Search

Despite the progress in the development of innovative EEG acquisition systems, their use in dynamic applications is still limited by motion artifacts compromising the interpretation of the collected signals. Therefore, extensive research on the genesis of motion artifacts in EEG recordings is still needed to optimize existing technologies, shedding light on possible solutions to overcome the current limitations. We identified three potential sources of motion artifacts occurring at three different levels of a traditional biopotential acquisition chain: the skin-electrode interface, the connecting cables between the detection and the acquisition systems, and the electrode-amplifier system. The identified sources of motion artifacts were modelled starting from experimental observations carried out on EEG signals. Consequently, we designed customized EEG electrode systems aiming at experimentally disentangling the possible causes of motion artifacts. Both analytical and experimental observations indicated two main residual sites responsible for motion artifacts: the connecting cables between the electrodes and the amplifier and the sudden changes in electrode-skin impedance due to electrode movements. We concluded that further advancements in EEG technology should focus on the transduction stage of the biopotentials amplification chain, such as the electrode technology and its interfacing with the acquisition system. [ABSTRACT FROM AUTHOR]

Climbing is a physically demanding discipline, placing significant loads on the finger flexors. Notwithstanding the documented greater endurance capacity of experienced climbers, the mechanisms explaining these training-induced adaptations remain unknown. We therefore investigate whether two non-competing strategies – muscle adaptation and alternate muscle recruitment – may explain the disparity in endurance capacity in participants with different climbing experience. We analysed high-density surface electromyograms (EMGs) from 38 Advanced and Intermediate climbers, during suspension exercises over three different depths (15, 20, 30 mm) using a half-crimp grip position. From the spatial distribution of changes in MeDian Frequency and Root Mean Square values until failure, we assessed how much and how diffusely the myoelectric manifestations of fatigue took place. Advanced climbers exhibited greater endurance, as evidenced by significantly longer failure time (p < 0.009) and lower changes in MDF values (p < 0.013) for the three grip depths. These changes were confined to a small skin region (nearly 25% of the grid size), centred at variable locations across participants. Moreover, lower MDF changes were significantly associated with longer suspension times. Collectively, our results suggest that muscle adaptation rather than load sharing between and within muscles is more likely to explain the improved endurance in experienced climbers. [ABSTRACT FROM AUTHOR]

Proprioception refers to the ability to perceive the position and movement of body segments in space. The cortical aspects of the proprioceptive afference from the body can be investigated using corticokinematic coherence (CKC). CKC accurately quanti- fies the degree of coupling between cortical activity and limb kinematics, especially if precise proprioceptive stimulation of evoked movements is used. However, there is no evidence on how volitional muscle activation during proprioceptive stimulation affects CKC strength. Twenty-five healthy volunteers (28.8 ± 7 yr, 11 females) participated in the experiment, which included electroencephalographic (EEG), electromyographic (EMG), and kinematic recordings. Ankle-joint rotations (2-Hz) were elicited through a movement actuator in two conditions: passive condition with relaxed ankle and active condition with constant 5-Nm plantar flexion exerted during the stimulation. In total, 6 min of data were recorded per condition. CKC strength was defined as the maximum coherence value among all the EEG channels at the 2-Hz movement frequency for each condition separately. Both conditions resulted in significant CKC peaking at the Cz electrode over the foot area of the primary sensorimotor (SM1) cortex. Stronger CKC was found for the active (0.13 ± 0.14) than the passive (0.03 ± 0.04) condition (P < 0.01). The results indicated that volitional activation of the muscles intensifies the neuronal proprioceptive processing in the SM1 cortex. This finding could be explained both by peripheral sensitization of the ankle joint proprioceptors and central modulation of the neuronal proprioceptive processing at the spinal and cortical levels. [ABSTRACT FROM AUTHOR]

The use of electrical stimulation to elicit single twitches and tetanic contractions of skeletal muscles has increased markedly in the last years, with applications ranging from basic physiology to clinical settings. Addressing all possible needs required by different applications with an electrical stimulator is challenging as it requires the device to be highly flexible in terms of stimulation configurations (number of channels and electrode location), and possibility to control the stimulation patterns (timing and stimulation profiles). This paper describes a new wireless, modular, and programmable electrical stimulator integrating the possibility to acquire and use biomechanical signals to trigger the stimulation output. A closed-loop FES Cycling setup has been presented to show a possible application of the system.

The use of multiple surface EMG electrodes (High-Density surface EMG - HD-sEMG) allows the extraction of anatomical and physiological information either at the muscle or at the motor unit level with applications in several fields ranging from clinical neurophysiology to the control of prosthetic devices. These applications need to acquire monopolar sEMG signals free from power line interference arising from the capacitive coupling between the subject, the acquisition system and the power line. The aim of this work is to provide a common mode analysis of the detection system used to collect monopolar sEMG signals, characterizing different configuration of the reference electrodes leading to different behaviors in terms of immunity to the power line interference. Based on the experimental results, a new impedance-controlled HD-sEMG signal amplifier is proposed and discussed.