Search

Hydroxyapatite is a bioactive ceramic frequently used for bone engineering/replacement. One of the parameters that influence the biological response to implanted materials is the conformation of the first adsorbed protein layer. In this work, the adsorption and conformational changes of two fibroid serum proteins; fibronectin and fibrinogen adsorbed onto four different hydroxyapatite powders are studied with a Quartz Crystal Microbalance with Dissipation (QCM-D). Each of the calcined apatites adsorbs less protein than their corresponding synthesized samples. Adsorption on synthesized samples yields always an extended conformation whereas a reorganization of the layer is observed for the calcined samples. Fg acquires a "Side on" conformation in all the samples at the beginning of the experiment except for one of the synthesized samples where an "End-on" conformation is obtained during the whole experiment. The Extended conformation is the active conformation for Fn. This conformation is favored by apatites with large specific surface area (SSA) and on highly concentrated media. Apatite surface features should be considered in the selection or design of materials for bone regeneration, since it is possible to control the conformation mode of attachment of Fn and Fg by an appropriate selection of them. © 2016 Wiley Periodicals, Inc. J Biomed Mater Res Part A: 104A: 2585-2594, 2016.

Protein-surface interaction may determine the success or failure of an implanted device. Not much attention have been paid to the specific surface parametes of hydroxyapatite (OHAp) that modulates and determines the formation and potential activity of the layer of proteins that is first formed when the material get in contact with the host tissue. the influence of specific surface area (SSA), crystallite size (CS) and particle size (PS) of OHAp on the adsorption of proteins relevant for bone regeneration is evaluated in this article. OHAp have been prepared by a wet chemical reaction of Ca(OH)(2) with H(3) PO(4) . One set of reactions included poly acrylic acid in the reactant solution to modify the properties of the powder. Fibrinogen (Fg) Fraction I, type I: from Human plasma, (67% Protein), and Fibronectin (Fn) from Human plasma were selected to perform the adsorption experiments. The analysis of protein adsorption was carried out by UV/Vis spectrometry. A lower SSA and a different aspect ratio are obtained when the acrylic acid is included in the reaction badge. The deconvolution of the amide I band on the Raman spectra of free and adsorbed proteins reveals that the interaction apatite-protein happens through the carboxylate groups of the proteins. The combined analysis of CS, SSA and PS should be considered on the design of OHAp materials intended to interact with proteins.

Introduction The gradual aging of the population results in increased incidence of osteoporotic bone fractures. In a good quality bone, the fixation with the usual methods is adequate, but not in osteoporotic bone, in which consolidation delays and other complications are common, with failure rates for screws up to 25%. Objective To test fibronectin loaded hydroxyapatite as a complementary treatment for osteoporotic fractures. Material and Methods This study was performed in a vivo model; 42 female osteoporotic adult rabbits 4–5 kg (White New Zealand) were used. Two groups (hydroxyapatite and fibronectin loaded hydroxyapatite) and a control group were tested. 3 time points 24 h, 48 h and 5 days were studied. Defects were created in both femurs, in one of them, a cannulated screw (4 mm) and a biocompatible material were placed; in the other femur a screw was inserted without supplemented material forming the control group. Osteoporosis was induced from models already known throughout administration of steroids. Samples were analyzed histologically and through imaging (micro Ct). Results Basal levels of BMD are observed below to normal when compared to other studies (0.25/0.3 instead of 0.4). Global and dependent of time analysis of samples, show no significant differences for samples analyzed. However, an important trend was noted for variables that define the trabecular bone microarchitecture. Indices that define trabecular microarchitecture in the comparative analysis found to have statistical differences ( p Discussion Osteosynthesis in an osteoporotic bone is a challenge for the surgeon, due to a reduced bone mineral density and different bone architecture. The main finding was the verification of the hypothesis that the trabecular bone parameters increases with our augmentation material in weak rabbit bone quality. Also, the histological analyses of samples show an increase of non inflammatory cells in protein samples (OHAp-Fn) from the first 24 hours. Conclusion An early response of rabbit osteroporotic bone to a complementary treatment with fibronectin loaded hydroxyapatite has been observed. This response is reflected in greater values for indices that define the trabecular bone microarchitecture, thickness and separation, a greater non-inflammatory cellularity after only 24 hours and an increased amount of connective tissue observed at 48 hours.

Hydroxyapatite is a bioactive ceramic frequently used for bone engineering/replacement. One of the parameters that influence the biological response to implanted materials is the conformation of the first adsorbed protein layer. In this work, the adsorption and conformational changes of two fibroid serum proteins; fibronectin and fibrinogen adsorbed onto four different hydroxyapatite powders are studied with a Quartz Crystal Microbalance with Dissipation (QCM-D). Each of the calcined apatites adsorbs less protein than their corresponding synthesized samples. Adsorption on synthesized samples yields always an extended conformation whereas a reorganization of the layer is observed for the calcined samples. Fg acquires a "Side on" conformation in all the samples at the beginning of the experiment except for one of the synthesized samples where an "End-on" conformation is obtained during the whole experiment. The Extended conformation is the active conformation for Fn. This conformation is favored by apatites with large specific surface area (SSA) and on highly concentrated media. Apatite surface features should be considered in the selection or design of materials for bone regeneration, since it is possible to control the conformation mode of attachment of Fn and Fg by an appropriate selection of them. © 2016 Wiley Periodicals, Inc. J Biomed Mater Res Part A: 104A: 2585-2594, 2016.