Search

In this study, Al–CuO nanocomposites were fabricated by sol-gel method. As a contrast, the thermite was prepared by physical mixing at the equivalence ratio of 0.5, 1, 2, respectively. The intermediates and samples as prepared were characterized by SEM and XRD. The exothermic properties of the two samples prepared at different equivalence ratios were tested and the reaction products were characterized by XRD. The SEM results show that the sample prepared by the sol-gel method demonstrates a micron-sized agglomerated sphere formed by a mutual wrapping of Al NPs and CuO NPs, and the particles are evenly distributed in the agglomerate. In addition, when the content of Al powder is seriously insufficient, the heat release of the sample prepared by physical mixing is 1.6 times that of by sol-gel method. With the increase of Al powder content, the exothermic properties of Al/CuO NPs prepared by sol-gel method began to increase significantly compared with physical mixing and the difference is 1.5 times when the equivalence ratio increases to 2. It can be concluded that the reason for this result may be attributed to the different mass transfer modes of components due to the different morphologies of samples.

The storage stability of energetic materials is important for its application. Here, the storage stability of Al/CuO nanothermite, which was prepared by electrospray method and stored with different storage time, was systematically researched. The activation energy of Al/CuO nanothermite was calculated by differential scanning calorimetry (DSC). The ignition temperature and the curve pressure history of Al/CuO nanothermite was measured using ignition temperature measuring device and constant-volume pressurization tests, respectively. Further, the thermites were characterized by X-ray Diffractometer (XRD), X-ray photoelectron spectroscopy (XPS), scanning electron microscope (SEM) and Transmission electron microscopy (TEM). The results show that the morphology of the thermites did not change significantly. The activation energy was decreased from 254.1 kJ/mol to 181.8 kJ/mol after storage for 13 months. When stored for 0, 7 and 13 months, the peak pressures of Al/CuO nanothermite were 685.8 kPa, 626.3 kPa and 625.5 kPa, respectively. In addition to the ignition temperature, it was 775 °C, 739 °C and 754 °C, respectively. This result indicated that the ignition and combustion properties of Al/CuO nanothermite are obviously reduced when stored for a long time, at room temperature.

The laser four-quadrant detection system is an important part of laser guided weapons. The accurate evaluation of its performance in the design stage is conducive to the iteration and optimization of the design scheme. The simulation model of the four-quadrant detection system was established based on LitghtTools. Through the establishment of target model, optical system model and four-quadrant detector model, the system could be effectively simulated. Combined with principle of four-quadrant detection system, the sum-difference amplitude of angle deviation could be obtained; the stray light of the system could also be simulated to evaluate the impact of stray light on system; in addition, it could also simulate the laser speckle effect and analyze the influence of speckle characteristics on the sum-difference amplitude. Therefore, the modeling and simulation based on LitghtTools provided an accurate basis for design optimization. Finally, the simulation model was verified by experiments. The sum-difference amplitude of the simulation is basically the same as that of the experiment in the range of ± 15°.

As a class of transcription regulators, numerous miRNAs have been verified to participate in regulating ovary follicular development in chickens (Gallus gallus). Previously we showed that gga-miR-135a-5p has significant differential expression between high and low-yield chicken ovaries, and the abundance of gga-miR-135a-5p is significantly higher in follicular theca cells than in granulosa cells. However, the exact role of gga-miR-135a-5p in chicken follicular theca cells is unclear. In this study, primary chicken follicular theca cells were isolated and then transfected with gga-miR-135a-5p inhibitor. Transcriptome sequencing was performed in chicken follicular theca cells with or without transfection. Differentially expressed genes (DEGs) were analyzed using bioinformatics. A dual-luciferase reporter assay was used to verify the target relationship between gga-miR-135a-5p and predicted targets within the DEGs. Compared with the normal chicken follicle theca cells, 953 up-regulated and 1060 down-regulated genes were detected in cells with gga-miR-135a-5p inhibited. The up-regulated genes were significantly enriched in Gene Ontology terms and pathways involved in cell proliferation and differentiation. In chicken follicular theca cells, Krüppel-like factor 4 (KLF4), ATPase phospholipid transporting 8A1 (ATP8A1), and Complexin-1 (CPLX1) were significantly up-regulated when the expression of gga-miR-135a-5p was inhibited. In addition, KLF4, ATP8A1, and CPLX1 confirmed as targets of gga-miR-135a-5p by using a dual-luciferase assay in vitro. The results suggest that gga-mir-135a-5p may involve in proliferation and differentiation in chicken ovarian follicular theca cells by targeting KLF4, ATP8A1, and CPLX1.

Additional file 13: Figure S1. Predicted biomathematical circRNA-miRNA-mRNA network for circRNA225 and circRNA226. Only the top 50 mRNAs are shown in the network. Yellow ellipses represent circRNAs, green diamonds represent miRNAs, and red triangles represent mRNAs.