Search

Objective: A systematic review was conducted to assess scientific knowledge concerning the effect of haematopoietic stem cell transplantation (HSCT) on the occurrence of caries, periodontal conditions and tooth loss, and to evaluate the prevalence of these diseases in adult HSCT survivors (PROSPERO 152906). Methods: PubMed and Embase were searched for papers, published from January 2000 until November 2020 without language restriction, assessing prevalence, incidence or parameters of caries, periodontal conditions and tooth loss in HSCT recipients (≥80% transplanted in adulthood). Bias risk was assessed with checklists from Joanna Briggs Institute, and data synthesis was performed by narrative summary. Results: Eighteen papers were included (1618 subjects). Half were considered at high risk of bias. Longitudinal studies did not show caries progression, decline in periodontal health or tooth loss after HSCT. The prevalence in HSCT survivors ranged from 19% to 43% for caries, 11% to 67% for periodontitis, and 2% to 5% for edentulism. Certainty in the body of evidence was very low. Conclusions: Haematopoietic stem cell transplantation, on the short term, may have little to no effect on caries, periodontal conditions and tooth loss. Caries and periodontitis may be more common in HSCT survivors compared with the general population, whereas edentulism may be comparable. However, the evidence for all conclusions is very uncertain. [ABSTRACT FROM AUTHOR]

Purpose: This in vitro study investigated whether aging different restorative materials influences secondary caries development using a short-term in vitro biofilm model, hypothesizing that the antibacterial adhesive employed may lose its effect over time. Materials and Methods: Sixty enamel-dentin blocks were divided into 6 groups with n = 10 per group. The groups were restored with three different restorative materials, of which each sample contained an artificial gap: composite with conventional adhesive (CCA; negative control), composite with an antibacterial adhesive (CAA), and amalgam (A; positive control). Half of the groups were prepared fresh and half of the groups were submitted to an aging protocol consisting of water storage, thermocycling, storage in human saliva, and storage in 0.9% saline solution. All specimens were subjected to an intermittent 1% sucrose biofilm model for 20 days to create artificial caries lesions. Lesion progression in the enamel and dentin next to the different materials was measured as lesion depth (LD) and mineral loss (ML), using transverse wavelength independent microradiography (T-WIM). Regression analysis was used to evaluate the effect of aging on LD and ML per restorative material, corrected for gap size. Materials and Methods: Sixty enamel-dentin blocks were divided into 6 groups with n = 10 per group. The groups were restored with three different restorative materials, of which each sample contained an artificial gap: composite with conventional adhesive (CCA; negative control), composite with an antibacterial adhesive (CAA), and amalgam (A; positive control). Half of the groups were prepared fresh and half of the groups were submitted to an aging protocol consisting of water storage, thermocycling, storage in human saliva, and storage in 0.9% saline solution. All specimens were subjected to an intermittent 1% sucrose biofilm model for 20 days to create artificial caries lesions. Lesion progression in the enamel and dentin next to the different materials was measured as lesion depth (LD) and mineral loss (ML), using transverse wavelength independent microradiography (T-WIM). Regression analysis was used to evaluate the effect of aging on LD and ML per restorative material, corrected for gap size. Results: In the amalgam group, aging led to shallower lesions and less mineral loss. Fresh amalgam samples showed an average lesion depth of 156.65 ± 39.18 μm at wall dentin locations. Aged amalgam samples had an average lesion depth of 73.42 ± 73.50 μm. Fresh CAA samples showed lower average surface mineral loss values (9104 ± 2631 μm.vol%) than did fresh CCA samples (13166 ± 4769 μm.vol%). After aging, this effect was absent, and the average mineral loss in the CAA group was 13382 ± 5586 μm.vol%, while in the CCA group it was 15518 ± 9283 μm.vol%. Conclusion: Aging can influence secondary caries development either positively or negatively depending on the kind of restorative material. Antibacterial adhesives may lose their effectiveness over time. [ABSTRACT FROM AUTHOR]

Aim: To compare manual and powered tooth brushing (MT and PT) with respect to patient compliance to brushing frequency advice, plaque removal and severity of oral mucositis (OM) in patients undergoing hematopoietic stem cell transplantation (HSCT) after high‐dose chemotherapy. Materials & methods: A randomized controlled trial was conducted. Forty‐six patients scheduled to receive myeloablative conditioning regimen before autologous HSCT were included and randomly assigned to control (MT, n = 23) or test (PT, n = 23) groups. Starting at day 1 (day of hospital admission for HSCT), brushing frequency (patient recorded diary), plaque scores (Plaque Control Index) and oral mucositis (Oral Mucositis Nursing Index) were recorded daily. Data for days 1 to 17 were analysed using regression analysis and general linear models. Results: Few patients maintained 4 times per day brushing, but most brushed at least 2 times per day throughout the study. In PT, overall plaque scores were lower by 6.98% (p =.006) as compared to MT. No differences were seen in OM scores between the groups (p =.968). A small but significant positive correlation was found between plaque scores and OM severity: R2=0.15 (p <.01). Conclusions: Powered tooth brushing resulted in lower plaque scores, but was not associated with reduced OM severity. Individual plaque scores were positively related to OM severity. [ABSTRACT FROM AUTHOR]

Purpose: To evaluate the effect of water storage and cyclic loading on the microtensile bond strength (µTBS) and fracture pattern of adhesives to dentin. Materials and Methods: Midcoronal dentin surfaces (n = 36) were prepared and composite restorations were built up using two adhesives (self-etch and etch-and-rinse). The specimens were randomly divided into 3 groups according to the aging conditions (n = 6): 1. control: storage in water for 24 h (CO); 2. water storage: storage in water for 6 months (WS); 3. mechanical loading: 750,000 mechanical cycles (ML) using the Rub&Roll loading device. Specimens were sections into beams and the μTBS was tested. Fracture patterns were analyzed using stereomicroscopy and fractographic analysis was performed using SEM. μTBS data (n = 53-72 specimens) were subjected to two-way ANOVA and Tukey's post-hoc test. The chi-squared test was used to compare the distribution of failure modes (p < 0.05). Results: Aging conditions and adhesives significantly affected μTBS (p < 0.01). The CO group showed no difference between materials and had highest μTBS. After WS, the self-etch adhesive showed higher μTBS than did the etchand- rinse adhesive. ML resulted in lower μTBS for both adhesives. Materials (p < 0.01) and aging (p < 0.01) significantly influenced the distribution of failure modes. SEM analysis showed that specimens submitted to WS or ML showed features of degradation and fatigue at the fractured interface, depending on the adhesive. Conclusion: Mechanical loading had a negative effect on the bonding efficacy of both adhesives and influenced the fracture pattern, with specimens presenting a different fracture surface from that observed in water-stored specimens. [ABSTRACT FROM AUTHOR]

Aim: To investigate the prevalence of non‐carious cervical lesions (NCCLs) and their association with individual and tooth‐related factors in adults from the 1982 Pelotas Birth Cohort. Materials and methods: Participants were interviewed and clinically examined at the age of 31. NCCL was defined as loss of dental tissue without bacterial involvement in the cervical region. Independent variables were the socioeconomic, demographic, behavioural, and clinical characteristics. Associations were tested using a multilevel Poisson regression model. Results: Five‐hundred and thirty‐nine participants were clinically examined, with a 26% prevalence of NCCLs, which were more prevalent in the maxilla (56.5%) and in premolars (72.9%). In the multilevel analysis, women presented lower prevalence than men [prevalence ratio (PR) 0.59 (0.48–0.73)]; those who reported smoking at both 22 and 30 years of age had more NCCLs than those who never smoked [PR 1.65 (1.31–2.07)]; and high‐frequency brushers presented higher prevalence than low‐frequency brushers [PR 1.26 (1.03–1.55)]. Gingival recession increased 10 times the prevalence of NCCLs [PR 10.03 (8.15–12.35)], while the presence of periodontal pockets (≥4 mm) reduced the prevalence of NCCLs [PR 0.43 (0.28–0.66)]. Conclusions: NCCLs were more prevalent in males, smokers, and those with higher frequency of toothbrushing. While the presence of periodontal pockets was associated with a lower prevalence of NCCLs, gingival recession was a strong clinical indicator for the presence of NCCLs. [ABSTRACT FROM AUTHOR]

Our understanding of erosive tooth wear and its contributing factors has evolved considerably over the last decades. New terms have been continuously introduced, which frequently describe the same aspects of this condition, whereas other terms are being used inappropriately. This has led to unnecessary confusion and miscommunication between patients, professionals, and researchers. A group of 15 experts, selected by the European Organization for Caries Research (ORCA) and the Cariology Research Group of the International Association for Dental Research (IADR), participated in a 2-day workshop to define the most commonly used terms in erosive tooth wear. A modified Delphi method was utilized to reach consensus. At least 80% agreement was achieved for all terms discussed and their definitions related to clinical conditions and processes, basic concepts, diagnosis, risk, and prevention and management of erosive tooth wear. Use of the terms agreed on will provide a better understanding of erosive tooth wear and intends to enable improved communication on this topic. [ABSTRACT FROM AUTHOR]

Background/aim: The underlying mechanism of the development of cups and grooves on occlusal tooth surfaces is still unclear. The aim of this study was to evaluate factors contributing to in vitro cup formation, in order to elucidate the clinical process.Methods: A total of 48 extracted human molar teeth were exposed to acidic aqueous solutions at pH of 4.8 and 5.5 in constant motion, in combination with different loading conditions: no load (0N group, control), 30 N (30N group) or 50 N (50N group) (n = 8 per group). Before and after 3 months of exposure (1,422,000 loading cycles), the samples were scanned using a non-contact profilometer. Pre- and post-exposure scans were subtracted and height loss and volume tissue loss were calculated. Representative samples with wear and cupping lesions were imaged using scanning electron microscopy, light microscopy and micro-computed tomography.Results: Average height and volume tissue loss at pH 5.5 was 54 µm and 3.4 mm3 (0N), 52 µm and 3.4 mm3 (30N) and 58 µm and 3.7 mm3 (50N), respectively, with no statistically significant differences. Average height and volume loss at pH 4.8 were 135 µm and 8.7 mm3 (0N), 172 µm and 12.6 mm3 (30N) and 266 µm and 17.8 mm3 (50N), respectively, with a statistically significant difference between 0N and 50N (p < 0.002). Cup-shaped lesions had formed only at pH of 4.8, in the 30N and 50N groups.Conclusion: The study showed that a cup can arise fully in enamel and that mechanical loading in addition to erosive challenges are required. [ABSTRACT FROM AUTHOR]

Contemporary minimally invasive treatment concepts for restorative treatment of primary caries lesions include both delayed intervention and smaller-sized preparations restricted to removal of carious tissue. The aim of this study was to investigate whether these concepts have resulted in a trend towards a more conservative choice made by dentists regarding treatment thresholds and restorative techniques. The results from previously conducted, precoded questionnaires developed by Espelid and Tveit, as well as from a recent Dutch questionnaire, were collected and analysed. A worldwide trend towards more minimally invasive strategies in the operative treatment of caries lesions could not be observed, neither for the initiation of operative treatment nor for the preparation techniques. However, in some countries, changes over time could be assessed, especially in Norway, where a reduction in the proportion of interventions is visible for both occlusal and approximal lesions, indicating that more dentists are postponing interventions until the lesions have progressed to a deeper level. From the Dutch national survey, it could be concluded that operators that intervene at an earlier stage of approximal lesioning (stage ≤4) also intervene at an earlier stage of occlusal caries (stage ≤3) (p = 0.012; OR = 2.52; 95% CI: 1.22-5.22). Generally, it can be concluded that dentists worldwide still tend to operatively intervene at a too early stage of caries, although variations exist between countries. A worldwide shift could be observed in the restorative material applied, since composite resin has almost completely replaced amalgam for restoring primary caries lesions. [ABSTRACT FROM AUTHOR]