Search

peer-reviewed, Trees and their associated rhizosphere organisms play a major role in mineral weathering drivingcalcium fluxes from the continents to the oceans that ultimately control long-term atmosphericCO2 and climate through the geochemical carbon cycle. Photosynthate allocation to tree roots andtheir mycorrhizal fungi is hypothesized to fuel the active secretion of protons and organic chelatorsthat enhance calcium dissolution at fungal-mineral interfaces. This was tested using 14CO2 suppliedto shoots of Pinus sylvestris ectomycorrhizal with the widespread fungus Paxillus involutus inmonoxenic microcosms, revealing preferential allocation by the fungus of plant photoassimilate toweather grains of limestone and silicates each with a combined calcium and magnesium contentof over 10 wt.%. Hyphae had acidic surfaces and linear accumulation of weathered calcium withsecreted oxalate, increasing significantly in sequence: quartz, granite < basalt, olivine, limestone

Biotite dissolution rates were determined at 25 °C, at pH 2–6, and as a function of mineral composition, grain size, and aqueous organic ligand concentration. Rates were measured using both open- and closed-system reactors in fluids of constant ionic strength. Element release was non-stoichiometric and followed the general trend of Fe, Mg > Al > Si. Biotite surface area normalised dissolution rates (ri) in the acidic range, generated from Si release, are consistent with the empirical rate law: ri=kH,iaxiH+ where kH,i refers to an apparent rate constant, aH+ designates the activity of protons, and xi stands for a reaction order with respect to protons. Rate constants range from 2.15 × 10−10 to 30.6 × 10−10 (molesbiotite m−2 s−1) with reaction orders ranging from 0.31 to 0.58. At near-neutral pH in the closed-system experiments, the release of Al was stoichiometric compared to Si, but Fe was preferentially retained in the solid phase, possibly as a secondary phase. Biotite dissolution was highly spatially anisotropic with its edges being ∼120 times more reactive than its basal planes. Low organic ligand concentrations slightly enhanced biotite dissolution rates. These measured rates illuminate mineral–fluid–organism chemical interactions, which occur in the natural environment, and how organic exudates enhance nutrient mobilisation for microorganism acquisition.

peer-reviewed, Bauxite residue is a high volume byproduct of alumina manufacture which is commonly disposed of in purpose-built bauxite residue disposal areas (BRDAs). Natural waters interacting with bauxite residue are characteristically highly alkaline, and have elevated concentrations of Na, Al, and other trace metals. Rehabilitation of BRDAs is therefore often costly and resource/infrastructure intensive. Data is presented from three neighboring plots of bauxite residue that was deposited 20 years ago. One plot was amended 16 years ago with process sand, organic matter, gypsum, and seeded (fully treated), another plot was amended 16 years ago with process sand, organic matter, and seeded (partially treated), and a third plot was left untreated. These surface treatments lower alkalinity and salinity, and thus produce a substrate more suitable for biological colonisation from seeding. The reduction of pH leads to much lower Al, V, and As mobility in the actively treated residue and the beneficial effects of treatment extend passively 20–30 cm below the depth of the original amendment. These positive rehabilitation effects are maintained after 2 decades due to the presence of an active and resilient biological community. This treatment may provide a lower cost solution to BRDA end of use closure plans and orphaned BRDA rehabilitation.

Biotite dissolution rates were determined at 25 °C, at pH 2–6, and as a function of mineral composition, grain size, and aqueous organic ligand concentration. Rates were measured using both open- and closed-system reactors in fluids of constant ionic strength. Element release was non-stoichiometric and followed the general trend of Fe, Mg > Al > Si. Biotite surface area normalised dissolution rates (ri) in the acidic range, generated from Si release, are consistent with the empirical rate law: ri=kH,iaxiH+ where kH,i refers to an apparent rate constant, aH+ designates the activity of protons, and xi stands for a reaction order with respect to protons. Rate constants range from 2.15 × 10−10 to 30.6 × 10−10 (molesbiotite m−2 s−1) with reaction orders ranging from 0.31 to 0.58. At near-neutral pH in the closed-system experiments, the release of Al was stoichiometric compared to Si, but Fe was preferentially retained in the solid phase, possibly as a secondary phase. Biotite dissolution was highly spatially anisotropic with its edges being ∼120 times more reactive than its basal planes. Low organic ligand concentrations slightly enhanced biotite dissolution rates. These measured rates illuminate mineral–fluid–organism chemical interactions, which occur in the natural environment, and how organic exudates enhance nutrient mobilisation for microorganism acquisition.