Search

A simple mathematical model to estimate the energy stored in a green roof is developed. Analytical solutions are derived corresponding to extensive (shallow) and intensive (deep) substrates. Results are presented for the surface temperature and energy stored in both green roofs and concrete during a typical day. Within the restrictions of the model assumptions the analytical solution demonstrates that both energy and surface temperature vary linearly with fractional leaf coverage, albedo and irradiance, while the effect of evaporation rate and convective heat transfer is non-linear. It is shown that a typical green roof is significantly cooler and stores less energy than a concrete one even when the concrete has a high albedo coating. Evaporation of even a few millimetres per day from the soil layer can reduce the stored energy by a factor of more than three when compared to an equivalent thickness concrete roof., Peer Reviewed, Postprint (published version)

A mathematical model describing the erosion or leaching of a solid material by a flowing fluid in a column is developed. This involves an advection-diffusion equation coupled to a linear kinetic reaction describing the mass transfer between the solid and fluid. Two specific cases are analysed, the first where the extracted material has the same saturation solubility and rate of mass transfer throughout the process, the second where the solubility switches after a certain amount of erosion. In the first case there are only two model unknowns, the solubility and mass transfer coefficient, in the second there is a third unknown, the second solubility. Exploiting the fact that erosion is a slow process (relative to the flow rate) a perturbation solution based on the smallness of the amount removed is developed to describe the concentration and radius throughout the column. From this an analytical expression for the extracted fraction is obtained. The extracted fraction has a large linear section which results in a simple calculation to estimate the initial solubility from a very few or even a single data point. The remaining unknowns may also be easily calculated from the formula and later data points. A numerical solution, using finite differences, is developed to verify the perturbation solution. The analytical solution is also verified against experimental data for the removal of lanolin from wool fibres with a supercritical CO /ethanol solvent. Values for the mass transfer rate and two solubilities are obtained for different pressures and shown to provide excellent agreement with a series of experimental results for the extracted fraction., Peer Reviewed, Postprint (author's final draft)

Premi Extraordinari de Doctorat, promoció 2018-2019. Àmbit de Ciències, For 200 years, Fourier’s law has been used to describe heat transfer with excellent results. However, as technology advances, more and more situations arise where heat conduction is not well described by the classical equations. Examples are applications with extremely short time scales such as ultra fast laser heating, or very small length scales such as the heat conduction through nanowires or nanostructures in general. In this thesis we investigate alternative models which aim to correctly describe the non-classical effects that appear in extreme situations and which Fourier’s law fails to describe. A popular approach is the Guyer-Krumhansl equation and the framework of phonon hydrodynamics. This formalism is particularly appealing from a mathematical point of view since it is analogous to the Navier-Stokes equations of fluid mechanics, and from a physical point of view, since it is able to describe the physics in a simple and elegant way. In the first part of the thesis we use phonon hydrodynamics to predict the size-dependent thermal conductivity observed experimentally in nanostructures such as nanowires or thin films. In particular, we show that the Guyer-Krumhansl equation is suitable to capture the dependence of the thermal conductivity on the size of the physical system under consider- ation. During the modelling process we use the analogy with fluids to incorporate a slip boundary condition with a slip coefficient that depends on the ratio of the phonon mean free path to the characteristic size of the system. With only one fitting parameter we are able to accurately reproduce experimental observations corresponding to nanowires and nanorods of different sizes. The second part of the thesis consists of studying the effect of the non-classical fea- tures on melting and solidification processes. We consider different extensions and in- corporate them into the mathematical description of a solidification process in a simple, one-dimensional geometry. In chapt, La llei de Fourier ha estat una peça clau per a descriure la conducció de calor des de que fou proposada fa gairabé 200 anys. No obstant, a mesura que avança la tecnologia ens hi trobem més sovint amb situacions on les equacions clàssiques perden la seva validesa. En aquesta tesi investiguem alguns models alternatius que tenen com a objectiu descriure la conducció de calor en situacions on la llei de Fourier no és aplicable. Un model que s'ha aconseguit establir com un extensió vàlida de la llei de Fourier és l'equació de Guyer i Krumhansl i el marc de la hidrodinàmica de fonons derivat d'aquesta. Es tracta d'un model particularment interessant, ja que les equacions són anàlogues a les equacions per a fluids dins de la hidrodinàmica clàssica. A la primera part de la tesi considerem aquesta equació per a descriure la conducció de calor estàtica per nanofibres de seccions transversals circulars i rectangulars. En particular, calculem una conductivitat tèrmica efectiva i trobem que és possible reproduïr els resultats experimentals amb un sol paràmetre d'adjust. En el cas de nanofibres cilíndriques, no és necessari cap paràmetre d'adjust si es consideren unes certes condicions de vora per al flux. Una conseqüència d'haver de considerar extensions per a la llei de Fourier és que s'ha d'estudiar l'efecte que tenen aquests canvis en la descripció de processos de canvi de fase. En la segona part de la tesi investiguem els efectes que tenen diversos models sobre la solidificació d'un líquid unidimensional. Al capítol 5 estudiem el cas en el que considerem la conductivitat tèrmica com a una funció de la mida del sòlid i que incorpora característiques que són importants quan el tamany del sòlid és comparable a les longituds característiques dels fonons, mentres que al capítol 6 considerem l'equació de Guyer i Krumhansl dels capítols anteriors. En ambdós casos, un anàlisi asimptòtic ens permet reduïr la complexitat del problema i proposar models reduïts formats per un parell de, Award-winning, Postprint (published version)

We study the derivation, properties and solution methods of the classical and the hyperbolic heat transfer equations. Some results to approximate the hyperbolic model with the classical model for small values of the thermal relaxation time are given. Finally, two examples of application of the hyperbolic model are studied and discussed.

This thesis is an introduction to the theory of minimal surfaces. After introducing the basic concepts of functional analysis, variational calculus and theory of surfaces, a theorem existence of nonparametric minimal surfaces and the more general Douglas-Courant-Tonelli method are given. The Weierstrass-Enneper representation theorems link our minimal surfaces with complex analysis and potential theory.