Search

Abstract: The present work describes the surface improvement and biocompatibility of TiAl24Nb10 intermetallic alloy using rf plasma nitriding. The nitriding process was carried out at different plasma power from 400W to 650W where the other plasma conditions were fixed. Grazing incidence X-ray diffractometry (GIXRD), Auger electron spectroscopy (AES), tribometer and a nanohardness tester were employed to characterize the nitrided layer. Further potentiodynamic polarization method was used to describe the corrosion behavior of the un-nitrided and nitrided alloy. It has been found that the Vickers hardness (HV) and corrosion resistance values of the nitrided layers increase with increasing plasma power while the wear rates of the nitrided layers reduce by two orders of magnitude as compared to those of the un-nitrided layer. This improvement in surface properties of the intermetallic alloy is due to formation of a thin modified layer which is composed of titanium nitride in the alloy surface. Moreover, all modified layers were tested for their sustainability as a biocompatible material. Concerning the application area of biocompatibility, the present treated alloy show good surface properties especially for the nitrided alloy at low plasma power of 400W. [Copyright &y& Elsevier]

The depth dependence of elemental composition, phase distribution, and cross-sectional morphology of rf plasma nitrocarburized 304 austenitic stainless steel were investigated using glow discharge optical spectroscopy (GDOS), grazing incidence X-ray diffraction (GIXRD), and optical microscopy, respectively. A step-wise mechanical polishing method was used to remove successive sublayers of the treated surface. It was found that the properties of the nitrocarburized layer depend critically on the plasma gas composition, which controls the supersaturation of nitrogen and carbon through the compound layer depth. Iron nitride phases and/or nitrogen-expanded austenite (γN) were detected in the nitrocarburized layer prepared at high plasma nitrogen (N2) content. In the compound layer processed at high plasma carbon (C2H2) content, besides the carbon-expanded austenite phase (γC), carbide phases were found predominantly in the top-layer, in which the carbon concentration has a maximum value of ∼2 wt.%. The lattice expansion of the expanded austenite phases changes with sampling depth, depending on local variations in nitrogen and carbon content. The applied rf plasma processing power influences significantly nitrogen and carbon distribution in the treated sublayers. [Copyright &y& Elsevier]

Adding C2H2 gas to nitrogen gas during r.f. plasma processing has significant influence on the properties of 304 austenitic stainless steel. The elemental depth profiles of the compound layer were investigated by glow discharge optical spectroscopy. Different treatment gas compositions of N2/C2H2 mixtures (0–100% in steps of 10 or 5% in some cases) have been investigated. The total gas pressure during the plasma processing was 8.4×10-2 mbar. The sample temperature was approximately 550 °C with an insignificant variation for different gas compositions. A high rate of diffusion of carbonitriding has been obtained without initial sputter removal of the surface oxide layer, which demonstrates that the surface oxide layer does not play a crucial role during r.f. plasma carburizing and carbonitriding of stainless steel. The nitrogen concentration and the compound layer thickness increase, when 10% of C2H2 is added. With further increase in the C2H2 ratio, they decrease again gradually. The carbon depth profiles for the same samples show lower concentration and opposite tendency with respect to the nitrogen content. X-ray diffraction was used to characterize the microstructure of the compound layers. Fe2N, Fe3N, CrN, nitrogen-expanded austenite (γn) and carbon-expanded austenite (γc) phases are detected. The relative proportions of the phases are critically dependent on the N2/C2H2 ratio. Depending on the N2/C2H2 ratio, the microhardness value increases by a factor between 2 and 6. The carbonitrid layer exhibits a corrosion resistance better than pure nitrided and carburized layers. [Copyright &y& Elsevier]