Search

Abstract We present MATRIX‐VBS, a new aerosol scheme that simulates organic partitioning in an aerosol microphysics model, as part of the NASA GISS ModelE Earth System Model. MATRIX‐VBS builds on its predecessor aerosol microphysics model MATRIX (Bauer et al., 2008, https://doi.org/10.5194/acp‐8‐6003‐2008) and was developed in the box model framework (Gao et al., 2017, https://doi.org/10.5194/gmd‐10‐751‐2017). The scheme features the inclusion of organic partitioning between the gas and particle phases and the photochemical aging process using the volatility‐basis set (Donahue et al., 2006, https://doi.org/10.1021/es052297c). To assess the performance of the new model, we compared its mass concentration, number concentration, and activated number concentration to the original scheme MATRIX, and evaluated its mass concentrations in four seasons against data from the NASA Atmospheric Tomography Mission (ATom) aircraft campaign. Results from MATRIX‐VBS show that organics are transported further away from their source, and their mass concentration increases aloft and decreases at the surface compared to those in MATRIX. The mass concentration of organics at the surface agrees well with measurements, and there are discrepancies for vertical profiles aloft. In the new scheme, the global mass load of organic aerosols increased by 50%, there is also an increased number of particles at the surface and fewer activated ones in most regions. The new scheme presents advanced and more comprehensive capability in simulating aerosol processes.

Abstract This study investigated two random forest (RF) models for the non‐iterative parametrization of surface‐layer turbulent fluxes: (a) the RF scheme, a calculation model that is directly trained using correlated variables, and (b) the RF_Li10 scheme, a random forest correction model based on the Li10 scheme (Li et al., 2010, https://doi.org/10.1007/s10546-010-9523-y). A comparison between these two new models and the Li10 scheme against an iterative scheme revealed the hierarchy of maximum relative errors in estimating stability parameters, as well as momentum and heat transfer coefficients. This hierarchy is as follows: the Li10 scheme is the greatest, followed by the RF scheme, with the RF_Li10 scheme exhibiting the least errors.

Weather radars play a crucial role in the monitoring of severe convective weather. However, due to their limited detection range, they cannot conduct an effective monitoring in remote offshore areas. Therefore, this paper utilized UNet++ to establish a model for retrieving radar composite reflectivity based on Himawari-9 satellite datasets. In the process of comparative analysis, we found that both satellite and radar data exhibited significant diurnal cycles, but there were notable differences in their variation characteristics. To address this, we established four comparative models to test the influence of latitude and diurnal cycles on the inversion results. The results showed that adding the distribution map of the minimum brightness temperature at the corresponding time in the model could effectively improve the model’s performance in both spatial and temporal dimensions, reduce the root-mean-square error (RMSE) of the model, and enhance the accuracy of severe convective weather monitoring.

Abstract Stratospheric injections of sulfur dioxide from major volcanic eruptions perturb the Earth's global radiative balance and dominate variability in stratospheric sulfur loading. The atmospheric component of the GFDL Earth System Model (ESM4.1) uses a bulk aerosol scheme and previously prescribed the distribution of aerosol optical properties in the stratosphere. To quantify volcanic contributions to the stratospheric sulfur cycle and the resulting climate impact, we modified ESM4.1 to simulate stratospheric sulfate aerosols prognostically. Driven by explicit volcanic emissions of aerosol precursors and non‐volcanic sources, we conduct ESM4.1 simulations from 1989 to 2014, with a focus on the Mt. Pinatubo eruption. We evaluate our interactive representation of the stratospheric sulfur cycle against data from Moderate Resolution Imaging Spectroradiometer, Multi‐angle Imaging SpectroRadiometer, Advanced Very High Resolution Radiometer, High Resolution Infrared Radiation Sounder, and Stratospheric Aerosol and Gas Experiment II. To assess the key processes associated with volcanic aerosols, we performed a sensitivity analysis of sulfate burden from the Mt. Pinatubo eruption by varying injection heights, emission amount, and stratospheric sulfate's dry effective radius. We find that the simulated stratospheric sulfate mass burden and aerosol optical depth in the model are sensitive to these parameters, especially volcanic SO2 injection height, and the optimal combination of parameters depends on the metric we evaluate.