Search

Neutralizing antibodies (inhibitors) to replacement factor VIII (FVIII, either plasma derived or recombinant) impair the effective management of hemophilia A. Individuals with hemophilia A due to major deletions of the FVIII gene (F8) lack antigenically cross-reactive material in their plasma ("CRM-negative"), and the prevalence of inhibitors in these individuals may be as high as 90%. Conversely, individuals with hemophilia A caused by F8 missense mutations are CRM-positive, and their overall prevalence of inhibitors is

Several factor (F) VIII products of different origin and structure are being used for haemophilia A treatment worldwide. The assessment of FVIII concentration in these products is done using activity assays, which are dependent upon the assay and its modifications. To evaluate FVIII products for potency and for FVIII concentration and specific activity, three activity-based assays [activated partial thromboplastin time (APTT), intrinsic FXase and synthetic coagulation proteome] and two immunoassays (ELISA and western blotting) were used in this study with albumin-free full-length recombinant (r) FVIII as a standard. In all activity assays, products A and B (both contain full-length rFVIII) at 1 U mL(-1) showed potency similar to that of the 0.7 nm (1 U mL(-1)) rFVIII standard. Product E (contains truncated rFVIII) was less potent in the APTT (83% of standard) and product C (contains plasma FVIII) was less potent in FXase assays (66%). The ELISA immunoassay revealed that the specific activity of FVIII proteins in products A-C and E varied over a wide range (3900-13 200 U mg(-1)) and was higher for most lots when compared with the standard (5000 U mg(-1)), whereas the specific activity of product D (contains plasma FVIII) was lower than expected (3200-4800 U mg(-1)). (i) FVIII potency estimated in different assays gives dissimilar results; (ii) the specific activity of FVIII in various FVIII products is different and inconsistent. Thus, the administration of an equal FVIII potency in units means the administration of different amounts of FVIII protein, which may partly explain apparent discrepancies in product performance.

The influence of platelets on tissue factor (TF)-initiated thrombin generation in a reconstituted model of blood coagulation and in whole blood was evaluated. No thrombin generation was observed over 15 min in the reconstituted model when either TF or platelets and phospholipids were omitted. At 25 pM TF, the rates of thrombin generation were platelet and PCPS concentration-dependent and achieved maximum (1.0 nM/s) in the physiological range of platelet concentration. Similar rates were achieved in the absence of platelets when 1-2 microM phospholipid was used. However, the maximum rates of thrombin generation (5.2-6.0 nM/s) and the shortest initiation phase (1 min) were attained between 25 and 100 microM phospholipid. In the reconstituted model, an increase in platelet concentration from 0.125 x 10(8)/ml to 0.5 x 10(8)/ml decreased the duration of the initiation phase (in the absence of phospholipids) from 4.3 min to 2 min. Further increases in platelet concentration did not affect this phase. Sequential whole blood studies were conducted in blood of a chemotherapy patient who developed reduced platelet counts. The TF (12.5 pM) initiated clotting of patient's blood was accelerated from approximately 10 min to 5 min when the platelet concentration increased from 0.05 x 10(8)/ml to 0.11 x 10(8)/ml. Clotting times were essentially unchanged for platelet concentrations exceeding 0.5 x 10(8)/ml (range 0.5-3.1 x 10(8)/ml). Similarly, clotting of whole blood obtained from healthy volunteers was not affected by the platelet count, which varied from 1.5 x 10(8)/ml to 3.1 x 10(8)/ml (4.0+/-0.5 min). The data obtained in both models are consistent with in vivo observations that clinical bleeding is most likely to occur at platelet counts

Three model systems have been used to study the dynamics of the blood clotting process initiated by tissue factor (TF): synthetic plasma mixtures prepared with purified coagulation proteins and inhibitors; mathematical models based on the reaction constants, stoichiometries and thermodynamics of individual catalyst and inhibitor reactions; and contact suppressed whole blood induced to clot in vitro by the addition of exogenous TF. In the three models, the generation of thrombin can be described in terms of an initiation phase in which pmol/l concentrations of the coagulation serine proteases are generated and the cofactor proteins factor V (FV) and FVIII are activated. Subsequently, explosive thrombin generation occurs during a propagation phase. The complementary inhibitory pathways extinguish the generation of thrombin. Tissue factor pathway inhibitor (TFPI), present in low concentrations, primarily influences the duration of the initiation phase and has little influence on the propagation phase. Antithrombin III (ATIII), present in higher concentrations, has little influence during the initiation phase, but decreases the rate of thrombin generation during the propagation phase. The protein C pathway cannot act in the absence of thrombin and therefore only influences the duration of the propagation phase by inactivating activated FV. Thus combinations of TFPI plus ATIII and TFPI plus protein C pathway components contribute to the synergistic inhibitory processes. As a consequence of the roles of pro, and anti-coagulants, the generation of thrombin by the TF pathway becomes a threshold limited process