Search

The diffusive gradients in thin films (DGT) technique has shown to be a useful tool for predicting metal bioavailability and toxicity in sediments, however, links between DGT measurements and biological responses have often relied on laboratory-based exposures and further field evaluations are required. In this study, DGT probes were deployed in metal-contaminated (Cd, Pb, Zn) sediments to evaluate relationships between bioaccumulation by the freshwater bivalve Hyridella australis and DGT-metal fluxes under both laboratory and field conditions. The DGT-metal flux measured across the sediment/water interface (±1 cm) was useful for predicting significant cadmium and zinc bioaccumulation, irrespective of the type of sediment and exposure. A greater DGT-Zn flux measured in the field was consistent with significantly higher zinc bioaccumulation, highlighting the importance of performing metal bioavailability assessments in situ. In addition, DGT fluxes were useful for predicting the potential risk of sub-lethal toxicity (i.e., lipid peroxidation and lysosomal membrane damage). Due to its ability to account for multiple metal exposures, DGT better predicted bioaccumulation and toxicity than particulate metal concentrations in sediments. These results provide further evidence supporting the applicability of the DGT technique as a monitoring tool for sediment quality assessment. DGT was useful for predicting bioaccumulation and sublethal toxicity to organisms exposed to metal contaminated sediments irrespective of type of sediment and exposure.

The burrowing and feeding activities of benthic organisms can alter metal speciation in sediments and affect an organisms' exposure to metals. Recently, the performance of the in situ technique of diffusive gradients in thin films (DGT) for predicting metal bioavailability has been investigated in response to the increasing demand of considering contaminant bioavailability in sediment quality assessments. In this study, we test the ability of the DGT technique for predicting the metal bioavailability in clean and contaminated sediments that are being subjected to varying degrees of sediments disturbance: low bioturbation (bivalve Tellina deltoidalis alone) and high bioturbation (bivalve and actively burrowing amphipod, Victoriopisa australiensis). Significant release of DGT-labile Cd, Ni, Pb, and Zn, but lower Cu and Fe, occurred in the pore and overlying waters of sediments exposed to high bioturbation conditions, resulting in higher bioaccumulation of zinc in bivalves. Strong relationships were found between bioaccumulation of Pb and Zn and time-integrated DGT-metal fluxes, whereas poor relationships were obtained using total or dilute-acid extractable metal concentrations. This results demonstrate that DGT is a useful tool for assessing metal bioavailability in sediments and can provide useful predictions of metal bioavailable to benthic organisms in dynamic sediment environments.

The use of diffusive gradients in thin films (DGT) for predicting metal bioavailability was investigated by exposing the bivalve Tellina deltoidalis to an identical series of metal-contaminated sediments deployed simultaneously in the field and laboratory. To understand the differences in metal exposure occurring between laboratory and field-based bioassays, changes in metal fluxes to DGT probes in sediments, and metal concentrations and partitioning to porewaters and overlying waters were investigated. DGT-metal fluxes (Cu, Pb and Zn) were lower in the overlying waters of most field-bioassays compared to the laboratory, causing differences in Pb and Zn bioaccumulation between bivalves exposed to laboratory and field conditions. Overall, DGT-metal fluxes provided predictions of metal bioaccumulation similar to those obtained using dilute-acid extractable metal measurements. This study demonstrates that, irrespective of the physicochemical properties of the sediment and type of exposure (laboratory or field), sediments pose a significant risk of bioaccumulation by T. deltoidalis when the Cu, Pb and Zn DGT flux exceeds 3.5, 1.3 and 156 µg/h/m2, respectively. The results presented here support the use of the DGT technique for sediment quality assessment and the hypothesis that DGT-metal fluxes may potentially be useful surrogates for the lability of metals for all exposure routes.

Bioturbation alters the properties of sediments and modifies contaminant bioavailability to benthic organisms. These naturally occurring disturbances are seldom considered during the assessment of sediment quality. We investigated how the presence (High bioturbation) and absence (Low bioturbation) of a strongly bioturbating amphipod within three different sediments influenced metal bioavailability, survival and bioaccumulation of metals to the bivalve Tellina deltoidalis. The concentrations of dissolved copper decreased and manganese increased with increased bioturbation. For copper a strong correlation was observed between increased bivalve survival (53-100%) and dissolved concentrations in the overlying water. Increased bioturbation intensity resulted in greater tissue concentrations for chromium and zinc in some test sediments. Overall, the results highlight the strong influence that the natural bioturbation activities from one organism may have on the risk contaminants pose to other organisms within the local environment. The characterisation of field-based exposure conditions concerning the biotic or abiotic resuspension of sediments and the rate of attenuation of released contaminants through dilution or readsorption may enable laboratory-based bioassay designs to be adapted to better match those of the assessed environment.

In this study, a novel application of the diffusive gradients in thin films (DGT) technique as a monitoring tool for bioavailable metals in sediments is presented. DGT was tested using a wide range of marine and fresh water sediments that possessed a variety of chemical and physical properties. These were tested in both the laboratory and in the field. In the laboratory, the use of naturally contaminated sediments allowed the evaluation of the performance of the DGT technique under realistic environmental conditions (i.e. exposure to contaminant mixtures). Strong dose-response relationships were found between DGT-labile metal fluxes and toxicity to the marine amphipod Melita plumulosa. The combined flux of metals (Cd, Cu, Ni, Pb and Zn) measured at the sediment water interface (SWI) provided a robust measure of the bioavailable pool of metals present in the sediment and overlying water. A flux normalisation approach was adopted in an attempt to account for different toxicity caused by different metals, and this significantly improved the relationship between DGT and toxicity. The performance of the DGT technique to predict metal bioavailability was also investigated by comparing DGT-labile metal fluxes from identical metal contaminated sediments deployed in the field and under laboratory conditions with metal bioaccumulation in Tellina deltoidalis (marine bivalve) and Hyridella australis (freshwater bivalve). The combined laboratory and field results indicated that DGT-labile metal fluxes measured at the SWI provide robust predictions of metal bioaccumulation in Tellina deltoidalis (marine bivalve) and Hyridella australis (freshwater bivalve), irrespective of the type of exposure (laboratory vs field). There was a mismatch between laboratory and field bioassay results for both species which emphasised the importance of performing in situ tests for environmental risk assessments.

Laboratory-based bioaccumulation and toxicity bioassays are frequently used to predict the ecological risk of contaminated sediments in the field. This study investigates the bioassay conditions most relevant to achieving environmentally relevant field exposures. An identical series of metal-contaminated marine sediments were deployed in the field and laboratory over 31 days. Changes in metal concentrations and partitioning in both sediments and waters were used to interpret differences in metal exposure and bioaccumulation to the benthic bivalve Tellina deltoidalis. Loss of resuspended sediments and deposition of suspended particulate matter from the overlying water resulted in the concentrations of Cu, Pb and Zn (major contaminants) becoming lower in the 1-cm surface layer of field-deployed sediments. Lower exchange rates of overlying waters in the laboratory resulted in higher dissolved metal exposures. The prediction of metal bioaccumulation by the bivalves in field and laboratory was improved by considering the metal partitioning within the surface sediments.

Many sediment quality assessment frameworks incorporate contaminant bioavailability as a critical factor regulating toxicity in aquatic ecosystems. However, current approaches do not always adequately predict metal bioavailability to organisms living in the oxidised sediment surface layers. The deployment of the diffusive gradients in thin films (DGT) probes in sediments allows labile metals present in pore waters and weakly-bound to the particulate phase to be assessed in a time-integrated manner in situ. In this study, relationships between DGT-labile metal fluxes within 5 mm of the sediment-water interface and lethal and sub-lethal effects to the amphipod Melita plumulosa were assessed in a range of contaminated estuarine sediments during 10-day laboratory-based bioassays. To account for differing toxicities of metals, DGT fluxes were normalised to water (WQG) or sediment quality guidelines or toxicity thresholds specific for the amphipod. The better dose-response relationships appeared to be the one based on WQG-normalized DGT fluxes, which successfully predicted toxicity despite the wide range of metals and large variations in sediment properties. The study indicated that the labile fraction of metals measured by DGT is useful for predicting metal toxicity to benthic invertebrates, supporting the applicability of this technique as a rapid monitoring tool for sediments quality assessments.