Search

Two versions of an electrically powered device (Rotorinser) to sample carcasses or other surfaces in situ for microbiological analysis and several different sampling protocols were evaluated against excision plus stomaching for ability to remove bacteria from pig skin and beef carcass tissue. Both devices sampled circular areas of approximately 14 cm 2 . Ten tissue samples were used for each set of conditions. Rotorinser bacterial removal efficiency was calculated as R/(R + S), where R is the Rotorinser count (CFU cm -2 ) and S is the count on stomached excised tissue after rotorinsing. Stomacher efficiencies were calculated as S1/(S1 + S2), where S1 is the first stomacher count of excised tissue and S2 is the count from a second stomaching. Both Rotorinsers were much better than traditional swabs. Rotorinser 1 gave removal efficiencies of 0.79 to 0.88 for beef, and 0.79 to 0.95 for pork. Prewetting surfaces for 5 min improved removal, but mixtures of enzymes did not. Rotorinser 2 applied with NaCl or NaCl-Tween 80 diluent for either 30 or 60 s was significantly better (0.93 and 0.98) than the stomacher (0.86) at removing aerobic mesophilic bacteria from pork skin. The Rotorinser causes negligible tissue damage and can be used on surfaces at any angle.

A thermometric device unequivocably showed whether samples complied with a standard, to a resolution better than 0.002 a w units, without calibration, and with a throughput of one sample per 6 min. As a meter its response was linear from a w = 0.78 (the lowest value tested) to 1.00. It exhibited no hysteresis and was immune to drift resulting from high humidities or contamination by nonaqueous volatiles from foods.

Bacterial counts obtained on hydrophobic grid-membrane filters were comparable to conventional plate counts for Pseudomonas aeruginosa, Escherichia coli, and Staphylococcus aureus in homogenates from a range of foods. The wide numerical operating range of the hydrophobic grid-membrane filters allowed sequential diluting to be reduced or even eliminated, making them attractive as components in automated systems of analysis. Food debris could be rinsed completely from the unincubated hydrophobic grid-membrane filter surface without affecting the subsequent count, thus eliminating the possibility of counting food particles, a common source of error in electronic counting systems.

A device to facilitate manual scoring of hydrophobic grid-membrane filters (HGMF) is described. Variations in scores were generally less than 2.5% between 41 analysts from six laboratories, who, using the apparatus, scored a set of five specimen HGMF in different ways, and there was good agreement between scores from positive and negative grid-cell counts by each analyst. A scoring procedure for use in routine microbiological analysis, suitable for HGMF at various degrees of saturation, is recommended.