Search

Preliminary results of spectroscopy and imaging of a solar active region and flare plasma in soft X-ray emission lines are presented. Observed X-ray line widths in a nonflaring active region are broader than the Doppler width corresponding to the local electron temperature. An analysis of 41 soft X-ray flares within a single active region reveals a preference for flares to occur at locations that already show enhanced X-ray emission and to favor magnetic complexity over high gradient. However, flares do not appear to be directly responsible for the heating and X-ray production of the active regions.

It is pointed out that the X-ray polychromator experiment has been in operation on the Solar Maximum Mission satellite for more than three months. Using a number of different modes, the polychromator is observing flares and active regions in the wavelength range 1-23 A. These modes include polychromatic imaging, high resolution line profiles, high dispersion spectra, and light curves with high time-resolution. Data are described and some of the early analysis and interpretation is presented. All the interpretations are based on simple approximate methods; it is noted, however, that in most cases more elaborate and reliable methods are close to being applied.

Previous determinations of the form of the emission-measure distribution function for solar active regions are examined. It is found that two analyses in particular are affected by low quality of either observational or atomic data. An alternative method of analysis is discussed.

An evaluation of the nature of the X-ray source Cygnus X-1 depends on distance relations. The validity of distance estimates provided by Margon et al. (1973) and Bregman et al. (1973) is considered. It is concluded that the possibility of a determination of the distance of HDE 226868 to the required accuracy on the basis of reddening measurements appears unlikely. It is, therefore, thought to be premature to suggest that the X-ray source is a black hole.

X-ray and ultraviolet line emission from hot, optically thin material forming coronal active regions on the sun may be described in terms of an emission measure distribution function, Phi (T). A relationship is developed between line flux and Phi (T), a theory which assumes that the electron density is a single-valued function of temperature. The sources of error involved in deriving Phi (T) from a set of line fluxes are examined in some detail. These include errors in atomic data (collisional excitation rates, assessment of other mechanisms for populating excited states of transitions, element abundances, ion concentrations, oscillator strengths) and errors in observed line fluxes arising from poorly - known instrumental responses. Two previous analyses are discussed in which Phi (T) for a non-flaring active region is derived. A least squares method of Batstone uses X-ray data of low statistical significance, a fact which appears to influence the results considerably. Two methods for finding Phi (T) ab initio are developed. The coefficients are evaluated by least squares. These two methods should have application not only to active-region plasmas, but also to hot, flare-produced plasmas.

Cooling models for flare produced plasmas in solar corona, considering collisional, radiative and conductive mechanisms

The expected flux of K alpha line emission from sulfur, argon, calcium, and iron is calculated during both thermal and nonthermal solar X-ray events. Such emission is shown to be weak during the course of most of the nonthermal hard X-ray bursts that Kane and Anderson (1970) have observed. If Compton backscattering is significant at high energies, the flux is reduced still further for disk flares, but it is noted that the strong, near-limb burst of June 26 would have produced about 100 photons /sq cm/sec of sulfur and iron K alpha emission. The impulsive hard X-ray bursts may in general be too short-lived for much K alpha emission. It may be noted that sulfur K alpha emission in particular depends sensitively on the lower-energy limit of the nonthermal electron spectrum, assuming such a sharply defined boundary exists. During soft X-ray bursts, when temperatures of a few 10 to the 7th power K are obtained, K alpha emission from certain iron ions, specifically Fe XVIII-XXIII, may be important.

The solar X-ray flare model of Jager and Kundu (1963), supported by the direct evidence recently provided by Tindo et al. (1972) for the presence of radial electron beams indicated in Jager-Kundu's model, is discussed with respect to its apparent conflict with Ohki's (1969) and Pinter's (1969) indications of a directivity effect likely to occur for X-ray flares at very high photon energies. An attempt is made to explain this apparent conflict.

Analysis of data from the soft X-ray proportional counter spectrometer on OSO-4 has been continued along the lines of earlier work. It was noticed that the time profiles of X-ray counts from the OSO-4 instrument's 1 to 3 Angstrom detectors for two events showed a very rapid initial decay after maximum, followed by a much more slowly falling section. At least in the case of the larger of the two events, the change of slope seems quite definitely to be discontinuous. Temperatures and emission measures for both flares have been derived, by fitting an emission function to eight-channel count histograms which form the output of the 1 to 3 Angstrom detectors, analyzed into eight energy intervals by pulse-height analysis. The computer program is described. It employs temperature and continuum emission measures in the Culhane-Acton formula and the flux in the 6.7 KeV iron-line feature as free parameters, adjusting them by small amounts in successive iterations until the original historgram is approximately reproduced. A chi-squared is used to examine the agreement between histograms and terminates the iteration accordingly. Account is taken of the proportional counters' energy resolution in the fitting process.