Search

ULTRASAT (ULtra-violet TRansient Astronomy SATellite) is a wide-angle space telescope that will perform a deep time-resolved all-sky survey in the near-ultraviolet (NUV) spectrum. The science objectives are the detection of counterparts to short-lived transient astronomical events such as gravitational wave sources and supernovae. The mission is led by the Weizmann Institute of Science and is planned for launch in 2026 in collaboration with the Israeli Space Agency and NASA. DESY will provide the UV camera, composed by the detector assembly located in the telescope focal plane and the remote electronics unit. The camera is composed out of four back-metallized CMOS Image Sensors (CIS) manufactured in the 4T, dual gain Tower process. As part of the radiation qualification of the camera, Single Event Effect (SEE) testing has been performed by irradiating the sensor with heavy ions at the RADEF, Jyvaskyla facility. Preliminary results of both Single Event Upset (SEU) and Single Event Latch-up (SEL) occurrence rate in the sensor are presented. Additionally, an in-orbit SEE rate simulation has been performed in order to gain preliminary knowledge about the expected effect of SEE on the mission.

ULTRASAT (ULtraviolet TRansient Astronomy SATellite) is a wide-angle space telescope that will perform deep time-resolved surveys in the near-ultraviolet spectrum. ULTRASAT is a space mission led by the Weizmann Institute of Science and the Israel Space Agency and is planned for launch in 2025. The camera implements backside-illuminated, stitched pixel sensors. The pixel has a dual-conversion-gain 4T architecture, with a pitch of $9.5$ $\mu m$ and is produced in a $180$ $nm$ process by Tower Semiconductor. Before the final sensor was available for testing, test sensors provided by Tower were used to gain first insights into the pixel's radiation tolerance. One of the main contributions to sensor degradation due to radiation for the ULTRASAT mission is Total Ionizing Dose (TID). TID measurements on the test sensors have been performed with a Co-60 gamma source at Helmholz Zentrum Berlin and CC-60 facility at CERN and preliminary results are presented., Comment: Part of the conference: Frontier Detectors for Frontier Physics: 15th Pisa Meeting on Advanced Detectors, La Biodola - Isola d'Elba Published in: Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment Available online 15 June 2023, 168463. In Press, Journal Pre-proof

The Ultraviolet Transient Astronomical Satellite is a scientific space mission carrying an astronomical telescope. The mission is led by the Weizmann Institute of Science in Israel and the Israel Space Agency, while the camera in the focal plane is designed and built by Deutsches Elektronen Synchrotron in Germany. Two key science goals of the mission are the detection of counterparts to gravitational wave sources and supernovae. The launch to geostationary orbit is planned for 2024. The telescope with a field-of-view of $\approx200$deg$^2$, is optimized to work in the near-ultraviolet band between $220$ and $280$nm. The focal plane array is composed of four $22.4$-megapixel, backside-illuminated CMOS sensors with a total active area of 90x90mm$^2$. Prior to sensor production, smaller test sensors have been tested to support critical design decisions for the final flight sensor. These test sensors share the design of epitaxial layer and anti-reflective coatings (ARC) with the flight sensors. Here, we present a characterization of these test sensors. Dark current and read noise are characterized as a function of the device temperature. A temperature-independent noise level is attributed to on-die infrared emission and the read-out electronics` self-heating. We utilize a high-precision photometric calibration setup to obtain the test sensors` quantum efficiency (QE) relative to PTB/NIST-calibrated transfer standards ($220$-$1100$nm), the quantum yield for $\lambda < 300$nm, the non-linearity of the system, and the conversion gain. The uncertainties are discussed in the context of the newest results on the setup`s performance parameters. From three ARC options, Tstd, T1 and T2, the latter optimizes out-of-band rejection and peaks in the mid of the ULTRASAT operational waveband (max. QE $\approx80\%$ at $245\mathrm{nm}$). We recommend ARC option T2 for the final ULTRASAT UV sensor.

The Ultraviolet Transient Astronomical Satellite (ULTRASAT) is a scientific UV space telescope that will operate in geostationary orbit. The mission, targeted to launch in 2024, is led by the Weizmann Institute of Science (WIS) in Israel and the Israel Space Agency (ISA). Deutsches Elektronen Synchrotron (DESY) in Germany is tasked with the development of the UV-sensitive camera at the heart of the telescope. The camera's total sensitive area of ~90mm x 90mm is built up by four back-side illuminated CMOS sensors, which image a field of view of ~200 deg2. Each sensor has 22.4 megapixels. The Schmidt design of the telescope locates the detector inside the optical path, limiting the overall size of the assembly. As a result, the readout electronics is located in a remote unit outside the telescope. The short focal length of the telescope requires an accurate positioning of the sensors within +-50 mu along the optical axis, with a flatness of +-10 mu. While the telescope will be at around 295K during operations, the sensors are required to be cooled to 200K for dark current reduction. At the same time, the ability to heat the sensors to 343K is required for decontamination. In this paper, we present the preliminary design of the UV sensitive ULTRASAT camera., Comment: "UV, X-Ray, and Gamma-Ray Space Instrumentation for Astronomy XXII", Proc. SPIE 11821, Optics and Photonics, 11821-21 (August, 2021). Contact authors Rolf Buehler (rolf.buehler@desy.de) and Merlin Barschke (merlin.barschke@desy.de)