Search

Glycerophospholipids are the major amphiphilic molecules found in the plasma membrane bilayer of all vertebrate cells. Involved in many biological processes, their huge structural diversity and large concentration scale make their thorough characterization extremely difficult in complex biological matrices. Mass spectrometry techniques are now recognized as being among the most powerful methods for the sensitive and comprehensive characterization of lipids. Depending on the experimental conditions used during electrospray ionization mass spectrometry experiments, glycerophospholipids can be detected as different molecular species (e.g. protonated, sodiated species) when analyzed either in positive or negative ionization modes or by direct introduction or hyphenated mass spectrometry-based methods. The observed ionized forms are characteristic of the corresponding phospholipid structures, and their formation is highly influenced by the polar head group. Although the fragmentation behavior of each phospholipid class has already been widely studied under low collision energy, there are no established rules based on charge-induced dissociation mechanisms for explaining the generation of fragment ions. In the present paper, we emphasize the crucial roles played by ion-dipole complexes and salt bridges within charge-induced dissociation processes. Under these conditions, we were able to readily explain almost all the fragment ions obtained under low-energy collision-induced dissociation for particular glycerophospholipids and lysoglycerophospholipids species including glycerophosphatidylcholines and glycerophosphatidylethanolamines. Thus, in addition to providing a basis for a better comprehension of phospholipid fragmentation processes, our work also highlighted some potentially new relevant diagnostic ions to signal the presence of particular lipid species.

The gas phase structures of several proteins have been studied by electron transfer dissociation (ETD) with and without prior collisional heating after electrospraying these proteins from native-like solutions into a quadrupole ion trap mass spectrometer. Without prior collisional heating, we find that ETD fragmentation is mostly limited to regions of the protein that are not spanned by the salt bridges known to form in solution. When protein ions are collisionally heated before ETD, new product ions are observed, and in almost all cases, these new ions arise from protein regions that are spanned by the salt bridges. Together these results confirm the existence of salt bridges in protein ions and demonstrate that a sufficient amount energy is required to disrupt these salt bridges in the gas phase. More interestingly, we also show that different salt bridges require different collisional activation voltages to be disrupted, suggesting that they have variable stabilities in the gas phase. These stabilities appear to be influenced by the gas-phase basicities of the involved residues and the presence of nearby charged residues. We also find that higher collisional activation voltages are needed to enable the formation of new product from sites spanned by multiple salt bridges.

There has been considerable debate about the contribution of salt bridges to the stabilization of protein folds, in spite of their participation in crucial protein functions. Salt bridges appear to contribute to the activity-stability trade-off within proteins by bringing high-entropy charged amino acids into close contacts during the course of their functions. The current study analyzes the modes of association of salt bridges (in terms of networks) within globular proteins and at protein-protein interfaces. While the most common and trivial type of salt bridge is the isolated salt bridge, bifurcated salt bridge appears to be a distinct salt-bridge motif having a special topology and geometry. Bifurcated salt bridges are found ubiquitously in proteins and interprotein complexes. Interesting and attractive examples presenting different modes of interaction are highlighted. Bifurcated salt bridges appear to function as molecular clips that are used to stitch together large surface contours at interacting protein interfaces. The present work also emphasizes the key role of salt-bridge-mediated interactions in the partial folding of proteins containing long stretches of disordered regions. Salt-bridge-mediated interactions seem to be pivotal to the promotion of "disorder-to-order" transitions in small disordered protein fragments and their stabilization upon binding. The results obtained in this work should help to guide efforts to elucidate the modus operandi of these partially disordered proteins, and to conceptualize how these proteins manage to maintain the required amount of disorder even in their bound forms. This work could also potentially facilitate explorations of geometrically specific designable salt bridges through the characterization of composite salt-bridge networks. Graphical abstract ᅟ.

Salt bridges are very common in proteins. But what drives the formation of protein salt bridges is not clear. In this work, we determined the strength of four salt bridges in the protein GB3 by measuring the ΔpK a values of the basic residues that constitute the salt bridges with a highly accurate NMR titration method at different temperatures. The results show that the ΔpK a values increase with temperature, thus indicating that the salt bridges are stronger at higher temperatures. Fitting of ΔpK a values to the van't Hoff equation yields positive ΔH and ΔS values, thus indicating that entropy drives salt-bridge formation. Molecular dynamics simulations show that the protein and solvent make opposite contributions to ΔH and ΔS. Specifically, the enthalpic gain contributed from the protein is more than offset by the enthalpic loss contributed from the solvent, whereas the entropic gain originates from the desolvation effect., (© 2017 Wiley-VCH Verlag GmbH & Co. KGaA, Weinheim.)

Modern computational chemistry methods provide a powerful tool for use in refining the geometry of proteins determined by X-ray crystallography. Specifically, computational methods can be used to correctly place hydrogen atoms unresolved by this experimental method and improve bond geometry accuracy. Using the semiempirical method PM7, the structure of the nucleotide-sanitizing enzyme MTH1, complete with hydrolyzed substrate 8-oxo-dGMP, was optimized and the resulting geometry compared with the original X-ray structure of MTH1. After determining hydrogen atom placement and the identification of ionized sites, the charge distribution in the binding site was explored. Where comparison was possible, all the theoretical predictions were in good agreement with experimental observations. However, when these were combined with additional predictions for which experimental observations were not available, the result was a new and alternative description of the substrate-binding site interaction. An estimate was made of the strengths and weaknesses of the PM7 method for modeling proteins on varying scales, ranging from overall structure to individual interatomic distances. An attempt to correct a known fault in PM7, the under-estimation of steric repulsion, is also described. This work sheds light on the specificity of the enzyme MTH1 toward the substrate 8-oxo-dGTP; information that would facilitate drug development involving MTH1. Graphical Abstract Overlay of the backbone traces of the two MTH1 protein chains (green and orange respectively) in PDB 3ZR0 and the equivalent PM7 structures (magenta and cyan respectively) each optimized separately.

Native electrospray ionization-mass spectrometry, with gas-phase activation and solution compositions that partially release subcomplexes, can elucidate topologies of macromolecular assemblies. That so much complexity can be preserved in gas-phase assemblies is remarkable, although a long-standing conundrum has been the differences between their gas- and solution-phase decompositions. Collision-induced dissociation of multimeric noncovalent complexes typically distributes products asymmetrically (i.e., by ejecting a single subunit bearing a large percentage of the excess charge). That unexpected behavior has been rationalized as one subunit "unfolding" to depart with more charge. We present an alternative explanation based on heterolytic ion-pair scission and rearrangement, a mechanism that inherently partitions charge asymmetrically. Excessive barriers to dissociation are circumvented in this manner, when local charge rearrangements access a lower-barrier surface. An implication of this ion pair consideration is that stability differences between high- and low-charge state ions usually attributed to Coulomb repulsion may, alternatively, be conveyed by attractive forces from ion pairs (salt bridges) stabilizing low-charge state ions. Should the number of ion pairs be roughly inversely related to charge, symmetric dissociations would be favored from highly charged complexes, as observed. Correlations between a gas-phase protein's size and charge reflect the quantity of restraining ion pairs. Collisionally-facilitated salt bridge rearrangement (SaBRe) may explain unusual size "contractions" seen for some activated, low charge state complexes. That some low-charged multimers preferentially cleave covalent bonds or shed small ions to disrupting noncovalent associations is also explained by greater ion pairing in low charge state complexes. Graphical Abstract ᅟ.

We have systematically studied how secondary interactions with neighboring lysine (Lys) and arginine (Arg) residues influence the binding and selectivity of the synthetic receptor A2 N for trimethyllysine (Kme3 ). Multiple secondary binding sites on A2 N are formed by carboxylates rigidly positioned over aromatic rings, a motif that has been shown to stabilize salt bridges. We varied the spacing between KmeX (X=0, 3) and an ancillary Lys or Arg and measured binding by isothermal titration calorimetry (ITC). These studies revealed that both neighboring residues improve the binding of A2 N to KmeX by approximately 1 kcal mol(-1) , with little influence of the spacing. Nonetheless, the improvement in affinity caused by Arg is enthalpically driven, while for Lys it is entropically driven, suggesting different mechanisms by which the residues interact with the secondary binding site., (© 2015 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.)

Ion pairs (also known as salt bridges) of electrostatically interacting cationic and anionic moieties are important for proteins and nucleic acids to perform their function. Although numerous three-dimensional structures show ion pairs at functionally important sites of biological macromolecules and their complexes, the physicochemical properties of the ion pairs are not well understood. Crystal structures typically show a single state for each ion pair. However, recent studies have revealed the dynamic nature of the ion pairs of the biological macromolecules. Biomolecular ion pairs undergo dynamic transitions between distinct states in which the charged moieties are either in direct contact or separated by water. This dynamic behavior is reasonable in light of the fundamental concepts that were established for small ions over the last century. In this review, we introduce the physicochemical concepts relevant to the ion pairs and provide an overview of the recent advancement in biophysical research on the ion pairs of biological macromolecules.

Bacterial biofilms communicate by a process called Quorum Sensing. Gram negative bacterial pathogens specifically talk through the production, detection, and response to the signal or autoinducer called Acyl Homoserine Lactones. Bacterial lactonases are important AHL hydrolysing or quorum quenching enzymes. The present study deals with ten endospore forming gram positive isolates of the saltern soil. Preliminary screening for Quorum Quenching activity with the QS Inhibition indicator strain Chromobacterium violaceum ATCC 12472, showed positive activity in four isolates namely TS2, TS16, TSAWB, and TS53B. AHL lactonase (AiiA) specific primers amplified Acyl Homoserine Lactone lactonase gene in the TSAWB genome alone. Phylogenetic relationship of the identified AiiATSAWB confirmed its evolutionary relationship with bacterial AiiA like AHL lactonase of the metallo-beta-lactamase super family. Our in vitro AHL hydrolysis assay under wide percentage (0-5) of salt solutions with TSAWB isolate and also its intracellular soluble protein fraction showed halotolerant AHL hydrolysis ability of the AiiATSAWB enzyme. In silico determination of putative tertiary structure, the ESBRI derived conserved salt bridges, aminoacid residue characterization with high mole percent of acidic and hydrophobic residues reaffirmed the halotolerant ability of the enzyme. So we propound the future use of purified AiiATSAWB , as hypertonic suspension for inhalation to substitute the action of inactivated host's paraoxonase in treating Pseudomonas aeruginosa infection in cystic fibrosis patients., (© 2014 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.)

The molecular architecture of protein-RNA interfaces are analyzed using a non-redundant dataset of 152 protein-RNA complexes. We find that an average protein-RNA interface is smaller than an average protein-DNA interface but larger than an average protein-protein interface. Among the different classes of protein-RNA complexes, interfaces with tRNA are the largest, while the interfaces with the single-stranded RNA are the smallest. Significantly, RNA contributes more to the interface area than its partner protein. Moreover, unlike protein-protein interfaces where the side chain contributes less to the interface area compared to the main chain, the main chain and side chain contributions flipped in protein-RNA interfaces. We find that the protein surface in contact with the RNA in protein-RNA complexes is better packed than that in contact with the DNA in protein-DNA complexes, but loosely packed than that in contact with the protein in protein-protein complexes. Shape complementarity and electrostatic potential are the two major factors that determine the specificity of the protein-RNA interaction. We find that the H-bond density at the protein-RNA interfaces is similar with that of protein-DNA interfaces but higher than the protein-protein interfaces. Unlike protein-DNA interfaces where the deoxyribose has little role in intermolecular H-bonds, due to the presence of an oxygen atom at the 2' position, the ribose in RNA plays significant role in protein-RNA H-bonds. We find that besides H-bonds, salt bridges and stacking interactions also play significant role in stabilizing protein-nucleic acids interfaces; however, their contribution at the protein-protein interfaces is insignificant.

The power of X-ray crystal structure analysis as a technique is to 'see where the atoms are'. The results are extensively used by a wide variety of research communities. However, this 'seeing where the atoms are' can give a false sense of security unless the precision of the placement of the atoms has been taken into account. Indeed, the presentation of bond distances and angles to a false precision (i.e. to too many decimal places) is commonplace. This article has three themes. Firstly, a basis for a proper representation of protein crystal structure results is detailed and demonstrated with respect to analyses of Protein Data Bank entries. The basis for establishing the precision of placement of each atom in a protein crystal structure is non-trivial. Secondly, a knowledge base harnessing such a descriptor of precision is presented. It is applied here to the case of salt bridges, i.e. ion pairs, in protein structures; this is the most fundamental place to start with such structure-precision representations since salt bridges are one of the tenets of protein structure stability. Ion pairs also play a central role in protein oligomerization, molecular recognition of ligands and substrates, allosteric regulation, domain motion and α-helix capping. A new knowledge base, SBPS (Salt Bridges in Protein Structures), takes these structural precisions into account and is the first of its kind. The third theme of the article is to indicate natural extensions of the need for such a description of precision, such as those involving metalloproteins and the determination of the protonation states of ionizable amino acids. Overall, it is also noted that this work and these examples are also relevant to protein three-dimensional structure molecular graphics software.

Apolipoprotein E (apoE), first described in 1973, is a truly fascinating protein. While studies initially focused on its role in cholesterol and lipid metabolism, one apoE isoform (apoE4) is a major risk factor for development of late onset Alzheimer's disease. Yet the difference between apoE3, the common form, and apoE4 is a single amino acid of the 299 in this 34 kDa protein. Structure determination of the two domain full length apoE3 protein was only accomplished in 2011 and supports the notion that mutations in the N-terminal domain can be propagated through the structure to the C-terminal domain. Understanding the structural differences between apoE3 and apoE4 is critical for finding ways to modulate the deleterious effect of apoE4., (© 2013 The Protein Society.)

Unlabelled: Salt bridges can play important roles in protein structure and function and have stabilizing and destabilizing effects in protein folding. ESBRI is a software available as web tool which analyses the salt bridges in a protein structure, starting from the atomic coordinates. In the case of protein complexes, the salt bridges between protein chains can be evaluated, as well as those among specific charged amino acids and the different protein subunits, in order to obtain useful information regard the protein-protein interaction., Availability: The service is available at the URL: http://bioinformatica.isa.cnr.it/ESBRI/