Search

Introduction: Studies evaluating guided bone regeneration (GBR) on knife-edge ridges using absorbable membranes with staged approaches have reported various horizontal bone gains. This study compared the horizontal bone gain obtained via a conventional technique of GBR and a recently-reported technique. Bone loss during the healing process was also measured., Methods: Consecutive patients who underwent GBR on knife-edge ridges via a conventional technique (control group) or the Sausage Technique (test group) were included in this study. GBR was performed using a collagen membrane and deproteinized bovine bone mineral combined with an autogenous graft at a 1:1 ratio. Cone-beam computed tomography (CBCT) was performed preoperatively, postoperatively, and after the patient healed. Horizontal bone width was measured on CBCT images 2 mm apical from the top of the crest. The preoperative CBCT and posthealing CBCT were superimposed to calculate the bone gain after healing, and the preoperative and postoperative CBCT scans were superimposed to calculate the bone gain after surgery. Bone loss during healing was calculated by subtracting the width of the ridge after healing from the postoperative width., Results: The mean horizontal bone gain was significantly lower in the control group (2.7 ± 1.8 mm; 83.2%) than in the test group (5.3 ± 2.3 mm; 216.8%) (p = 0.003). The average horizontal bone loss between regeneration and implant placement was 0.9 mm in the control group (27.9%) and 2.1 mm in the test group (29.4%). While the absolute bone loss was significantly different (p = 0.012), the percentage of bone resorption was not (p = 0.608)., Conclusion: The new technique resulted in significantly more bone gain than a conventional GBR technique. The rate of graft resorption during healing was stable regardless of the amount of grafted material., (© 2022 Wiley Periodicals LLC.)

Background: Primary stability can be improved by using a tapered implant in a slightly underprepared implant site. This may lead to high compression forces and elevated insertion torques. It has been postulated that disturbance of the local microcirculation may occur, leading to necrosis of the osteocytes and bone resorption., Purpose: Report on the clinical outcome of 42 implants placed with an insertion torque equal or greater than 70 Ncm and evaluate bone levels around these implants., Materials and Methods: This prospective study included 48 patients treated with 66 4.5 mm diameter Tapered Screw-Vent implants (Zimmer Dental®, Carlsbad, CA, USA). Maximum insertion torque (MIT) was recorded with an electronic torque measuring device (Tohnichi® STC200CN, Hitachi, Tokyo, Japan). Nine implants (control group) presented MIT between 30 and 50 Ncm (mean = 37.1 Ncm) and 42 implants (experimental group) MIT greater than 70 Ncm (mean = 110.6 Ncm, range: 70.8-176 Ncm). Marginal bone levels were recorded at the time of loading and 1 year later for the two groups., Results: After 2-3 months of non-sumerged healing, all implants were clinically stable. Mean marginal bone resorption was 1.03 mm (SD = 0.44) for the control group (low torque) and 0.72 mm (SD = 0.56) for the experimental group (high torque) at time of loading, and 1.09 (SD = 0.62) and 1.24 mm (SD = 0.75), respectively, after 1 year. There were no significant differences between the two groups for bone stability and implant success rate., Conclusions: The use of high insertion torques (up to 176 Ncm) did not prevent osseointegration. Marginal bone levels in the control and experimental groups were similar both at the time of loading and 1 year later., (© 2011 Wiley Periodicals, Inc.)