Search

This study addressed the possibility of forming of co-amorphous systems between clozapine (CZ) and various carboxylic acid plasticizers (CAPs). The aim was to improve the solubility and oral bioavailability of clozapine. Co-amorphous dispersions were prepared using modified solvent evaporation methodology at drug/plasticizer stoichiometric ratios of 1:1, 1:1.5 and 1:2. Solid state characterization was performed using differential scanning calorimetry, X-ray diffraction and infra red spectroscopy. Highly soluble homogeneous co-amorphous dispersions were formed between clozapine and CAPs via hydrogen bonding. The co-amorphous dispersions formed with tartaric acid (1:2) showed the highest dissolution percentage (> 95 % in 20 minutes) compared to pure crystalline CZ (56 %). Highly stable solutions were obtained from co-amorphous CZ-citric and CZ-tartaric acid at 1:1.5 molar ratio. The prepared dispersions suggest the possibility of peroral or sublingual administration of highly soluble clozapine at a reduced dose with the great chance to bypass the first pass metabolism.

For the quantification of resveratrol (RV) in the Wistar rat skin, an ultra-performance liquid chromatography-mass spectrometric (UPLC–MS/MS) method was developed and validated on ACQUITY UPLC BEH C18 column (1.7 μm). The mobile phase ratio of methanol (A) and 2% formic acid (B) (ratio 10: 90% v/v, 80: 20 v/v) at isocratic elution with flow rate 0.3 mL/min, and run time 3 min was used for analysis. In addition, the use of multiple reaction monitoring (MRM)/ES+ mode to detect the analytes and to track parents to daughter ion transition of 229.17 > 107.04 m/z (time scan 3 min, retention time 1.48) for RV and curcumin as an internal standard shows 369.16 > 176.93m/z (scan time is 2.80 min, retention time is 1.11), respectively. Linearity was observed in the range of 2.5 to 2,000 ng/mL (R2 = 0.987). Precision and accuracy on rat skin were within the acceptability range (RE%: ±15; RSD%: ±15). Moreover, it showed a good percentage recovery and found within acceptance limit 90–110%. Lower limit of detection and quantitation for the method observed to be 2.5 and 20 ng.mL−1, respectively. Method application indicated successful determination of dermatokinetics parameters of RV from lipospheres gel and suspension in the rats. [ABSTRACT FROM AUTHOR]

Improvement of water solubility, dissolution rate, oral bioavailability, and reduction of first pass metabolism of OL (OL), were the aims of this research. Co-amorphization of OL carboxylic acid dispersions at various molar ratios was carried out using rapid solvent evaporation. Characterization of the dispersions was performed using differential scanning calorimetry (DSC), Fourier transform infrared spectrometry (FTIR), X-ray diffractometry (XRD), and scanning electron microscopy (SEM). Dispersions with highest equilibrium solubility were formulated as fast dissolving oral films. Modeling and optimization of film formation were undertaken using artificial neural networks (ANNs). The results indicated co-amorphization of OL-ascorbic acid through H-bonding. The co-amorphous dispersions at 1:2 molar ratio showed more than 600-fold increase in solubility of OL. The model optimized fast dissolving film prepared from the dispersion was physically and chemically stable, demonstrated short disintegration time (8.5 s), fast dissolution (97% in 10 min) and optimum tensile strength (4.9 N/cm2). The results ofin vivodata indicated high bioavailability (144 ng h/mL) and maximum plasma concentration (14.2 ng/mL) compared with the marketed references. Therefore, the optimized co-amorphous OL-ascorbic acid fast dissolving film could be a valuable solution for enhancing the physicochemical and pharmacokinetic properties of OL. [ABSTRACT FROM PUBLISHER]