Search

Considering the growing interest in magnetic materials for unconventional computing, data storage, and sensor applications, there is active research not only on material synthesis but also characterisation of their properties. In addition to structural and integral magnetic characterisations, imaging of magnetization patterns, current distributions and magnetic fields at nano- and microscale is of major importance to understand the material responses and qualify them for specific applications. In this roadmap, we aim to cover a broad portfolio of techniques to perform nano- and microscale magnetic imaging using SQUIDs, spin center and Hall effect magnetometries, scanning probe microscopies, x-ray- and electron-based methods as well as magnetooptics and nanoMRI. The roadmap is aimed as a single access point of information for experts in the field as well as the young generation of students outlining prospects of the development of magnetic imaging technologies for the upcoming decade with a focus on physics, materials science, and chemistry of planar, 3D and geometrically curved objects of different material classes including 2D materials, complex oxides, semi-metals, multiferroics, skyrmions, antiferromagnets, frustrated magnets, magnetic molecules/nanoparticles, ionic conductors, superconductors, spintronic and spinorbitronic materials.

The magnetic and electronic nature of the gamma-Al2O3/SrTiO3 spinel/perovskite interface is explored by means of x-ray absorption spectroscopy. Polarized x-ray techniques combined with atomic multiplet calculations reveal localized magnetic moments assigned to Ti3+ at the interface with equivalent size for in- and out-of-plane magnetic field directions. Although magnetic fingerprints are revealed, the Ti3+ magnetism can be explained by a paramagnetic response at low temperature under applied magnetic fields. Modeling the x-ray linear dichroism results in a delta0 = 1.9 eV splitting between the t2g and eg states for the Ti4+ 3d0 orbitals. In addition these results indicate that the lowest energy states have the out-of-plane dxz/dyz symmetry. The isotropic magnetic moment behavior and the lowest energy dxz/dyz states are in contrast to the observations for the two-dimensional electron gas at the perovskite/perovskite interface of LaAlO3/SrTiO3, that exhibits an anisotropic magnetic dxy ground state., Comment: 6 pages, 5 figures

Herein, we reported giant tunability of the physical properties of 2DEGs at the spinel/perovskite interface of {\gamma}-Al2O3/SrTiO3 (GAO/STO). By modulating the carrier density thus the band filling with ionic-liquid gating, the system experiences a Lifshitz transition at a critical carrier density of 3E13 cm-2, where a remarkably strong enhancement of Rashba spin-orbit interaction and an emergence of Kondo effect at low temperatures are observed. Moreover, as the carrier concentration depletes with decreasing gating voltage, the electron mobility is enhanced by more than 6 times in magnitude, leading to the observation of clear quantum oscillations. The great tunability of GAO/STO interface by EDLT gating not only shows promise for design of oxide devices with on-demand properties, but also sheds new light on the electronic structure of 2DEG at the non-isostructural spinel/perovskite interface., Comment: Nano Letters 2017

The spinel/perovskite heterointerface $\gamma$-Al$_2$O$_3$/SrTiO$_3$ hosts a two-dimensional electron system (2DES) with electron mobilities exceeding those in its all-perovskite counterpart LaAlO$_3$/SrTiO$_3$ by more than an order of magnitude despite the abundance of oxygen vacancies which act as electron donors as well as scattering sites. By means of resonant soft x-ray photoemission spectroscopy and \textit{ab initio} calculations we reveal the presence of a sharply localized type of oxygen vacancies at the very interface due to the local breaking of the perovskite symmetry. We explain the extraordinarily high mobilities by reduced scattering resulting from the preferential formation of interfacial oxygen vacancies and spatial separation of the resulting 2DES in deeper SrTiO$_3$ layers. Our findings comply with transport studies and pave the way towards defect engineering at interfaces of oxides with different crystal structures., Comment: Accepted as Rapid Communications in Physical Review B

The two-dimensional electron gas (2DEG) at the non-isostructural interface between spinel gamma-Al2O3 and perovskite SrTiO3 is featured by a record electron mobility among complex oxide interfaces in addition to a high carrier density up to the order of 1E15 cm-2. Herein, we report on the patterning of 2DEG at the gamma-Al2O3/SrTiO3 interface grown at 650 {\deg}C by pulsed laser deposition using a hard mask of LaMnO3. The patterned 2DEG exhibits a critical thickness of 2 unit cells of gamma-Al2O3 for the occurrence of interface conductivity, similar to the unpatterned sample. However, its maximum carrier density is found to be approximately 3E13 cm-2, much lower than that of the unpatterned sample (1E15 cm-2). Remarkably, a high electron mobility of approximately 3,600 cm2V-1s-1 was obtained at low temperatures for the patterned 2DEG at a carrier density of 7E12 cm-2, which exhibits clear Shubnikov-de Hass quantum oscillations. The patterned high-mobility 2DEG at the gamma-Al2O3/SrTiO3 interface paves the way for the design and application of spinel/perovskite interfaces for high-mobility all-oxide electronic devices., Comment: 4 figures

Metallic LaAlO$_3$/SrTiO$_3$ (LAO/STO) interfaces attract enormous attention, but the relationship between the electron mobility and the sheet electron density, $n_s$, is poorly understood. Here we derive a simple expression for the three-dimensional electron density near the interface, $n_{3D}$, as a function of $n_s$ and find that the mobility for LAO/STO-based interfaces depends on $n_{3D}$ in the same way as it does for bulk doped STO. It is known that undoped bulk STO is strongly compensated with $N \simeq 5 \times 10^{18}~\rm{cm^{-3}}$ background donors and acceptors. In intentionally doped bulk STO with a concentration of electrons $n_{3D} < N$ background impurities determine the electron scattering. Thus, when $n_{3D} < N$ it is natural to see in LAO/STO the same mobility as in the bulk. On the other hand, in the bulk samples with $n_{3D} > N$ the mobility collapses because scattering happens on $n_{3D}$ intentionally introduced donors. For LAO/STO the polar catastrophe which provides electrons is not supposed to provide equal number of random donors and thus the mobility should be larger. The fact that the mobility is still the same implies that for the LAO/STO the polar catastrophe model should be revisited., Comment: 4 pages and 1 figure

Modulation-doped oxide two-dimensional electron gas (2DEG) formed at the LaMnO3 (LMO) buffered disorderd-LaAlO3/SrTiO3 (d-LAO/LMO/STO) heterointerface, provides new opportunities for electronics as well as quantum physics. Herein, we studied the dependence of Sr-doping of La1-xSrxMnO3 (LSMO, x=0, 1/8, 1/3, 1/2, and 1) thus the filling of the Mn eg subbands as well as the LSMO polarity on the transport properties of d-LAO/LSMO/STO. Upon increasing the LSMO film thickness from 1 unit cell (uc) to 2 uc, a sharp metal to insulator transition of interface conduction was observed, independent of x. The resultant electron mobility is often higher than 1900 cm2V-1s-1 at 2 K, which increases upon decreasing x. The sheet carrier density, on the other hand, is in the range of 6.9E1012~1.8E1013 cm-2 (0.01~0.03 e/uc) and is largely independent on x for all the metallic d-LAO/LSMO (1 uc)/STO interfaces. These results are consistent with the charge transfer induced modulation doping scheme and clarify that the polarity of the buffer layer plays a trivial role on the modulation doping. The negligible tunability of the carrier density could result from the reduction of LSMO during the deposition of disordered LAO or that the energy levels of Mn 3d electrons at the interface of LSMO/STO are hardly varied even when changing the LSMO composition from LMO to SrMnO3., Comment: 14 pages, 4 figures, to be published in JAP, March 2017

The discovery of two-dimensional electron gases (2DEGs) at the interface between two insulating complex oxides, such as LaAlO3 (LAO) or gamma-Al2O3 (GAO) epitaxially grown on SrTiO3 (STO) 1,2, provides an opportunity for developing all-oxide electronic devices3,4. These 2DEGs at complex oxide interfaces involve many-body interactions and give rise to a rich set of phenomena5, for example, superconductivity6, magnetism7,8, tunable metal-insulator transitions9, and phase separation10. However, large enhancement of the interfacial electron mobility remains a major and long-standing challenge for fundamental as well as applied research of complex oxides11-15. Here, we inserted a single unit cell insulating layer of polar La1-xSrxMnO3 (x=0, 1/8, and 1/3) at the interface between disordered LaAlO3 and crystalline SrTiO3 created at room temperature. We find that the electron mobility of the interfacial 2DEG is enhanced by more than two orders of magnitude. Our in-situ and resonant x-ray spectroscopic in addition to transmission electron microscopy results indicate that the manganite layer undergoes unambiguous electronic reconstruction and leads to modulation doping of such atomically engineered complex oxide heterointerfaces. At low temperatures, the modulation-doped 2DEG exhibits clear Shubnikov-de Haas oscillations and the initial manifestation of the quantum Hall effect, demonstrating an unprecedented high-mobility and low electron density oxide 2DEG system. These findings open new avenues for oxide electronics., Comment: 29 pages, 5 figures, Accepted for publication in Nature Materials

A magnet designed for use in a magnetic refrigeration device is presented. The magnet is designed by applying two general schemes for improving a magnet design to a concentric Halbach cylinder magnet design and dimensioning and segmenting this design in an optimum way followed by the construction of the actual magnet. The final design generates a peak value of 1.24 T, an average flux density of 0.9 T in a volume of 2 L using only 7.3 L of magnet, and has an average low flux density of 0.08 T also in a 2 L volume. The working point of all the permanent magnet blocks in the design is very close to the maximum energy density. The final design is characterized in terms of a performance parameter, and it is shown that it is one of the best performing magnet designs published for magnetic refrigeration., Comment: 6 pages, 6 figures

A 3D thermoelectric numerical model is used to investigate different internal heat loss mechanisms for a thermoelectric generator with bismuth telluride p- and n-legs. The model considers all thermoelectric effects, temperature dependent material parameters and simultaneous convective, conductive and radiative heat losses, including surface to surface radiation. For radiative heat losses it is shown that for the temperatures considered here, surface to ambient radiation is a good approximation of the heat loss. For conductive heat transfer the module efficiency is shown to be comparable to the case of radiative losses. Finally, heat losses due to internal natural convection in the module is shown to be negligible for the millimetre sized modules considered here. The combined case of radiative and conductive heat transfer resulted in the lowest efficiency. The optimized load resistance is found to decrease for increased heat loss. The leg dimensions are varied for all heat losses cases and it is shown that the ideal way to construct a TEG module with minimal heat losses and maximum efficiency is to either use a good insulating material between the legs or evacuate the module completely, and use small and wide legs closely spaced., Comment: 11 pages, 9 figures

The discovery of two-dimensional electron gases (2DEGs) at the heterointerface between two insulating perovskite-type oxides, such as LaAlO3 and SrTiO3, provides opportunities for a new generation of all-oxide electronic and photonic devices. However, significant improvement of the interfacial electron mobility beyond the current value of approximately 1,000 cm2V-1s-1 (at low temperatures), remains a key challenge for fundamental as well as applied research of complex oxides. Here, we present a new type of 2DEG created at the heterointerface between SrTiO3 and a spinel {\gamma}-Al2O3 epitaxial film with excellent quality and compatible oxygen ions sublattices. This spinel/perovskite oxide heterointerface exhibits electron mobilities more than one order of magnitude higher than those of perovskite/perovskite oxide interfaces, and demonstrates unambiguous two-dimensional conduction character as revealed by the observation of quantum magnetoresistance oscillations. Furthermore, we find that the spinel/perovskite 2DEG results from interface-stabilized oxygen vacancies and is confined within a layer of 0.9 nm in proximity to the heterointerface. Our findings pave the way for studies of mesoscopic physics with complex oxides and design of high-mobility all-oxide electronic devices., Comment: 25pages, 5 figures

We report a comprehensive 77Se NMR study of the structural, magnetic, and superconducting properties of a single crystalline sample of the newly discovered FeSe-based high temperature superconductor K(x)Fe(2-y)Se(2) (Tc=33K) in a broad temperature range up to 290 K. We will compare our results with those reported for FeSe (Tc=9K) and FeAs-based high Tc systems., Comment: Final version

We discuss using a table-top ion interferometer to search for deviations from Coulomb's inverse-square law. Such deviations would result from non-classical effects such at a non-zero photon rest mass. We discuss the theory behind the proposed measurement, explain which fundamental, experimentally controllable parameters are the relevant figures of merit, and calculate the expected performance of such a device in terms of these parameters. The sensitivity to deviations in the exponent of the inverse-square law is predicted to be a few times $10^{-22}$, an improvement by five orders of magnitude over current experiments. It could measure a non-zero photon rest mass smaller than $9\times10^{-50}$ grams, nearly 100 times smaller than current laboratory experiments., Comment: 4 pages, 2 figures