 40.40 mA/cm2. Theoretical calculation has further demonstrated that the optimal thickness of SiOx nano-layer will increase from 1.5 nm to 1.8 nm if the density of interface defect state decreases by one magnitude from 1 × 1010 cm−2/eV, and the cell efficiency can be improved up to 24.64% with open-circuit voltage over 0.720 V by optimizing the parameters of functional materials and interface layers. The present work has indicated that the commercialization of low-cost and high-efficiency n-PERT bifacial c-Si cells is possible due to the processes compatible with existing production lines.

RNA-Seq has been increasingly used for the quantification and characterization of transcriptomes. The ongoing development of the technology promises the more accurate measurement of gene expression. However, its benefits over widely accepted microarray technologies have not been adequately assessed, especially in toxicogenomics studies. The goal of this study is to enhance the scientific community's understanding of the advantages and challenges of RNA-Seq in the quantification of gene expression by comparing analysis results from RNA-Seq and microarray data on a toxicogenomics study. A typical toxicogenomics study design was used to compare the performance of an RNA-Seq approach (Illumina Genome Analyzer II) to a microarray-based approach (Affymetrix Rat Genome 230 2.0 arrays) for detecting differentially expressed genes (DEGs) in the kidneys of rats treated with aristolochic acid (AA), a carcinogenic and nephrotoxic chemical most notably used for weight loss. We studied the comparability of the RNA-Seq and microarray data in terms of absolute gene expression, gene expression patterns, differentially expressed genes, and biological interpretation. We found that RNA-Seq was more sensitive in detecting genes with low expression levels, while similar gene expression patterns were observed for both platforms. Moreover, although the overlap of the DEGs was only 40-50%, the biological interpretation was largely consistent between the RNA-Seq and microarray data. RNA-Seq maintained a consistent biological interpretation with time-tested microarray platforms while generating more sensitive results. However, there is clearly a need for future investigations to better understand the advantages and limitations of RNA-Seq in toxicogenomics studies and environmental health research.

The primary testing strategy to identify nongenotoxic carcinogens largely relies on the 2-year rodent bioassay, which is time-consuming and labor-intensive. There is an increasing effort to develop alternative approaches to prioritize the chemicals for, supplement, or even replace the cancer bioassay. In silico approaches based on quantitative structure-activity relationships (QSAR) are rapid and inexpensive and thus have been investigated for such purposes. A slightly more expensive approach based on short-term animal studies with toxicogenomics (TGx) represents another attractive option for this application. Thus, the primary questions are how much better predictive performance using short-term TGx models can be achieved compared to that of QSAR models, and what length of exposure is sufficient for high quality prediction based on TGx. In this study, we developed predictive models for rodent liver carcinogenicity using gene expression data generated from short-term animal models at different time points and QSAR. The study was focused on the prediction of nongenotoxic carcinogenicity since the genotoxic chemicals can be inexpensively removed from further development using various in vitro assays individually or in combination. We identified 62 chemicals whose hepatocarcinogenic potential was available from the National Center for Toxicological Research liver cancer database (NCTRlcdb). The gene expression profiles of liver tissue obtained from rats treated with these chemicals at different time points (1 day, 3 days, and 5 days) are available from the Gene Expression Omnibus (GEO) database. Both TGx and QSAR models were developed on the basis of the same set of chemicals using the same modeling approach, a nearest-centroid method with a minimum redundancy and maximum relevancy-based feature selection with performance assessed using compound-based 5-fold cross-validation. We found that the TGx models outperformed QSAR in every aspect of modeling. For example, the TGx models' predictive accuracy (0.77, 0.77, and 0.82 for the 1-day, 3-day, and 5-day models, respectively) was much higher for an independent validation set than that of a QSAR model (0.55). Permutation tests confirmed the statistical significance of the model's prediction performance. The study concluded that a short-term 5-day TGx animal model holds the potential to predict nongenotoxic hepatocarcinogenicity.

A genetic association study is a complicated process that involves collecting phenotypic data, generating genotypic data, analyzing associations between genotypic and phenotypic data, and interpreting genetic biomarkers identified. SNPTrack is an integrated bioinformatics system developed by the US Food and Drug Administration (FDA) to support the review and analysis of pharmacogenetics data resulting from FDA research or submitted by sponsors. The system integrates data management, analysis, and interpretation in a single platform for genetic association studies. Specifically, it stores genotyping data and single-nucleotide polymorphism (SNP) annotations along with study design data in an Oracle database. It also integrates popular genetic analysis tools, such as PLINK and Haploview. SNPTrack provides genetic analysis capabilities and captures analysis results in its database as SNP lists that can be cross-linked for biological interpretation to gene/protein annotations, Gene Ontology, and pathway analysis data. With SNPTrack, users can do the entire stream of bioinformatics jobs for genetic association studies. SNPTrack is freely available to the public at http://www.fda.gov/ScienceResearch/BioinformaticsTools/SNPTrack/default.htm.

Drug-induced liver injury (DILI) is a significant concern in drug development due to the poor concordance between preclinical and clinical findings of liver toxicity. We hypothesized that the DILI types (hepatotoxic side effects) seen in the clinic can be translated into the development of predictive in silico models for use in the drug discovery phase. We identified 13 hepatotoxic side effects with high accuracy for classifying marketed drugs for their DILI potential. We then developed in silico predictive models for each of these 13 side effects, which were further combined to construct a DILI prediction system (DILIps). The DILIps yielded 60–70% prediction accuracy for three independent validation sets. To enhance the confidence for identification of drugs that cause severe DILI in humans, the “Rule of Three” was developed in DILIps by using a consensus strategy based on 13 models. This gave high positive predictive value (91%) when applied to an external dataset containing 206 drugs from three independent literature datasets. Using the DILIps, we screened all the drugs in DrugBank and investigated their DILI potential in terms of protein targets and therapeutic categories through network modeling. We demonstrated that two therapeutic categories, anti-infectives for systemic use and musculoskeletal system drugs, were enriched for DILI, which is consistent with current knowledge. We also identified protein targets and pathways that are related to drugs that cause DILI by using pathway analysis and co-occurrence text mining. While marketed drugs were the focus of this study, the DILIps has a potential as an evaluation tool to screen and prioritize new drug candidates or chemicals, such as environmental chemicals, to avoid those that might cause liver toxicity. We expect that the methodology can be also applied to other drug safety endpoints, such as renal or cardiovascular toxicity., Author Summary Translational research involves utilization of clinical data to address challenges in drug discovery and development. The rationale behind this study is that the side effects observed in clinical trial and post-marketing surveillance can be translated into a screening system for use in drug discovery. As a proof-of-concept study, we developed an in silico system based on 13 hepatotoxic side effects to predict drug-induced liver injury (DILI), which is one of the most frequent causes of drug failure in clinical trial and withdrawal from post-marketing application, and also one of the most difficult clinical endpoints to predict from preclinical studies. We first identified 13 types of liver injury which yielded high prediction accuracy to distinguish drugs known to cause DILI from these don't. To effectively apply these 13 hepatotoxic side effects to the drug discovery process for DILI, we developed in silico models for each of these side effects solely based on chemical structure data. Finally, we constructed a DILI prediction system (DILIps) by combining these 13 in silico models in a consensus fashion, which yielded >91% positive predictive value for DILI in humans. The DILIps methodology can be extended in applications for addressing other drug safety issues, such as renal and cardiovascular toxicity.

Background Advances in microbial genomics and bioinformatics are offering greater insights into the emergence and spread of foodborne pathogens in outbreak scenarios. The Food and Drug Administration (FDA) has developed a genomics tool, ArrayTrackTM, which provides extensive functionalities to manage, analyze, and interpret genomic data for mammalian species. ArrayTrackTM has been widely adopted by the research community and used for pharmacogenomics data review in the FDA’s Voluntary Genomics Data Submission program. Results ArrayTrackTM has been extended to manage and analyze genomics data from bacterial pathogens of human, animal, and food origin. It was populated with bioinformatics data from public databases such as NCBI, Swiss-Prot, KEGG Pathway, and Gene Ontology to facilitate pathogen detection and characterization. ArrayTrackTM’s data processing and visualization tools were enhanced with analysis capabilities designed specifically for microbial genomics including flag-based hierarchical clustering analysis (HCA), flag concordance heat maps, and mixed scatter plots. These specific functionalities were evaluated on data generated from a custom Affymetrix array (FDA-ECSG) previously developed within the FDA. The FDA-ECSG array represents 32 complete genomes of Escherichia coli and Shigella. The new functions were also used to analyze microarray data focusing on antimicrobial resistance genes from Salmonella isolates in a poultry production environment using a universal antimicrobial resistance microarray developed by the United States Department of Agriculture (USDA). Conclusion The application of ArrayTrackTM to different microarray platforms demonstrates its utility in microbial genomics research, and thus will improve the capabilities of the FDA to rapidly identify foodborne bacteria and their genetic traits (e.g., antimicrobial resistance, virulence, etc.) during outbreak investigations. ArrayTrackTM is free to use and available to public, private, and academic researchers at http://www.fda.gov/ArrayTrack.

Background Endocrine disruptors (EDs) and their broad range of potential adverse effects in humans and other animals have been a concern for nearly two decades. Many putative EDs are widely used in commercial products regulated by the Food and Drug Administration (FDA) such as food packaging materials, ingredients of cosmetics, medical and dental devices, and drugs. The Endocrine Disruptor Knowledge Base (EDKB) project was initiated in the mid 1990’s by the FDA as a resource for the study of EDs. The EDKB database, a component of the project, contains data across multiple assay types for chemicals across a broad structural diversity. This paper demonstrates the utility of EDKB database, an integral part of the EDKB project, for understanding and prioritizing EDs for testing. Results The EDKB database currently contains 3,257 records of over 1,800 EDs from different assays including estrogen receptor binding, androgen receptor binding, uterotropic activity, cell proliferation, and reporter gene assays. Information for each compound such as chemical structure, assay type, potency, etc. is organized to enable efficient searching. A user-friendly interface provides rapid navigation, Boolean searches on EDs, and both spreadsheet and graphical displays for viewing results. The search engine implemented in the EDKB database enables searching by one or more of the following fields: chemical structure (including exact search and similarity search), name, molecular formula, CAS registration number, experiment source, molecular weight, etc. The data can be cross-linked to other publicly available and related databases including TOXNET, Cactus, ChemIDplus, ChemACX, Chem Finder, and NCI DTP. Conclusion The EDKB database enables scientists and regulatory reviewers to quickly access ED data from multiple assays for specific or similar compounds. The data have been used to categorize chemicals according to potential risks for endocrine activity, thus providing a basis for prioritizing chemicals for more definitive but expensive testing. The EDKB database is publicly available and can be found online at http://edkb.fda.gov/webstart/edkb/index.html. Disclaimer:The views presented in this article do not necessarily reflect those of the US Food and Drug Administration.

Background Protein-protein interactions (PPIs) are a critical component for many underlying biological processes. A PPI network can provide insight into the mechanisms of these processes, as well as the relationships among different proteins and toxicants that are potentially involved in the processes. There are many PPI databases publicly available, each with a specific focus. The challenge is how to effectively combine their contents to generate a robust and biologically relevant PPI network. Methods In this study, seven public PPI databases, BioGRID, DIP, HPRD, IntAct, MINT, REACTOME, and SPIKE, were used to explore a powerful approach to combine multiple PPI databases for an integrated PPI network. We developed a novel method called k-votes to create seven different integrated networks by using values of k ranging from 1-7. Functional modules were mined by using SCAN, a Structural Clustering Algorithm for Networks. Overall module qualities were evaluated for each integrated network using the following statistical and biological measures: (1) modularity, (2) similarity-based modularity, (3) clustering score, and (4) enrichment. Results Each integrated human PPI network was constructed based on the number of votes (k) for a particular interaction from the committee of the original seven PPI databases. The performance of functional modules obtained by SCAN from each integrated network was evaluated. The optimal value for k was determined by the functional module analysis. Our results demonstrate that the k-votes method outperforms the traditional union approach in terms of both statistical significance and biological meaning. The best network is achieved at k=2, which is composed of interactions that are confirmed in at least two PPI databases. In contrast, the traditional union approach yields an integrated network that consists of all interactions of seven PPI databases, which might be subject to high false positives. Conclusions We determined that the k-votes method for constructing a robust PPI network by integrating multiple public databases outperforms previously reported approaches and that a value of k=2 provides the best results. The developed strategies for combining databases show promise in the advancement of network construction and modeling.