Search

This commentary addresses data quality in equilibrium solubility measurement in aqueous solution. Broadly discussed is the “gold standard” shake-flask (SF) method used to measure equilibrium solubility of ionizable drug-like molecules as a function of pH. Many factors affecting the quality of the measurement are recognized. Case studies illustrating the analysis of both solution and solid state aspects of solubility measurement are presented. Coverage includes drug aggregation in solution (sub-micellar, micellar, complexation), use of mass spectrometry to assess aggregation in saturated solutions, solid state characterization (salts, polymorphs, cocrystals, polymorph creation by potentiometric method), solubility type (water, buffer, intrinsic), temperature, ionic strength, pH measurement, buffer issues, critical knowledge of the pKa, equilibration time (stirring and sedimentation), separating solid from saturated solution, solution handling and adsorption to untreated surfaces, solubility units, and tabulation/graphic presentation of reported data. The goal is to present cohesive recommendations that could lead to better assay design, to result in improved quality of measurements, and to impart a deeper understanding of the underlying solution chemistry in suspensions of drug solids.

The Potentiometric Cycling for Polymorph Creation [PC] 2has been applied to sparfloxacin, a third-generation fluoroquinolone antibiotic. Two different trihydrate phases precipitate from aqueous solution. X-ray data indicate that one of these is a previously unknown polymorph of sparfloxacin trihydrate. Because both forms crystallize from solution at the same time, the two crystalline forms are concomitant polymorphs that precipitate in a thermodynamically controlled ratio. [ABSTRACT FROM AUTHOR]

The solubility in water of diclofenac (2-(2,6-dichlorophenyl)aminophenylacetic acid), a potent nonsteroidal anti-inflammatory drug, has been investigated. The various solid forms have been characterized by thermogravimetric analysis, differential scanning calorimetry, and X-ray diffraction. The commercially available form of diclofenac is the anhydrous sodium salt. This was recrystallized from ethanol and precipitated as a hydrate containing four diclofenac anions, four sodium cations, and nineteen water molecules per unit cell. This crystal structure is similar to but different from an earlier report of the structure. Crystals of the acid form of diclofenac were anhydrous and corresponded to an earlier crystal structure. Separate solubility measurements on all three of these solid forms of diclofenac gave consistent results for the intrinsic solubility. The aqueous solubility values reported in the literature for diclofenac are spread over a large range, with a factor of 100 separating the largest and the smallest. Our value is at the smaller end of this range. It is the only one supported by three independent procedures and rigorous characterization of the solid forms. The experimental conditions were precisely controlled. [ABSTRACT FROM AUTHOR]