Search

Air curtains (ACs) are plane turbulent impinging jets that are used to separate two environments in terms of heat and mass transfer while still allowing traffic between these environments. The many applications of ACs across a wide variety of industries makes the evaluation of their performance an important but difficult task. The aim of this paper is to introduce a performance indicator, called the adapted separation efficiency, that is suitable for different types of systems that may involve different AC configurations (downward blowing, upward blowing, lateral blowing, multiple jets, etc.) at multiple scales, different transported quantities (heat, water vapor, particles, gases, etc.) subjected to various transport mechanisms (advection, molecular and turbulent diffusion) and varying environmental conditions (gradients in environmental pressure and/or density). It is defined using a conventional efficiency formula. The principle of this performance indicator is illustrated with a generic case study where the performance is evaluated for two basic AC configurations involving cross-jet pressure and density gradients, as well as different jet momentum fluxes. The case study is conducted based on computational fluid dynamics employing validated large eddy simulations.

This paper presents a numerical study on the required momentum flux ratio to prevent air curtain breakthrough in case of cross-curtain (i.e. cross-jet) pressure gradients. 2D steady Reynolds-averaged Navier-Stokes (RANS) CFD simulations with the RNG k-ε turbulence model are employed for jet Reynolds numbers ranging from 5,000 to 30,000. First, the computational model is validated based on particle image velocimetry (PIV) measurements. Second, the influence of several jet parameters on the separation efficiency is evaluated for a moderate cross-jet pressure difference of 10 Pa. These are the ratio of the jet discharge momentum flux to the jet cross-flow momentum flux (momentum flux ratio), the jet height-to-width ratio and the jet discharge angle. Finally, the minimum deflection modulus to prevent jet breakthrough and the corresponding momentum flux ratio by an analytical equation and by CFD are compared. The results show that, for the configuration under study: (1) jets with the smallest height-to-width ratios (β = 18) provide the highest separation efficiency; (2) inclined jets with discharge angles α0 = 5° and 10° provide slightly higher separation efficiency than straight jets (α0 = 0°) and jets with α0 = 20°; (3) the maximum modified separation efficiency is reached at lower momentum flux ratios for jets with smaller height-to-width ratios and for inclined jets; (4) the analytical and CFD values of the optimal momentum flux ratio differ with up to 31.2%. This study shows how the separation efficiency of air curtains can be improved by adjusting certain jet parameters.

On-site renewable energy generation in the built environment can be achieved by incorporating wind turbines in the integral design of buildings. Passages through buildings are considered promising to strengthen the local wind resource availability but information concerning their design and performance is scarce. Therefore, two key design parameters that can enhance the wind energy performance of ducted openings in high-rise buildings are addressed and optimized via CFD simulations: the fillet radius (r) of the opening and the duct diameter (d0). 3D steady RANS simulations are performed and validated with wind tunnel data from the literature. Fillets are shown to suppress flow separation, thereby enhancing the magnitude and uniformity of the wind speed in the duct and reducing the turbulent kinetic energy. With a reference diameter d0 = D, the best-performing configuration has a normalized fillet radius r/d0 = 0.2, which increases the average wind speed in the duct by 65% and the wind power by 354%. Modifying the duct diameter alone has limited influence. However, combining a larger duct diameter d0 = 1.5D with fillets with r/d0 = 0.4, can yield up to 78% increase in average wind speed and 650% in wind power density. Findings indicate that the dimensionless wind speed in the duct (U/U0) scales closely in proportion to the normalized fillet radius (r/d0). With these results, the present study demonstrates the aerodynamic advantage of ducted openings in buildings and identifies relevant design conditions required to improve the wind resource availability for the prospective implementation of wind turbines.