Search

The Microwave SQUID Multiplexer ({\mu}MUX) is the device of choice for the readout of a large number of Low-Temperature Detectors in a wide variety of experiments within the fields of astronomy and particle physics. While it offers large multiplexing factors, the system noise performance is highly dependent on the cold and warm-readout electronic systems used to read it out, as well as the demodulation domain and parameters chosen. In order to understand the impact of the readout systems in the overall detection system noise performance, first we extended the available {\mu}MUX simulation frameworks including additive and multiplicative noise sources in the probing tones (i.e. phase and amplitude noise), along with the capability of demodulating the scientific data, either in resonator's phase or scattering amplitude. Then, considering the additive noise as a dominant noise source, the optimum readout parameters to achieve minimum system noise were found for both open-loop and flux-ramp demodulation schemes in the aforementioned domains. Later, we evaluated the system noise sensitivity to multiplicative noise sources under the optimum readout parameters. Finally, as a case study, we evaluated the optimal demodulation domain and expected system noise level for a typical Software-Defined Radio (SDR) readout system. This work leads to an improved system performance prediction and noise engineering based on the available readout electronics and selected demodulation domain., Comment: This article has been submitted to the Journal of Applied Physics. This is the revised version (V1)

This work reports the performance evaluation of an SDR readout system based on the latest generation (Gen3) of the AMD's Radio Frequency System-on-Chip (RFSoC) processing platform, which integrates a full-stack processing system and a powerful FPGA with up to 32 high-speed and high-resolution 14-bit Digital-to-Analog Converters (DACs) and Analog-to-Digital Converters (ADCs). The proposed readout system uses a previously developed multi-band, double-conversion IQ RF-mixing board targeting a multiplexing factor of approximately 1,000 bolometers in a bandwidth between 4 and 8 GHz, in line with state-of-the-art microwave SQUID multiplexers ($\mu$MUX). The characterization of the system was performed in two stages, under the conditions typically imposed by the multiplexer and the cold readout circuit. First, in transmission, showing that noise and spurious levels of the generated tones are close to the values imposed by the cold readout. Second, in RF loopback, presenting noise values better than -100 dBc/Hz totally in agreement with the state-of-the-art readout systems. It was demonstrated that the RFSoC Gen3 device is a suitable enabling technology for the next generation of superconducting detector readout systems, reducing system complexity, increasing system integration, and achieving these goals without performance degradation., Comment: 10 pages, peer reviewed, Journal of Low Temperature Physics special issue: LTD20

In this work we present an application of the Goertzel Filter for the channelization of multi-tonal signals, typically used for the read-out of cryogenic sensors which are multiplexed in the frequency domain (FDM), by means of Microwave Superconducting Quantum Interference Device (SQUID) Multiplexer ($\mu$MUX). We demonstrate how implementing a bank of many of these filters, can be used to perform a channelization of the multi-tonal input signal to retrieve the data added by the sensors. We show how this approach can be implemented in a resource-efficient manner in a Field Programmable Gate Array (FPGA) within the state-of-the-art, which allows great scalability for reading thousands of sensors; as is required by Radio Telescopes in Cosmic Microwave Background Radiation (CMB) surveys using cryogenic bolometers, particles detection like Neutrino mass estimation using cryogenic calorimeters or Quantum Computing., Comment: 17 pages, 18 figures, paper submitted for review for the Journal of Instrumentation (JINST)