Search

A quasistatic approach was used to consider the occurrence of additional pulses (APs) in the modal filter (MF) realized on a double-sided printed circuit board, as well as in the three structures obtained from it by removing one reference conductor. It is shown that, for all investigated MFs, the AP delays are determined by a linear combination of per-unit-length mode delays multiplied by the line length. It was found that there are no APs between the pulses of modes with one pass along the line, while they appear with three or more passes. It is revealed that in each of the considered MF structures (except the one without upper-right reference conductor), the APs have greater amplitudes of mode pulses with a triple pass. It was demonstrated that the removal of the reference conductors affects the number, polarity, and amplitude of the APs. [ABSTRACT FROM AUTHOR]

This article describes a new approach to electrostatic discharge (ESD) protection based on usage of a turn of a microstrip meander line (ML). The proposed approach enables decomposing an ESD peak surge with the duration of about 4 ns into a sequence of smaller amplitude pulses. Using a quasi-static simulation of the meander turn time response to the excitation of the IEC 61000-4-2 standard ESD current source, we obtained the condition for such decomposition. In addition, we derived the condition for the overlapping of the additionally reflected odd mode pulse of the negative polarity on the even mode pulse to reduce the amplitude of the last pulse. As an example, the proposed approach is used in investigating the ESD pulse propagation along the ML with various parameters. We also found the optimal value of the turn length for the minimum output ESD voltage, which decreases as the distance between the ML half-turns decreases. The described approach and the formulated conditions provide the improvement of the protection against ESD by decreasing its magnitude by several times. The effectiveness of the new approach is confirmed by the electrodynamic simulation and prototype measurements. The new research results supplement the theoretical framework for ESD mitigation techniques and can be used in designing reliable, light-weight, low-cost, and radiation-resistant ESD protection devices. [ABSTRACT FROM AUTHOR]

This study highlights the importance of detecting and localizing useful and interference signal extreme points in multiconductor transmission lines (MCTL) by developing a new approach for detecting and localizing signal extreme points in MCTL networks of arbitrary complexity. A radio-electronic component is presented as a network consisting of a number of connected MCTL sections. Each MCTL section is divided into segments and the number of segments is set by the user. The approach is based on a quasi-static calculation of signal waveforms at any point (segment) along each conductor of an MCTL. The block diagrams of the developed algorithms are presented. Using the approach, a number of investigations have been done which include the following: the signal maximum detection and localization in the meander lines with one and two turns, the influence of ultrashort pulse duration on localization of its extreme points in the printed circuit board (PCB) bus of a spacecraft autonomous navigation system, the influence of ultrashort pulse duration on localization of crosstalk extreme points in the PCB bus, and the simulation of electrostatic discharge effects on the PCB bus. There are also some investigations with optimization methods presented. A genetic algorithm (GA) was used to optimize the influence of ultrashort pulse duration on localization of the pulse and crosstalk extreme points in the PCB bus. Furthermore, the GA was used to optimize the PCB bus loads by criteria of the peak voltage minimization. A similar investigation was carried out with the evolution strategy. The obtained results help us to argue that the signal extreme points can be detected both in structures with different configurations and applying different excitations. [ABSTRACT FROM AUTHOR]