Search

Vitreous GeO$_2$ has been compressed at high temperature, to investigate the effect of thermal activation on the structural reorganization during compression. The measurements were performed in-situ using micro Raman spectroscopy under pressure up to 6 GPa and temperature up to 400$^\circ$C. The evolution of the Raman shift of the main band (400-500 cm$^{-1}$) with temperature during compression evidences a pressure window around 3 GPa within which temperature has a remarkable influence on the structure, in particular the intermediate range order. We find that this change is well correlated with previous ex-situ density measurements from high pressure-high temperature densifications. Moreover, coordination changes from tetrahedrally (GeO$_4$) to octahedrally (GeO$_6$) coordinated GeO$_2$ are accelerated with the heating during the compression.

Densified SiO2 glasses, obtained from different pressure and temperature routes have been annealed over a wide range of temperature far below the glass transition temperature (500$^\circ$C-900$^\circ$C). Hot and cold compressions were useful to separate the effects of pressure and the compression temperature. In-situ micro-Raman spectroscopy was used to follow the structural evolution during the thermal relaxation. A similar glass structure between the non-densified silica and the recovered densified silica after the temperature annealing demonstrates a perfect recovery of the non-densified silica glass structure. While the density decreases monotonically, the structural relaxation takes place through a more complex mechanism, which shows that density is not a sufficient parameter to fully characterize the structure of densified silica glass. The relaxation takes place through a transitory state, consisting in an increase of the network inhomogeneity, shown by an increase in intensity of the D2 band which is associated with 3 membered rings. The activation energy of these processes is 255$\pm$45 kJ/mol for the hot compressed samples. The kinetic is overall faster for the cold compressed samples. In that last case the relaxation is partially activated by internal stresses release.

Densified silica can be obtained by different pressure and temperature paths and for different stress conditions, hydrostatic or including shear. The density is usually the macroscopic parameter used to characterize the different compressed silica samples. The aim of our present study is to compare structural modifications for silica glass, densified from several routes. For this, densified silica glasses are prepared from cold and high temperature (up to 1020 $^\circ$C) compressions. The different densified glasses obtained in our study are characterized by micro-Raman spectroscopy. Intertetrahedral angles from the main band relative to the bending mode decreases and their values are larger for densified samples from high temperature compression than those samples from cold compression. The relative amount of 3-membered rings deduced from the D2 line area increases as a function of density for cold compression. The temperature increase during the compression process induces a decrease of the 3 fold ring population. Moreover, 3 fold rings are more deformed and stressed for densified samples at room temperature at the expense of those densified at high temperature. Temperature plays a main role in the reorganization structure during the densification and leads to obtaining a more relaxed structure with lower stresses than glasses densified from cold compression. The role of hydrostatic or non-hydrostatic applied stresses on the glass structure is discussed. From the Sen and Thorpe central force model, intertetrahedral angle average value and their distribution are estimated.

In addition of a flow, plastic deformation of structural glasses (in particular amorphous silica) is characterized by a permanent densification. Raman spectroscopic estimators are shown to give a full account of the plastic behavior of silica under pressure. While the permanent densification of silica has been widely discussed in terms of amorphous-amorphous transition, from a plasticity point of view, the evolution of the residual densification with the maximum pressure of a pressure cycle can be discussed as a density hardening phenomenon. In the framework of such a mechanical aging effect, we propose that the glass structure could be labelled by the maximum pressure experienced by the glass and that the saturation of densification could be associated with the densest packing of tetrahedra only linked by their vertices.

We studied a set of float glass samples prepared with different fictive temperature by previous annealing around the glass transition temperature. We compared the results to previous measurements on a series of amorphous silica samples, also prepared with different fictive temperature. We showed that the modifications on the structure at a local scale are very small, the changes of physical properties are moderate but the changes on density fluctuations at a nanometer scale are rather large: 12 and 20% in float glass and silica, for relative changes of fictive temperature equal to 13 and 25% respectively. Local order and mechanical properties of silica vary in the opposite way compared to float glass (anomalous behavior) but the density fluctuations in both glasses increase with temperature and fictive temperature.

In this paper, small-angle X-ray scattering measurements are used to determine the different compressibility contributions, as well as the isothermal compressibility, in thermal equilibrium in silica glasses having different thermal histories. Using two different methods of analysis, in the supercooled liquid and in the glassy state, we obtain respectively the temperature and fictive temperature dependences of the isotheraml compressibility. The values obtained in the glass and supercooled liquid states are very close to each other. They agree with previous determinations of the literature. The compressibility in the glass state slightly decreases with increasing fictive temperature. The relaxational part of the compressibility is also calculated and compared to previous determinations. We discussed the small differences between the different determinations.

Raman microspectroscopy was used to characterize amorphous silica plastic behavior. Using a correlation between Raman spectrum and density, a map of the local residual indentation-induced densification is obtained. The existence of a densification-induced hardening is also evidenced through a diamond anvil cell experiment. Such observations are not accounted for by the previously proposed hardening-free pressure-dependent yield criterion based on indentation curves. These results open the way to more accurate description of a constitutive law for amorphous silica.