Search

Recently, polar side chains have emerged as a functional tool to enhance conjugated polymer doping properties by improving the polymer miscibility with polar chemical dopants and facilitate solvated ion uptake. In this work, we design and investigate a novel family of side chains containing a single ether function, enabling the modulation of the oxygen atom position along the side chain. A meticulous investigation of this new polymer series by differential scanning calorimetry, fast scanning chip calorimetry and X-ray scattering shows that polymers bearing single-ether side chains can show high degree of crystallinity under proper conditions. Importantly, due to a gauche effect allowing the side chain to bend at the oxygen atom, the degree of crystallinity of polymers can be controlled by the position of the oxygen atom along the side chain. The further the oxygen atom is from the conjugated backbone, the more crystalline the polymer becomes. In addition, for all new polymers, high thermomechanical properties are demonstrated, leading to remarkable electrical conductivities and thermoelectric power factors in rub-aligned and sequentially doped thin films. This work confirms the potential of single-ether side chains to be used as polar solubilizing side chains for the design of a next generation of p- and n-type semiconducting polymers with increased affinity to polar dopants while maintaining high molecular order.

A series of polythiophenes with varying side chain density was synthesized, and their electrical and thermoelectric properties were investigated. Aligned and non-aligned thin films of the polymers were characterized in the neutral and chemically doped states. Optical and diffraction measurements revealed an overall lower order in the thin films with lower side chain density, also confirmed using polarized optical experiments on aligned thin films. However, upon doping the non-aligned films, a sixfold increase in electrical conductivity was observed for the polythiophene with the lowest side chain density compared to poly(3-hexylthiophene) (P3HT). We found that the improvement in conductivity was not due to a larger charge carrier density but an increase in charge carrier mobility after doping with 2,3,5,6-tetrafluoro-7,7,8,8-tetracyanoquinodimethane (F4TCNQ). On the other hand, doped aligned films did not show the same trend; lower side chain density instead led to a lower conductivity and Seebeck coefficient compared to those for P3HT. This was attributed to the poorer alignment of the polymer thin films with lower side chain density. The study demonstrates that optimizing side chain density is a synthetically simple and effective way to improve electrical conductivity in polythiophene films relevant to thermoelectric applications., Competing Interests: The authors declare no competing financial interest., (© 2023 The Authors. Published by American Chemical Society.)

Conjugated polymers are increasingly used as organic mixed ionic-electronic conductors in electrochemical applications for neuromorphic computing, bioelectronics, and energy harvesting. The design of efficient electrochemical devices relies on large modulations of the polymer conductivity, fast doping/dedoping kinetics, and high ionic uptake. In this work, structure-property relations are established and control of these parameters by the co-existence of order and disorder in the phase morphology is demonstrated. Using in situ time-resolved spectroelectrochemistry, resonant Raman, and terahertz (THz) conductivity measurements, the electrochemical doping in the different morphological domains of poly(3-hexylthiophene) (P3HT) is investigated. The main finding is that bipolarons are found preferentially in disordered polymer regions, where they are formed faster and are thermodynamically more favored. On the other hand, polarons show a preference for ordered domains, leading to drastically different bipolaron/polaron ratios and doping/dedoping dynamics in the distinct regions. A significant enhancement of the electronic conductivity is evident when bipolarons start forming in the disordered regions, while the presence of bipolarons in the ordered regions is detrimental for transport. This study provides significant advances in the understanding of the impact of morphology on the electrochemical doping of conjugated polymers and the induced increase in conductivity., (© 2023 The Authors. Advanced Materials published by Wiley-VCH GmbH.)

Understanding the impact of side chains on the aqueous redox properties of conjugated polymers is crucial to unlocking their potential in bioelectrochemical devices, such as organic electrochemical transistors (OECTs). Here, we report a series of polar propylenedioxythiophene-based copolymers functionalized with glyme side chains of varying lengths as well as an analogue with short hydroxyl side chains. We show that long polar side chains are not required for achieving high volumetric capacitance ( C *), as short hydroxy substituents can afford facile doping and high C * in saline-based electrolytes. Furthermore, we demonstrate that varying the length of the polar glyme chains leads to subtle changes in material properties. Increasing the length of glyme side chain is generally associated with an enhancement in OECT performance, doping kinetics, and stability, with the polymer bearing the longest side chains exhibiting the highest performance ([μ C *] OECT = 200 ± 8 F cm -1 V -1 s -1 ). The origin of this performance enhancement is investigated in different device configurations using in situ techniques (e.g., time-resolved spectroelectrochemistry and chronoamperometry). These studies suggest that the performance improvement is not due to significant changes in C * but rather due to variations in the inferred mobility. Through a thorough comparison of two different architectures, we demonstrate that device geometry can obfuscate the benchmarking of OECT active channel materials, likely due to contact resistance effects. By complementing all electrochemical and spectroscopic experiments with in situ measurements performed within a planar OECT device configuration, this work seeks to unambiguously assign material design principles to fine-tune the properties of poly(dioxythiophene)s relevant for application in OECTs.

Organic electrochemical transistors are a promising technology for bioelectronic devices, with applications in neuromorphic computing and healthcare. The active component enabling an organic electrochemical transistor is the organic mixed ionic-electronic conductor whose optimization is critical for realizing high-performing devices. In this study, the influence of purity and molecular weight is examined for a p-type polythiophene and an n-type naphthalene diimide-based polymer in improving the performance and safety of organic electrochemical transistors. Our preparative GPC purification reduced the Pd content in the polymers and improved their organic electrochemical transistor mobility by ~60% and 80% for the p- and n-type materials, respectively. These findings demonstrate the paramount importance of removing residual Pd, which was concluded to be more critical than optimization of a polymer's molecular weight, to improve organic electrochemical transistor performance and that there is readily available improvement in performance and stability of many of the reported organic mixed ionic-electronic conductors., (© 2022. The Author(s).)

Understanding the electrochemical doping of organic semiconductors plays a crucial role in the current development of organic electronics. In this short review, we present how temperature- and time- dependent visible-near-infrared (Vis-NIR) spectro-electrochemistry and terahertz spectroscopy, combined with multivariate curve resolution analysis, can inform on the fundamental mechanisms governing the doping kinetics and efficiency of two archetypal semiconducting polymers (PEDOT and P3HT). We highlight the experimental procedures and data analysis performed to access (i) the thermodynamic parameters driving the extent and dynamics of electrochemical reactions in doped systems and (ii) how the density and nature of charged species (polarons, bipolarons) impact the charge carrier delocalization, effective THz mobility and hence short-range conductivity., (Copyright 2022 Olivier Bardagot, Natalie Banerji. License: This work is licensed under a Creative Commons Attribution 4.0 International License.)

In this work, we use pump-probe Kelvin probe force microscopy (pp-KPFM) in combination with non-contact atomic force microscopy (nc-AFM) under ultrahigh vacuum, to investigate the nature of the light-induced surface potential dynamics in alumina-passivated crystalline silicon, and in an organic bulk heterojunction thin film based on the PTB7-PC 71 BM tandem. In both cases, we demonstrate that it is possible to identify and separate the contributions of two different kinds of photo-induced charge distributions that give rise to potential shifts with opposite polarities, each characterized by different dynamics. The data acquired on the passivated crystalline silicon are shown to be fully consistent with the band-bending at the silicon-oxide interface, and with electron trapping processes in acceptors states and in the passivation layer. The full sequence of events that follow the electron-hole generation can be observed on the pp-KPFM curves, i.e. the carriers spatial separation and hole accumulation in the space charge area, the electron trapping, the electron-hole recombination, and finally the electron trap-release. Two dimensional dynamical maps of the organic blend photo-response are obtained by recording the pump-probe KPFM curves in data cube mode, and by implementing a specific batch processing protocol. Sample areas displaying an extra positive SPV component characterized by decay time-constants of a few tens of microseconds are thus revealed, and are tentatively attributed to specific interfaces formed between a polymer-enriched skin layer and recessed acceptor aggregates. Decay time constant images of the negative SPV component confirm that the acceptor clusters act as electron-trapping centres. Whatever the photovoltaic technology, our results exemplify how some of the SPV components may remain completely hidden to conventional SPV imaging by KPFM, with possible consequences in terms of photo-response misinterpretation. This work furthermore highlights the need of implementing time-resolved techniques that can provide a quantitative measurement of the time-resolved potential., (© 2022 IOP Publishing Ltd.)

The synthesis of four non-fullerene acceptors (NFAs) with a "A-π-D-π-A" structure, in which the electron-donating core is extended, was achieved. The molecules differed by the nature of the solubilizing groups on the π-spacer and/or the presence of fluorine atoms on the peripheral electron-accepting units. The optoelectronic properties of the molecules were characterized in solution, in thin film, and in photovoltaic devices. The nature of the solubilizing groups had a minor influence on the optoelectronic properties but affected the organization in the solid state. On the other hand, the fluorine atoms influenced the optoelectronics properties and increased the photo-stability of the molecules in thin films. Compared to reference ITIC, the extended molecules showed a wider absorption across the visible range and higher lowest unoccupied molecular orbital energy levels. The photovoltaic performances of the four NFAs were assessed in binary blends using PM6 (PBDB-T-2F) as the donating polymer and in ternary blends with ITIC-4F. Solar cells (active area 0.27 cm 2 ) showed power conversion efficiencies of up to 11.1 % when ternary blends were processed from non-halogenated solvents, without any thermal post-treatment or use of halogenated additives, making this process compatible with industrial requirements., (© 2021 Wiley-VCH GmbH.)

An implementation of pump-probe Kelvin probe force microscopy (pp-KPFM) is reported that enables recording the time-resolved surface potential in single-point mode or over a 2D grid. The spectroscopic data are acquired in open z -loop configuration, which simplifies the pp-KPFM operation. The validity of the implementation is probed by measurements using electrical pumping. The dynamical photoresponse of a bulk heterojunction solar cell based on PTB7 and PC 71 BM is subsequently investigated by recording point-spectroscopy curves as a function of the optical power at the cathode and by mapping 2D time-resolved images of the surface photovoltage of the bare organic active layer., (Copyright © 2020, Grévin et al.; licensee Beilstein-Institut.)