Search

The effective use of rainwater is a key issue in agricultural development in arid and semi-arid regions. The tillage system as an important soil management measure can affect the rainwater retention, soil moisture content, and in consequence crop yield in rainfed lands. This study was conducted to evaluate the effects of slope gradient and tillage direction on rainwater use efficiency (RWUE) in rainfed lands in Zanjan Province. The field experiment was performed in five slope gradients (12.6, 15.3, 17, 19.4, and 22%) and two tillage directions (along slope and on contour tillage) at two replications. Mass soil water content was determined at 5-day intervals and runoff was measured after rainfalls. Wheat grain yield was determined for each plot and RWUE was computed using the proportion of wheat grain yield and precipitation. Base on the results, runoff, soil moisture, wheat grain yield, and RWUE were affected by tillage directions, so that runoff in contour line tillage decreased about 6.4 times compared to along slope tillage and in consequence increased soil moisture, wheat grain yield, and RWUE about 8.7, 24.8, and 24.8%, respectively. Increasing runoff production in contour line tillage at steeper slopes was associated with a lower capacity of cultivated furrows that strongly declined soil water retention and negatively affected wheat grain yield and RWUE in the lands. This study revealed that the efficiency of the contour tillage in water retention and RWUE decreases in steeper slopes in rainfed lands.

Few studies have been done regarding the role of the raindrop in the hydrodinamic mechanism of soil erosion. In this study, rainfall simulation experiments were conducted to evaluate the role of raindrop in runoff discharge, sediment concentration and hydraulic properties of flow under four slope gradients (5, 10, 15 and 20%) in a clay soil using a 90 mm.h-1 rainfall intensity to reach the steady state flow. Soil sample was packed into the erosion flume with 0.3m× 0.4m × 4 m in dimensions and tested under two soil surface conditions: one with raindrop impact and one without raindrop impact. The results showed that runoff discharge, sediment concentration, flow depth, shear stress, stream power, Reynolds number and runoff velocity under without raindrop impact condition were significantly lower than those in the condition with the raindrop impact with a factor of 0.62 to 3.54, 0.08 to 11.83, 0.91 to 0.96, 0.26 to 3.25, 0.52 to 4.45, and 0.36 to 3.27, 0.23 to 0.79 times, respectively; on the other hand, the Darcy Wysbach, Chezy and Manning coefficients were increased significantly under without raindrop impact (P

Sloping farmlands are the major sources of soil, water and nutrient losses in arid and semi-arid regions. Information about the impacts of different tillage practices on soil erosion, nutrient loss and crop nutrient uptake on the sloping farmland of semi- arid soil is, however, limited. This study was carried out to investigate the effects of tillage direction on soil, water, nitrogen and phosphorous losses and their uptake by plant in a rainfed wheat land. Field experiments were conducted in two tillage directions: downslope tillage and contour line tillage with four fertilization treatments: control, urea, triple superphosphate, and urea + triple superphosphate at the field plots with 1.75 m ´ 8 m in dimensions by using the randomized completely block design at three replications in Zanjan Township during 2014-2015. According to the results, Significant differences were found between the two tillage practices in soil loss (P < 0.001), water loss (P < 0.001), nitrogen loss soil loss (P < 0.001), and nitrogen uptake by wheat grain (P < 0.001), while phosphorous loss and its uptake did not show any statistically significant difference. Soil and water loss in the downslope tilled plots was 1.65 and 2.50 times higher than the contour line tillage, respectively. Nitrogen loss in the downslope tilled plots was 1.29 times more than that in the contour line tilled plots. Nitrogen loss in the plots was attributed to soil and water loss, so significant relationships were observed between nitrogen loss and soil loss (R2 = 0.59) and water loss (R2 = 0.55). This study, therefore, revealed that the tillage direction is an important factor controlling runoff, soil loss, and nitrogen loss and its uptake by wheat in the rainfed lands of semi-arid regions. Application of the contour tillage is, therefore, the first step to conserve soil and water and to improve soil productivity in these regions.

Modeling of Near-Surface Temperature Lapse Rate (NSTLR) is very important in various environmental applications. The Land Surface Temperature (LST) is influenced by many properties and conditions including surface biophysical and topographic characteristics. Some researches have considered the LST - Digital Elevation Model (DEM) feature space to model NSTLR. However, the influence of detailed surface characteristics is rare. This study investigated the impact of surface characteristics on the LST-DEM feature space for NSTLR modeling. A set of remote sensing data including Landsat 8 images, MODIS products, and surface features including DEM and land use of the Balikhli-Chay on 01/07/2018, 18/08/2018 and 03/09/2018 were collected and used in this study. First, Split Window (SW) algorithm was used to estimate LST, and spectral indices were employed to model surface biophysical characteristics. Owing to the impact of surface biophysical and topographic characteristics on the LST-DEM feature space, the NSTLR was calculated for different classes of surface biophysical characteristics, land use, and solar local incident angle. The modeled NSTLR values based on the LST-DEM feature space on 01/07/2018, 18/08/2018 and 03/09/2018 were 8.5, 1.5 and 2.4 °C Km−1; respectively. The NSTLR in different classes of surface biophysical characteristics, land use type and topographical parameters were variable between 0.5 to 14 °C Km−1. This clearly showed the dependence of NSTLR on topographic and biophysical conditions. This provides a new way of calculating surface characteristic specific NSTLR.

Sediment selectivity during transport may provide basic information for evaluating on-site and off-site impacts of the soil erosion. Limited information is, however, available on the selectivity of sediments in rill erosion, particularly in the rainfed furrows. Toward this, the sediment selectivity was investigated in three soil textures (loam, loamy sand sand clay loam) under 10% slope using 90 mm.h-1 rainfall intensity for 40 min. Soil samples were passed from a 10 mm sieve and packed in to the erosion flume with 0.4m × 4 m in dimensions. Particles size distribution (PSD) was determined in the sediments (PSDs) and compared with the original soil PSD (PSDo). The proportion of PSDs and PSDo was stated as PSDs/PSDo to show the selectivity of soil particles by rill erosion. Based on the results, all three soils appeared as the coarse particles (coarse sand and very coarse sand) in sediments with the PSDs/PSDo>1, indicating the higher selectivity of these particles by rill erosion. Loamy sand was the most susceptible soil to rill erosion among the studied soils, which generated a higher runoff (0.0035 m2.s-1) and sediment load (0.1 kg.m-1.s-1) during rainfall. The PSDs of this soil were similar to those of the original soil PSD. This study revealed that the stability of aggregates could be regarded as the major soil factor controlling rill erosion rate and the sediment selectivity in the semi-arid soils. With an increase in the water-stable aggregates, soil infiltration rate and as a consequence, shear stress of flow could be decreased in the rills.

The aim of this current research was to investigate airborne fungi in indoor environments at primary schools. The study also examined the correlation between these fungi and building characteristics, as well as some geographical and meteorological parameters. To achieve this aim, a passive sampling method was used. In this study, 148 samples were collected from the indoor environments of 24 schools located in Qom, Iran. To collect the samples, passive sampling was performed using Petri plates containing Sabouraud dextrose agar (SDA). The characteristics of school buildings were evaluated by checklist. The mean ± SD fungal load of indoor air in selected schools was found to be 10.1 ± 14.0 colonies (CFU/dm2 / h). According to the IMA standard, the majority of the classes (71.7%) were in very good condition. The dominant species were as follows: "Aspergillus niger," "Aspergillus candidus," and "Aspergillus flavus." Furthermore, the fungal load of girls' schools was significantly higher than that of the boys' schools (p < 0.05). The correlation analysis using the Pearson test showed that there was a direct correlation between the mean fungal load of classrooms and the number of students (p < 0.01). The highest concentration of fungi was found on the ground floor and in poor ventilation conditions (p < 0.05). During the study, it was found that schools located in the western part of Qom, Iran, had a higher concentration of fungi. This can be attributed to their exposure to the prevailing winds and the penetration of outdoor dusty air into indoor environments. The large number of students in each class and the inappropriate ventilation, which are the causes of airborne culturable fungi of these classes, call for the need for proper operation of school buildings.

Introduction: Field plots are widely used in studies related to the measurements of soil loss and modeling of erosion processes. Research efforts are needed to investigate factors affecting the data quality of plots. Spatial scale or size of plots is one of these factors which directly affects measuring runoff and soil loss by means of field plots. The effect of plot size on measured runoff or soil loss from natural plots is known as plot scale effect. On the other hand, variability of runoff and sediment yield from replicated filed plots is a main source of uncertainty in measurement of erosion from plots which should be considered in plot data interpretation processes. Therefore, there is a demand for knowledge of soil erosion processes occurring in plots of different sizes and of factors that determine natural variability, as a basis for obtaining soil loss data of good quality. This study was carried out to investigate the combined effects of these two factors by measurement of runoff and soil loss from replicated plots with different sizes. Materials and Methods: In order to evaluate the variability of runoff and soil loss data seven plots, differing in width and length, were constructed in a uniform slope of 9% at three replicates at Koohin Research Station in Qazvin province. The plots were ploughed up to down slope in September 2011. Each plot was isolated using soil beds with a height of 30 cm, to direct generated surface runoff to the lower part of the plots. Runoff collecting systems composed of gutters, pipes and tankswere installed at the end of each plot. During the two-year study period of 2011-2012, plots were maintained in bare conditions and runoff and soil loss were measured for each single event. Precipitation amounts and characteristics were directly measured by an automatic recording tipping-bucket rain gauge located about 200 m from the experimental plots. The entire runoff volume including eroded sediment was measured on storm basis using the collection tanks. The collected runoff from each plot was then mixed thoroughly and a sample was taken for determining sediment concentration by weight. The per-storm soil loss was then obtained. Results and Discussion: A wide range of rainfall characteristics were observed during the study period.The results indicated that the maximum amount of coefficients of variation (CVs) for runoff and soil loss from replicated plots were 60 and 80 percent, respectively, which were considerably higher than the variability of soil characteristics from these plots. CV of runoff and soil loss data among the replicates decreased as a power function of mean runoff (R2= 0.661, P

This paper focused on the effect of pure torsion deformation and various torsion pitches on the mechanical properties of the commercial pure Al wires which has not been examined so far. The initial wires with diameter of 4 mm have been torsion deformed to different pitch length (PL). In order to investigate the effect of gradient microstructure caused by torsion deformation, three different pitch length of 15 mm, 20 mm and 30 mm are considered. The results revealed that the level of grain refinement is correlated with the amount of induced plastic shear strain by torsion deformation. For the wire with pitch length of 15 mm, the grain sizes decreased to about 106 μm and 47 μm in the wire center and edge from the initial size of about 150 μm of the annealed wire. The micro-hardness measurement results show a gradient distribution of hardness from the wire center to the wire surface that confirmed the increasing trend of plastic shear strain obtained by FE simulations. The hardness of annealed sample (35 HV) is increased up to 73 HV at the wire surface for the smallest pitch length. The yield and ultimate tensile strength of the torsion deformed wires are also increased up to about 85 MPa and 152 MPa from the initial values of 38 MPa and 103 MPa of the annealed one respectively while the maximum elongation reduced significantly.

It is more expensive to remove pollution from groundwater than to prevent it. Delineation areas that arevulnerable to surface pollutants is one of methods to prevent pollution of groundwater resources. Focusing on this issue, DRASTIC model was used for evaluation of vulnerability of Tabriz-plain aquifer to pollution and the aquifer vulnerability map was prepared. The study shows that main zone of the aquifer’s groundwater is low to modrate vulnerability to pollution (DRASTIC Index of 120-40) that consist of about 55.84% and areas with low, moderate to high, and high risk zones comprise 21.81,22.08.% and 0.26% of the studied area, respectively Two tests of sensitivity analyses were carried out: the map removal and the single-parameter sensitivity analyses. Based on the characteristics of the studied area, the results from both map removal and single-parameter sensitivity analyses showed that the depth to water table has the most significant impact on the vulnerability risk zone. By overlaying of the vulnerability and landuse maps the areas where are subjected to potential release of pollutants from the agricultural activities were determined .Nitrate ion concentration and SINTACS model confirms the results of the vulnerability assessment.

Understanding the motion of surface-rolling nanomachines has attracted lots of attention in recent studies, due to their ability in carrying molecular payloads and nanomaterials on the surface. Controlling the surface motion of these nanovehicles is beneficial in the fabrication of nano-transportation systems. In the present study, molecular dynamics (MD) simulations alongside the potential energy analysis have been utilized to investigate the motion of C60 and C60-based nanovehicles on the silicene monolayer. Nano-machine simulations are performed using molecular mechanic forcefield. Compared with graphene and hexagonal boron-nitride, the molecules experience a higher energy barrier on the silicene, which leads to a lower diffusion coefficient and higher activation energy of C60 and nanomachines. Overcoming the maximum energy barrier against sliding motion is more probable at higher temperatures where the nanomachines receive higher thermal energy. After evaluating the motion of molecules around local vacancies, we introduce a nanoroad structure that can restrict surface motion. The motion of C60 and nanovehicles over the surface is limited to the width of nanorods up to a certain temperature. To increase the controllability of the motion, a thermal gradient has been applied to the surface and the molecules move toward the lower temperature regions, where they find lower energy levels. Comparing the results of this study with other investigations regarding the surface motion of molecules on boron-nitride and graphene surfaces brings forth the idea of controlling the motion by silicene-based hybrid substrates, which can be further investigated.