Search

The two-tailed cationic surfactant dioctadecyldimethyl ammonium bromide (DODAB) produces semi-permanent coatings that yield strongly reversed electroosmotic flow (EOF), for example -0.31 ± 0.01 cm 2 kV -1 s -1 at pH 3.5. Moreover, these coatings are easy to prepare, regenerable, cost effective, and yield high efficiency (520 000-900 000 plates per m) separations of cationic proteins over many runs under acidic (pH 3.5) conditions. Given the quaternary amine functionality of DODAB, we were surprised to observe that DODAB coatings become unstable at pH > 7. At pH 7.2, the EOF of a DODAB coated capillary drifted from reversed to cathodic over only 5 runs, and protein separations became severely compromised. By pH 12, no EOF reversal was observed. Electrophoretic and mass spectrometric studies demonstrate that the coating decomposition involves a surface conversion of the quaternary amine in DODAB to a variety of products, although the exact mechanism remains elusive. Regardless, the results herein demonstrate that semi-permanent coatings based on cationic two-tailed surfactants such as DODAB are limited to separations using acidic buffers.

A sequential surfactant bilayer/diblock copolymer coating was previously developed for the separation of proteins. The coating is formed by flushing the capillary with the cationic surfactant dioctadecyldimethylammonium bromide (DODAB) followed by the neutral polymer poly-oxyethylene (POE) stearate. Herein we show the method development and optimization for capillary isoelectric focusing (cIEF) separations based on the developed sequential coating. Electroosmotic flow can be tuned by varying the POE chain length which allows optimization of resolution and analysis time. DODAB/POE 40 stearate can be used to perform single-step cIEF, while both DODAB/POE 40 and DODAB/POE 100 stearate allow performing two-step cIEF methodologies. A set of peptide markers is used to assess the coating performance. The sequential coating has been applied successfully to cIEF separations using different capillary lengths and inner diameters. A linear pH gradient is established only in two-step CIEF methodology using 3-10 pH 2.5% (v/v) carrier ampholyte. Hemoglobin A(0) and S variants are successfully resolved on DODAB/POE 40 stearate sequentially coated capillaries., (Copyright © 2012 Elsevier B.V. All rights reserved.)

A surfactant bilayer/diblock polymer coating was previously developed for the separation of proteins. The coating consisted of a mixture of the cationic surfactant dioctadecyldimethylammonium bromide (DODAB) and the neutral polymer poly-oxyethylene (POE) 40 stearate (Journal of Chromatography A 1130 (2006) 265-271). Herein an improved method of generating DODAB/POE stearate coatings is demonstrated, which yields more predictable EOF, more stable coatings, greater average efficiencies and easier method development. In this sequential preparation method the DODAB is first flowed through the capillary, followed by a flow of the POE stearate (sequential method). A tunable EOF (-2.40 to -0.17 x 10⁻⁴ cm²/Vs) is achieved by varying the POE chain length (8, 40 and 100 oxyethylene units). Mixtures of POE 8 and POE 40 stearate enabled continuous variation in EOF from -2.44 to -0.42 x 10⁻⁴ cm²/Vs. Separations of basic proteins yielded efficiencies of 760,000-940,000 plates/m. Coatings formed using the sequential method were more stable over a larger number of runs (%RSD for migration times: 0.7-1.0% over 30 runs) than those formed using the original mixed method (%RSD: 2.4-4.6% over 14 runs). The ability to tune the EOF is important in maximizing the resolution of analytes with similar electrophoretic mobilities. Histone proteins are separated on a sequentially coated capillary with resolution of nine possible subtypes. Acidic proteins are separated on a sequentially coated capillary at pH 6.4., (Copyright © 2010 Elsevier B.V. All rights reserved.)

The cationic surfactants didodecyldimethylammonium bromide (DDAB) and dioctadecyldimethyl-ammonium bromide (DODAB) have previously been shown to form semi-permanent coatings that effectively prevent adsorption of cationic proteins in fused silica capillaries with inner diameters of 25-75 µm. This paper investigates the impact that narrower capillary diameters (≤25 µm) have on the stability of surfactant bilayer coatings and the efficiency of separations of model cationic proteins and neurotransmitters. Using a DODAB-coated 5 µm i.d. capillary 210 consecutive protein separations (1050 min) were performed without recoating the capillary between runs. Separation efficiencies of 1,400,000-2,000,000 plates per m (340,000-430,000 plates) were obtained. Migration time reproducibilites of 6.8% RSD were observed for 300 injections performed over a 30 day period without any regeneration of the coating. Neurotransmitters were separated with efficiencies ranging from 470,000-610,000 plates per m (110,000-140,000 plates) in a 5 µm capillary.

The two stereo-isomers; quinine and quinidine have been determined in their mixtures in the IR region using chemometric multivariate methods, principal component regression (PCR) and partial least squares (PLS). A training set of thirty synthetic binary mixture solutions in the possible combinations containing 0.0 - 4.0 and 4.0 - 0.0% w/v quinine and quinidine, respectively in chloroform was used to develop the multivariate calibrations. A validation set containing thirty synthetic binary mixtures of variable ratios in the range of 0.2 - 4.0 and 4.0 - 0.2% w/v for quinine and quinidine, respectively in chloroform was used to validate the developed calibrations. The results of analysis of the validation synthetic mixtures were found to be 100.5+/-0.44% (R.S.D.%=0.44) and 100.5+/-0.38% (R.S.D.%=0.38) for quinine and 100.1+/-0.67% (R.S.D.%=0.67) and 100.1+/-0.68% (R.S.D.%=0.68) for quinidine using PCR and PLS models, respectively.