Search

Objective: Improve 3D printing performance and gel properties of silver carp surimi system. Methods: By optimizing 3D printing parameters, the 3D printing process is associated with material rheological properties and 3D printing performance. The effects of sodium chloride addition on rheological properties, 3D printing properties, gel strength, moisture properties and microstructure of silver carp surimi were investigated. Results: The addition of sodium chloride decreased the loss modulus of surimi in a dose-dependent manner, but significantly improved the shear recovery performance, reduced the cooking loss of surimi system and increased the water retention of surimi system. The best gel strength and the densest microstructure of silver carp were obtained when the sodium chloride content was 2.5%. Conclusion: Adding proper amount of sodium chloride can improve the 3D printing performance and gel properties of surimi products.

In view of the limitations of the traditional processing technology of Pidan, this review summarizes the innovative processing technologies of Pidan, such as gradient temperature control, ultrasonic assisted, vacuum decompression, pulsating pressure, etc., and describes the changes of water, pH value, protein, free amino acids, texture, mineral elements and micro-morphology during the picking process of Pidan. Moreover, the development directions of Pidan products are prospected.

Objective: To investigate the effect of calcium, magnesium and potassium salts on the properties of coix seed starch-myofibrillar protein (CSS-MP) composite gel with low sodium content. Methods: Based on the results of previous research, the effects of partial substitution of NaCl by CaCl2, MgCl2 or KCl on the gel strength, water holding capacity (WHC), rheological properties, surface hydrophobicity, sulfhydryl group content, gel microstructure and sensory evaluation of CSS-MP composite gel were investigated. Results: The texture and rheological properties of the CaCl2 substitution group were better than those of the control group (3% NaCl), and the WHC and whiteness of the KCl substitution group were not significantly different from those of the control group, but the gel strength was decreased by MgCl2 or KCl substitution. The total sulfhydryl content of the CaCl2 and MgCl2 replacement groups was significantly lower than that of the control group, and the surface hydrophobicity of the CaCl2 replacement group was significantly higher than that of the other three groups. The addition of MgCl2 promoted the formation of hydrogen bonds, enhanced the hydrophobic interaction, while CaCl2 substitution had the opposite effect. In terms of sensory properties, the substitution of 1.0% CaCl2 and 0.5% MgCl2 could attain a saltiness perception similar to 3% NaCl. However, the comprehensive sensory score showed that the substitution of the three chlorine salts caused no significant difference in sensory properties of CSS-MP composite gel. Conclusion: Calcium, magnesium and potassium salts can improve the properties of CSS-MP composite gel in different degrees. The results of this study lay a theoretical foundation for the development of low-sodium composite surimi gel products.

The purpose of this study was to investigate the effect of crimson snapper scale peptides (CSSPs) on H2O2-induced oxidative damage in Caco-2 cells. The levels of lactate dehydrogenase (LDH) and interleukin-8 (IL-8) in the cell supernatant, the activity of intracellular antioxidant enzymes, the release of intracellular reactive oxygen species (ROS) and malondialdehyde (MDA), and the expression of apoptosis-related genes (Caspase-3, Caspase-9, Bax and Bcl-2) were measured. The antioxidant effects of CSSPs in intestinal cells were elucidated from the aspects of cellular redox state and apoptosis. Results showed that CSSPs mitigated H2O2-induced oxidative damage in Caco-2 cells through the antioxidant defense system. This effect involved increased activities of antioxidant enzymes and consequent inhibition of LDH release, intracellular ROS accumulation, and MDA and IL-8 production. Furthermore, CSSPs inhibited oxidative stress-induced apoptosis by regulating the mitochondrial apoptotic pathway, which significantly increased mitochondrial membrane potential, down-regulated the mRNA expression of Caspase-3, Caspase-9 and Bax, and up-regulated the mRNA expression of Bcl-2. In conclusion, CSSPs can effectively reduce the degree of cell damage by maintaining redox homeostasis and inhibiting apoptosis.

In order to reduce the amount of added sodium in myofibrillar protein (MP) gel, the effects of partial substitution of different chloride salts (CaCl2, MgCl2, and KCl) for NaCl on the gel strength, microstructure, water-holding capacity and rheological properties of MP gel were studied. The underlying mechanism of action of sodium substitutes was elucidated by using sodium dodecyl sulfate-polyacrylamide gel electrophoresis (SDS-PAGE) and intrinsic fluorescence spectroscopy as well as measuring surface hydrophobicity and sulfhydryl content. The results showed that KCl was the best substitute for NaCl, followed by CaCl2, and MgCl2 was least effective in replacing NaCl. The gel strength of the KCl substitution groups (0.5% KCl + 2.5% NaCl, 1.5% KCl + 1.5% NaCl, and 1.0% KCl + 2.0% NaCl; m/m) was better than that of the control group (3% NaCl), while no significant difference in water-holding capacity was found between the two groups (P > 0.05). The gel strength of the 1.5% CaCl2 + 1.5% NaCl group decreased significantly (P < 0.05), and the water-holding capacity decreased first and then increased. The gel strength significantly decreased (P < 0.05) and the water-holding capacity increased in the MgCl2 substitution groups. In terms of rheological properties, the storage modulus (G’) of the KCl substitution groups was significantly higher than that of the control group. Substitution of CaCl2 and MgCl2 increased the surface hydrophobicity of MP and decreased the sulfhydryl content. Substitution of CaCl2, MgCl2, and KCl resulted in a blue shift in intrinsic fluorescence spectra. At low substitution levels (0.5%), the microstructure of MP gel showed no significant difference from that of the control group. The above results indicate that CaCl2, MgCl2 and KCl can be used to partially substitute NaCl in surimi gel products.

With the improvement of living conditions, people’s eating habits gradually trend to “healthy” development. However, it is difficult to strike a balance between “healthy” and “delicious”. Seasoning is a crucial step during cooking. Saltiness is one of the five basic tastes, and it is produced mainly by adding salt in daily life. Salt plays an important role in human life, but excessive sodium intake can lead to many cardiovascular diseases. Today many health authorities around the world advocate a low-sodium diet. In this context, reducing the amount of salt in foods without affecting their flavor or quality has become a popular research topic. This paper reviews the mechanism of salty taste perception and the current status of salt reduction in foods, with special focuse on salty peptides. The sources, preparation and identification methods, synergistic effect and application prospects of salty peptides are outlined in this paper, so as to provide a basis for the development and application of salty peptides, which will help in advancing the salt reduction campaign.

Condiments (such as sodium chloride and glutamate sodium) cause consumers to ingest too much sodium and may lead to a variety of diseases, thus decreasing their quality of life. Recently, a salt reduction strategy using flavor peptides has been established. However, the development of this strategy has not been well adopted by the food industry. There is an acute need to screen for peptides with salty and umami taste, and to understand their taste characteristic and taste mechanism. This review provides a thorough analysis of the literature on flavor peptides with sodium-reducing ability, involving their preparation, taste characteristic, taste mechanism and applications in the food industry. Flavor peptides come from a wide range of sources and can be sourced abundantly from natural foods. Flavor peptides with salty and umami tastes are mainly composed of umami amino acids. Differences in amino acid sequences, spatial structures and food matrices will cause different tastes in flavor peptides, mostly attributed to the interaction between peptides and taste receptors. In addition to being used in condiments, flavor peptides have also anti-hypertensive, anti-inflammatory and anti-oxidant abilities, offering the potential to be used as functional ingredients, thus making their future in the food industry extremely promising. [ABSTRACT FROM AUTHOR]

The influence of epigallocatechin gallate (EGCG) on the physicochemical–rheological properties of silver carp surimi gel was investigated. The gel strength, texture, water-holding capacity (WHC), dynamic distribution of water, and rheological properties of surimi gels added with different levels (0, 0.02, 0.04, 0.06, 0.08, and 0.1%) of EGCG were measured. The results showed that with the increase of EGCG content, the gel strength, hardness, WHC, and immobilized water contents of surimi gels showed a trend of first increasing and then decreasing, and EGCG 0.02% and EGCG 0.04% showed better gel performance as compared with the control. EGCG 0.02% had the highest gel strength (406.62 g·cm), hardness (356.67 g), WHC (64.37%), and immobilized water contents (98.958%). The gel performance decreased significantly when the amounts of EGCG were higher than 0.06%. The viscosity, G′, and G″ of the rheological properties also showed the same trends. The chemical interaction of surimi gels, secondary structure of myofibrillar protein (MP), and molecular docking results of EGCG and silver carp myosin showed that EGCG mainly affected the structure and aggregation behavior of silver carp myosin through non-covalent interactions such as those of hydrogen bonds, hydrophobic interactions, and electrostatic interactions. The microstructures of EGCG 0.02% and EGCG 0.04% were compact and homogeneous, and had better gel formation ability. The lower concentrations of EGCG formed a large number of chemical interactions such as those of disulfide bonds and hydrophobic interactions inside the surimi gels by proper cross-linking with MP, and also increased the ordered β-sheet structure of MP, which facilitated the formation of the compact three-dimensional network gel. [ABSTRACT FROM AUTHOR]