Search

High power impulse magnetron sputtering (HiPIMS) discharges with a zirconium target are studied experimentally and by applying the ionization region model (IRM). The measured ionized flux fraction lies in the range between 25% and 59% and increases with increased peak discharge current density ranging from 0.5 to 2 A/cm(2) at a working gas pressure of 1 Pa. At the same time, the sputter rate-normalized deposition rate determined by the IRM decreases in accordance with the HiPIMS compromise. For a given discharge current and voltage waveform, using the measured ionized flux fraction to lock the model, the IRM provides the temporal variation of the various species and the average electron energy within the ionization region, as well as internal discharge parameters such as the ionization probability and the back-attraction probability of the sputtered species. The ionization probability is found to be in the range 73%-91%, and the back-attraction probability is in the range 67%-77%. Significant working gas rarefaction is observed in these discharges. The degree of working gas rarefaction is in the range 45%-85%, higher for low pressure and higher peak discharge current density. We find electron impact ionization to be the main contributor to working gas rarefaction, with over 80% contribution, while kick-out by zirconium atoms and argon atoms from the target has a smaller contribution. The dominating contribution of electron impact ionization to working gas rarefaction is very similar to other low sputter yield materials., QC 20240828

Here, we compare the ionization region model (IRM) against experimental measurements of particle densities and electron temperature in a high power impulse magnetron sputtering discharge with a tungsten target. The semi-empirical model provides volume-averaged temporal variations of the various species densities as well as the electron energy for a particular cathode target material, when given the measured discharge current and voltage waveforms. The model results are compared to the temporal evolution of the electron density and the electron temperature determined by Thomson scattering measurements and the temporal evolution of the relative neutral and ion densities determined by optical emission spectrometry. While the model underestimates the electron density and overestimates the electron temperature, the temporal trends of the species densities and the electron temperature are well captured by the IRM., Funding Agencies|Icelandic Research Fund [196141]; Swedish Research Council [VR 2018-04139]; Swedish Government Strategic Research Area in Materials Science on Functional Materials at Linkoping University [2009-00971]

The ionization region model (IRM) is applied to model a high power impulse magnetron sputtering discharge with a tungsten target. The IRM gives the temporal variation of the various species and the average electron energy, as well as internal discharge parameters such as the ionization probability and the back-attraction probability of the sputtered species. It is shown that an initial peak in the discharge current is due to argon ions bombarding the cathode target. After the initial peak, the W+ ions become the dominating ions and remain as such to the end of the pulse. We demonstrate how the contribution of the W+ ions to the total discharge current at the target surface increases with increased discharge voltage for peak discharge current densities J (D,peak) in the range 0.33-0.73 A cm(-2). For the sputtered tungsten the ionization probability increases, while the back-attraction probability decreases with increasing discharge voltage. Furthermore, we discuss the findings in terms of the generalized recycling model and compare to experimentally determined deposition rates and find good agreement., Funding Agencies|Icelandic Research Fund [196141]; Free State of Saxony; European Regional Development Fund [100336119]; Swedish Government Strategic Research Area in Materials Science on Functional Materials at Linkoping University [2009-00971]