Search

Integrin-mediated cell adhesion is central to cell survival, differentiation and motility. Many cell responses induced by integrins require both receptor occupancy and receptor aggregation, and appear to be regulated by both biochemical and biophysical means. Multidomain extracellular matrix molecules may serve to foster integrin aggregation by presenting local clusters of adhesion ligands, a hypothesis supported by studies with synthetic substrates showing that cell adhesion and migration are enhanced when adhesion ligands are presented in nanoscale clusters. Here, we used a novel synthetic polymer system to present the adhesion ligand GRGDSPK in nanoscale clusters with 1.7, 3.6 or 5.4 peptides per cluster against a non-adhesive background, where the peptide is mobile on a 2 nm polyethylene oxide tether. Average ligand density ranged from 190 to 5270 RGD/microm(2). We used these substrates to study the effects of ligand density and clustering on adhesion of wild-type NR6 fibroblasts, which express alphavbeta3 and alpha5beta1, integrins known to bind to linear RGD peptides. The strength of cell-substratum adhesion was quantified using a centrifugal detachment assay to assess the relative number of cells remaining adherent after a 10 minute application of defined distraction force. An unusual relationship between cell detachment and distraction force at relatively low values of applied force was found on substrates presenting the clustered ligand. Although a monotonic decrease in the number of cells remaining attached would be expected with increasing force on all substrates, we instead observed a peak (adhesion reinforcement) in this profile for certain ligand conditions. On substrates presenting clustered ligands, the fraction of cells remaining attached increased as the distraction force was increased to between 70 and 150 pN/cell, then decreased for higher forces. This phenomenon was only observed on substrates presenting higher ligand cluster sizes (n=3.6 or n=5.4) and was more pronounced at higher ligand densities. Adhesion reinforcement was not observed on fibronectin-coated surfaces. These results support previous studies showing that biophysical cues such as ligand spatial arrangement and extracellular matrix rigidity are central to the governance of cell responses to the external environment.

Tissue engineering can be used to restore, maintain, or enhance tissues and organs. The potential impact of this field, however, is far broader-in the future, engineered tissues could reduce the need for organ replacement, and could greatly accelerate the development of new drugs that may cure patients, eliminating the need for organ transplants altogether.

Biodegradable polymeric devices for drug delivery and tissue engineering are often fabricated with the use of organic solvents and may still contain significant amounts of solvent (> 1 wt%) even after aggressive vacuum drying. This excess solvent can interfere with tissue response and the mechanical properties of the devices. The aim of this article is to demonstrate that liquid CO(2) extraction can be used to reduce residual solvent in dense poly(L-lactide-co-glycolide) devices to 50 ppm relatively quickly and with minimal changes in architecture under some conditions. Two liquid CO(2) extraction systems were developed to examine the removal of residual solvents from bar-shaped PLGA devices: (1) a low-pressure (1400 psi) batch system, and (2) a high-pressure (5000 psi) continuous-flow system. Eight hours of extraction in the high-pressure system reduced residual chloroform in 3 mm thick bars below the 50-ppm target. A simple Fickian diffusion model was fit to the extraction results. Diffusion coefficients ranged from 1.10 x 10(-6) cm(2)/s to 2.64 x 10(-6) cm(2)/s. The model predicts that approximately 1 h is needed to dry 1-mm bars to chloroform levels below 50 ppm, and 7 h are needed for 3 mm thick bars. The micro- and macroarchitectures of porous PLGA scaffolds created by particulate leaching were not significantly altered by CO(2) drying if the salt used to make the pores was not removed before drying., (Copyright 2002 Wiley Periodicals, Inc. J Biomed Mater Res (Appl Biomater) 63: 567-576, 2002)

Clustering of ligated integrins strongly influences integrin signaling and mechanical linkages between integrins and intracellular structures. Extracellular spatial organization of integrin ligands in clusters may facilitate clustering of bound integrins and thus potentially regulate cellular responses to a defined average amount of ligand in the extracellular environment. The possible role of such ligand clustering effects in controlling overall receptor occupancy is studied here using a simple mass-action equilibrium model as well as a two-dimensional Monte Carlo lattice description of the cell-substrate interface, where cell surface receptors are free to diffuse in the plane of the interface and interact with the substrate-immobilized ligand. Results from the analytical treatment and simulation data indicate that for a single-state model in which receptor-ligand binding equilibria are not influenced by neighboring complexes, clustering of ligand does not enhance total receptor binding. However, if receptor binding energy increases in the presence of neighboring ligated receptors, strong ligand spatial distribution effects arise. Nonlinear responses to increasing ligand density are also observed even in the case of random ligand placement due to stochastic juxtaposition of ligand molecules. These results describe how spatial distribution of ligand presented by the extracellular matrix or by synthetic biomimetic materials might control cell responses to external ligands, and suggest a feedback mechanism by which focal contact formation might be initiated.