Search

Port-related activities have a detrimental impact on the air quality both at the point of source and for considerable distances beyond. These activities include, but are not limited to, heavy cargo traffic, onboard, and at-berth emissions. Due to differences in construction, operation, location, and policies at ports, the site-specific air pollution cocktail could result in different human health risks. Thus, monitoring and evaluating such emissions are essential to predict the risk to the community. Environmental agencies often monitor key pollutants (PM 2.5 , PM 10 , NO 2 , SO 2 ), but the volatile organic carbons (VOCs) most often are not, due to its analytical challenging. This study intends to fill that gap and evaluate the VOC emissions caused by activities related to the port of Paranaguá - one of the largest bulk ports in Latin America - by characterizing BTEX concentrations at the port and its surroundings. At seven different sites, passive samplers were used to measure the dispersion of BTEX concentrations throughout the port and around the city at weekly intervals from November 2018 to January 2019. The average and uncertainty of BTEX concentrations (µg m -3 ) were 0.60 ± 0.43, 5.58 ± 3.80, 3.30 ± 2.41, 4.66 ± 3.67, and 2.82 ± 1.95 for benzene, toluene, ethylbenzene, m- and p-xylene, and o-xylene, respectively. Relationships between toluene and benzene and health risk analysis were used to establish the potential effects of BTEX emissions on the population of the city of Paranaguá. Ratio analysis (T/B, B/T, m,p X/Et, and m,p X/B) indicate that the BTEX levels are mainly from fresh emission sources and that photochemical ageing was at minimum. The cancer risk varied across the sampling trajectory, whereas ethylbenzene represented a moderate cancer risk development for the exposed population in some of the locations. This study provided the necessary baseline data to support policymakers on how to change the circumstances of those currently at risk, putting in place a sustainable operation., (© 2023. The Author(s), under exclusive licence to Springer-Verlag GmbH Germany, part of Springer Nature.)

This research aims to assess air quality in a transitional location between city and forest in the Amazon region. Located downwind of the Manaus metropolitan region, this study is part of the large-scale experiment GoAmazon2014/5. Based on their pollutant potential, inhalable particulate matter (PM 2.5 ), nitrogen dioxide (NO 2 ), sulfur dioxide (SO 2 ), ozone (O 3 ), hydrogen sulfide (H 2 S), benzene, toluene, ethylbenzene and meta-, orto-, para-xylene (BTEX) were selected for analysis. Sampling took place during the wet season (March-April 2014) and dry season (August-October 2014). The number of forest fires in the surroundings was higher during the dry wet season. Results show significant increase during the dry season in mass concentration (wet: <0.01-10 μg m -3 ; dry: 9.8-69 μg m -3 ), NH 4 + soluble content (wet: 13-125 μg m -3 ; dry: 86-323 μg m -3 ) and K + soluble content (wet: 11-168 μg m -3 ; dry 60-356 μg m -3 ) of the PM 2.5 , and O 3 levels (wet: 1.4-14 μg m -3 ; dry: 1.0-40 μg m -3 ), indicating influence of biomass burning emissions. BTEX concentrations were low in both periods, but also increased during the dry season. A weak correlation in the time series of the organic and inorganic gaseous pollutants indicates a combination of different sources in both seasons and NO2 results suggest a spatial heterogeneity in gaseous pollutants levels beyond initial expectations., (Copyright © 2018 Elsevier B.V. All rights reserved.)

Among the new technologies developed for the heavy-duty fleet, the use of Selective Catalytic Reduction (SCR) aftertreatment system in standard Diesel engines associated with biodiesel/diesel mixtures is an alternative in use to control the legislated pollutants emission. Nevertheless, there is an absence of knowledge about the synergic behaviour of these devices and biodiesel blends regarding the emissions of unregulated substances as the Polycyclic Aromatic Hydrocarbons (PAHs) and Nitro-PAHs, both recognized for their carcinogenic and mutagenic effects on humans. Therefore, the goal of this study is the quantification of PAHs and Nitro-PAHs present to total particulate matter (PM) emitted from the Euro V engine fuelled with ultra-low sulphur diesel and soybean biodiesel in different percentages, B5 and B20. PM sampling was performed using a Euro V - SCR engine operating in European Stationary Cycle (ESC). The PAHs and Nitro-PAHs were extracted from PM using an Accelerated Solvent Extractor and quantified by GC-MS. The results indicated that the use of SCR and the largest fraction of biodiesel studied may suppress the emission of total PAHs. The Toxic Equivalent (TEQ) was lower when using 20% biodiesel, in comparison with 5% biodiesel on the SCR system, reaffirming the low toxicity emission using higher percentage biodiesel. The data also reveal that use of SCR, on its own, suppress the Nitro-PAHs compounds. In general, the use of larger fractions of biodiesel (B20) coupled with the SCR aftertreatment showed the lowest PAHs and Nitro-PAHs emissions, meaning lower toxicity and, consequently, a potential lower risk to human health. From the emission point of view, the results of this work also demonstrated the viability of the Biodiesel programs, in combination with the SCR systems, which does not require any engine adaptation and is an economical alternative for the countries (Brazil, China, Russia, India) that have not adopted Euro VI emission standards., (Copyright © 2018 Elsevier B.V. All rights reserved.)

Although the particulate matter (PM) emissions from biodiesel fuelled engines are acknowledged to be lower than those of fossil diesel, there is a concern on the impact of PM produced by biodiesel to human health. As the oxidative potential of PM has been suggested as trigger for adverse health effects, it was measured using the Electron Spin Resonance (OP(ESR)) technique. Additionally, Energy Dispersive X-ray Fluorescence Spectroscopy (EDXRF) was employed to determine elemental concentration, and Raman Spectroscopy was used to describe the amorphous carbon character of the soot collected on exhaust PM from biodiesel blends fuelled test-bed engine, with and without Selective Catalytic Reduction (SCR). OP(ESR) results showed higher oxidative potential per kWh of PM produced from a blend of 20% soybean biodiesel and 80% ULSD (B20) engine compared with a blend of 5% soybean biodiesel and 95% ULSD (B5), whereas the SCR was able to reduce oxidative potential for each fuel. EDXRF data indicates a correlation of 0.99 between concentration of copper and oxidative potential. Raman Spectroscopy centered on the expected carbon peaks between 1100cm(-1) and 1600cm(-1) indicate lower molecular disorder for the B20 particulate matter, an indicative of a more graphitic carbon structure. The analytical techniques used in this study highlight the link between biodiesel engine exhaust and increased oxidative potential relative to biodiesel addition on fossil diesel combustion. The EDXRF analysis confirmed the prominent role of metals on free radical production. As a whole, these results suggest that 20% of biodiesel blends run without SCR may pose an increased health risk due to an increase in OH radical generation., (Copyright © 2015 Elsevier B.V. All rights reserved.)

The aim of this investigation was to quantify organic and inorganic gas emissions from a four-cylinder diesel engine equipped with a urea selective catalytic reduction (SCR) system. Using a bench dynamometer, the emissions from the following mixtures were evaluated using a Fourier transform infrared (FTIR) spectrometer: low-sulfur diesel (LSD), ultralow-sulfur diesel (ULSD), and a blend of 20% soybean biodiesel and 80% ULSD (B20). For all studied fuels, the use of the SCR system yielded statistically significant (p < 0.05) lower NOx emissions. In the case of the LSD and ULSD fuels, the SCR system also significantly reduced emissions of compounds with high photochemical ozone creation potential, such as formaldehyde. However, for all tested fuels, the SCR system produced significantly (p < 0.05) higher emissions of N2O. In the case of LSD, the NH3 emissions were elevated, and in the case of ULSD and B20 fuels, the non-methane hydrocarbon (NMHC) and total hydrocarbon of diesel (HCD) emissions were significantly higher.

The changes in the composition of fuels in combination with selective catalytic reduction (SCR) emission control systems bring new insights into the emission of gaseous and particulate pollutants. The major goal of our study was to quantify NOx, NO, NO2, NH3 and N2O emissions from a four-cylinder diesel engine operated with diesel and a blend of 20% soybean biodiesel. Exhaust fume samples were collected from bench dynamometer tests using a heavy-duty diesel engine equipped with SCR. The target gases were quantified by means of Fourier transform infrared spectrometry (FTIR). The use of biodiesel blend presented lower concentrations in the exhaust fumes than using ultra-low sulfur diesel. NOx and NO concentrations were 68% to 93% lower in all experiments using SCR, when compared to no exhaust aftertreatment. All fuels increased NH3 and N2O emission due to SCR, a precursor secondary aerosol, and major greenhouse gas, respectively. An AERMOD dispersion model analysis was performed on each compound results for the City of Curitiba, assumed to have a bus fleet equipped with diesel engines and SCR system, in winter and summer seasons. The health risks of the target gases were assessed using the Risk Assessment Information System For 1-h exposure of NH3, considering the use of low sulfur diesel in buses equipped with SCR, the results indicated low risk to develop a chronic non-cancer disease. The NOx and NO emissions were the lowest when SCR was used; however, it yielded the highest NH3 concentration. The current results have paramount importance, mainly for countries that have not yet adopted the Euro V emission standards like China, India, Australia, or Russia, as well as those already adopting it. These findings are equally important for government agencies to alert the need of improvements in aftertreatment technologies to reduce pollutants emissions., (Copyright © 2014. Published by Elsevier B.V.)

The mitigation of pollution released to the environment originating from the industrial sector has been the aim of all policy-makers and its importance is evident if the adverse health effects on the world population are considered. Although this concern is controversial, petroleum refinery has been linked to some adverse health effects for people living nearby. Apart from home, school is the most important indoor environment for children and there is increasing concern about the school environment and its impact on health, also in developing countries where the prevalence of pollution is higher. As most of the children spend more than 40% of their time in schools, it is critical to evaluate the pollution level in such environment. In the metropolitan region of Curitiba, South Brazil, five schools nearby industries and highways with high density traffic, were selected to characterize the aerosol and gaseous compounds indoor and outdoor of the classrooms, during 2009-2011. Size segregated aerosol samples were collected for analyses of bulk and single particle elemental profiles. They were analyzed by electron probe X-ray micro-analysis (EPXMA), and by energy-dispersive X-ray fluorescence (EDXRF), to investigate the elemental composition of individual particles and bulk samples. The concentrations of benzene, toluene, ethylbenzene, and xylene (BTEX); NO2; SO2; acetic acid; and formic acid were assessed indoor and outdoor using passive diffusion tubes. BTEX were analyzed by GC-MS and other collected gasses by ion chromatography. Individual exposition of BTEX was assessed by personal passive diffusion tubes. Results are interpreted separately and as a whole with the specific aim of identifying compounds that could affect the health of the scholars. In view of the chemical composition and size distribution of the aerosol particles, local deposition efficiencies in the children's respiratory systems were calculated, revealing the deposition of particles at extrathoracic, tracheobronchial and pulmonary levels., (Copyright © 2013 Elsevier B.V. All rights reserved.)