Search

Multi-storey cross-laminated timber (CLT) buildings are a comparatively recent construction type. Knowledge concerning the performance of CLT buildings regarding the prevention of disproportionate collapse after unforeseeable events (e.g. accidents or acts of terrorism) is not as refined as that for concrete and steel buildings. In particular, alternative load paths (ALPs) after the removal of a wall panel in platform-framed variants have not yet been studied in detail. The goal of this work was therefore to study ALPs in CLT buildings. An eight-storey bay of an existing building was evaluated by conducting a non-linear static pushdown analysis in a finite element analysis on three representative storeys. The analyses accounted for single fastener behaviour, timber crushing, friction, brittle failure and large deformations. The force–deformation behaviours elicited under the pushdown analyses were subsequently inserted in a simplified dynamic model to evaluate the transient response of the entire bay. Four ALPs were identified in this case – shear resistance in the floor panels, arching action of the walls, catenary action in the floor panels and hanging action from the roof. The dynamic analysis did not show a collapse, unless the inter-compartment stiffness was significantly reduced. The resistance mechanisms are described in this paper, which may provide information for improved building design. [ABSTRACT FROM AUTHOR]

• Non-linear model for alternative load paths in cross-laminated timber floors. • Calibration to experimental results and parameter variations. • Collapse resistance by catenary and arching action, and the platform joint itself. • Collapse resistance increases at lower storeys and decreases with longer spans. • Catenary action requires novel connections, arching action requires thick panels. Multi-storey buildings require mitigation of consequences of unexpected or accidental events, to prevent disproportionate collapse after an initial damage. Cross-laminated timber (CLT) in platform-type construction is increasingly used for multi-storey buildings, however, the collapse behaviour and alternative load paths (ALPs) are not fully understood. A 3D non-linear component-based finite element model was developed for a platform-type CLT floor system to study the ALPs after an internal wall loss, in a pushdown analysis. The model, which accounted for connection failure, timber crushing and large displacements, was calibrated to experimental results and then adapted for boundary conditions corresponding to typical residential and office buildings. Subsequently, five parameters (floor span, connection type, vertical location of the floor, tying level, horizontal wall stiffness) were varied, to study their effects on the ALPs in 80 models. The results showed that three ALPs occurred, of which catenary action was the most dominant. Collapse resistance was mainly affected by the floor span, followed by the axial strength, stiffness and ductility of the floor-to-floor connection, the weight of the level above and the floor panel thickness. This study provides an approach to model ALPs in a platform-type CLT floor system to design disproportionate collapse resistant multi-storey CLT buildings. [ABSTRACT FROM AUTHOR]